Researchers develop high-performance perovskite oxide catalysts using late transition metal oxide materials

Enhancing bifunctional electrocatalytic activities via metal d-band center lift induced by oxygen vacancy on the subsurface of P
Figure 2. (a) ORR and (b) OER activities of Sm0.5Sr0.5CoO3−δ (δ = 0.0, 0.1, and 0.2) in O2-saturated 0.1 M KOH at a scan rate of 10 mV s–1 and a rotation rate of 1600 rpm. Credit: Professor Guntae Kim, UNIST

A research team, jointly led by Professor Gun-Tae Kim and Professor Jun-Hee Lee in the School of Energy and Chemical Engineering at UNIST has succeded in developing high-performance perovskite oxide catalysts using late transition metal oxide materials. Thus, they discovered the reason behind the improved performance of both the oxygen reduction reaction (ORR) and oxygen evolution reaction (OER), which has been explained by the change in the oxidation state of the transition metal caused by the increase in oxygen vacancies.

Perovskite oxide catalysts are composed of lanthanide, and oxygen. Owing to the excellent electrical conductivity and bifunctional ORR/OER activity, these catalysts have been considered to be an attractive candidate for metal-air batteries or fuel cells, in which opposite reactions, such as charging and discharging occur steadily. However, due to the high cost and low stability of noble metal catalysts, the development of alternatives is strongly desired.

The joint research team investigated the relationship between the bifunctional catalytic activity and the of modified perovskite oxides of Sm0.5Sr0.5CoO3−δ (SSC) by introducing oxygen vacancies without the change in the , physical properties, and chemical composition. In the study, the cobalt-based perovskite was selected as the late transition metal oxide catalyst having bifunctional activity for the ORR and OER. The bifunctional improvement was supported by the well-matched results of both theoretical DFT calculations and experimental electrochemical measurements.

"It has been known that the ORR activity of perovskite oxides are caused when oxygen vacancies are formed, but the newly developed catalysts exhibit good bifunctionality for both ORR and OER," says Professor Lee. "The improved performance of both ORR and OER is explained by the change in the oxidation state of the transition metal caused by the increase in oxygen vacancies."

"Our results suggest that late transition metal oxides can be utilized as efficient bifunctional catalysts by the introduction of oxygen vacancies," says Professor Kim. "We expect that this approach can accelerate the discovery and design of highly efficient bifunctional catalysts."


Explore further

New catalyst provides boost to next-generation EV batteries

More information: Hansol Lee et al. Enhancing Bifunctional Electrocatalytic Activities via Metal d-Band Center Lift Induced by Oxygen Vacancy on the Subsurface of Perovskites, ACS Catalysis (2020). DOI: 10.1021/acscatal.0c01104
Journal information: ACS Catalysis

Citation: Researchers develop high-performance perovskite oxide catalysts using late transition metal oxide materials (2020, November 20) retrieved 3 December 2020 from https://phys.org/news/2020-11-high-performance-perovskite-oxide-catalysts-late.html
This document is subject to copyright. Apart from any fair dealing for the purpose of private study or research, no part may be reproduced without the written permission. The content is provided for information purposes only.
7 shares

Feedback to editors

User comments