This article has been reviewed according to Science X's editorial process and policies. Editors have highlighted the following attributes while ensuring the content's credibility:


peer-reviewed publication

trusted source


Researchers formulate 'golden rules' for controlling alignment of supermoiré lattices

Golden rules for building atomic blocks
Artistic illustration of the supermoiré lattice with twist angles (θt and θb) formed between graphene and the top layer hexagonal boron nitride (T-hBN) and bottom layer hexagonal boron nitride (B-hBN). The slight misalignment causes the formation of a supermoiré lattice pattern. Credit: Nature Communications (2023). DOI: 10.1038/s41467-023-39893-5

National University of Singapore (NUS) physicists have developed a technique to precisely control the alignment of supermoiré lattices by using a set of golden rules, paving the way for the advancement of next generation moiré quantum matter.

Moiré patterns are formed when two identical periodic structures are overlaid with a relative twist angle between them or two different periodic structures but overlaid with or without twist angle. The twist angle is the angle between the crystallographic orientations of the two structures. For example, when and (hBN) which are layered materials are overlaid on each other, the atoms in the two structures do not line up perfectly, creating a pattern of interference fringes, called a moiré pattern.

This results in an electronic reconstruction. The moiré pattern in graphene and hBN has been used to create new structures with exotic properties, such as topological currents and Hofstadter butterfly states. When two moiré patterns are stacked together, a new structure called supermoiré is created (see figure above). Compared with the traditional single moiré materials, this supermoiré lattice expands the range of tunable material properties allowing for potential use in a much larger variety of applications.

A research team led by Professor Ariando from the Department of Physics, NUS, developed a technique and successfully realized the controlled alignment of the hBN/graphene/hBN supermoiré lattice. This technique allows for the precise arrangement of two moiré patterns, one on top of the other. Meanwhile, the researchers also formulated the "Golden Rule of Three" to guide the use of their technique for creating supermoiré lattices. The findings were published in the journal Nature Communications.

There are three main challenges in creating a graphene supermoiré lattice. First, the traditional optical alignment strongly depends on the straight edges of graphene, but it is time-consuming and labor-intensive to find a suitable graphene flake; Second, even if the straight-edged graphene sample is used, there is a low probability of 1/8 to obtain a double-aligned supermoiré lattice, due to the uncertainty of its edge chirality and lattice symmetry. Third, although the edge chirality and lattice symmetry can be identified, the alignment errors are often found to be large (greater than 0.5 degrees), as it is physically challenging to align two different lattice materials.

Dr. Junxiong Hu, the lead author for the research paper, said, "Our technique helps to solve a real-life problem. Many researchers have told me that they usually take almost one week to make a sample. With our technique, they can not only greatly shorten the fabrication time, but also greatly improve the accuracy of the sample."

The researchers use a 30-degree rotation technique at the start to control the alignment of the top hBN and graphene layers. Then they use a flip-over technique to control the alignment of the top hBN and bottom hBN layers. Based on these two methods, they can control the lattice symmetry and tune the band structure of the graphene supermoiré lattice. They have also shown that the neighboring graphite edge can act as a guide for the stacking alignment. In this study, they have fabricated 20 moiré samples with accuracy better than 0.2 degrees.

Prof. Ariando said, "We have established three golden rules for our technique which can help many researchers in the two-dimensional materials community. Many scientists working in other strongly correlated systems like magic-angle twisting or ABC-stacking multilayer graphene are also expected to benefit from our work. Through this technical improvement, I hope that it will accelerate the development of the next generation of moiré quantum matter."

Currently, the research team is using this technique to fabricate the single-layer graphene supermoiré lattice and explore the unique properties in this material system. Moreover, they are also extending the current technique to other material systems, to discover other novel quantum phenomena.

More information: Junxiong Hu et al, Controlled alignment of supermoiré lattice in double-aligned graphene heterostructures, Nature Communications (2023). DOI: 10.1038/s41467-023-39893-5

Journal information: Nature Communications

Citation: Researchers formulate 'golden rules' for controlling alignment of supermoiré lattices (2023, August 29) retrieved 29 November 2023 from
This document is subject to copyright. Apart from any fair dealing for the purpose of private study or research, no part may be reproduced without the written permission. The content is provided for information purposes only.

Explore further

Mixing of moiré-surface and bulk states: Capturing Hofstadter's butterfly in one of Earth's most ancient materials


Feedback to editors