Lithium-ion batteries: Capacity might be increased by six times

August 8, 2016, Helmholtz-Zentrum Berlin für Materialien und Energie
Lithium ions migrate through the electrolyte (yellow) into the layer of crystalline silicon (c-Si). During the charging cycle, a 20-nm layer (red) develops on the silicon electrode adsorbing extreme quantities of lithium atoms. Credit: HZB

The team was able to show through neutron measurements made at the Institut Laue-Langevin in Grenoble, France, that lithium ions do not penetrate deeply into the silicon. During the charge cycle, a 20-nm anode layer develops containing an extremely high proportion of lithium. This means extremely thin layers of silicon would be sufficient to achieve the maximal load of lithium.

Lithium-ion batteries provide laptops, smart phones, and tablet computers with reliable energy. However, electric vehicles have not gotten as far along with conventional batteries. This is due to currently utilised electrode materials such as graphite only being able to stably adsorb a limited number of ions, restricting the capacity of these batteries. Semiconductor materials like silicon are therefore receiving attention as alternative electrodes for . Bulk silicon is able to absorb enormous quantities of lithium. However, the migration of the lithium ions destroys the crystal structure of silicon. This can swell the volume by a factor of three, which leads to major mechanical stresses.

Observation during charging cycle

Now a team from the HZB Institute for Soft Matter and Functional Materials headed by Prof. Matthias Ballauff has directly observed for the first time a lithium-silicon half-cell during its charging and discharge cycles. "We were able to precisely track where the lithium ions adsorb in the silicon electrode using neutron reflectometry methods, and also how fast they were moving", comments Dr. Beatrix-Kamelia Seidlhofer, who carried out the experiments using the neutron source located at the Institute Laue-Langevin.

Lithium-rich layer of only 20 nanometer

She discovered two different zones during her investigations. Near the boundary to the electrolytes, a roughly 20-nm layer formed having extremely high lithium content: 25 lithium atoms were lodged among 10 . A second adjacent layer contained only one for ten silicon atoms. Both layers together are less than 100 nm thick after the second charging cycle.

Theoretical maximum capacity

After discharge, about one lithium ion per silicon node in the electrode remained in the silicon boundary layer exposed to the electrolytes. Seidlhofer calculates from this that the theoretical maximum capacity of these types of silicon-lithium batteries lies at about 2300 mAh/g. This is more than six times the theoretical maximum attainable capacity for a lithium-ion battery constructed with graphite (372 mAh/g).

Less is more

These are substantial findings that could improve the design of silicon electrodes: very thin films should be sufficient for adsorbing the maximum possible amount of lithium, which in turn would save on material and especially on energy consumed during manufacture - less is more!

Explore further: Next generation anode to improve lithium-ion batteries

More information: Beatrix-Kamelia Seidlhofer et al, Lithiation of Crystalline Silicon As Analyzed by Operando Neutron Reflectivity, ACS Nano (2016). DOI: 10.1021/acsnano.6b02032

Related Stories

Next generation anode to improve lithium-ion batteries

August 3, 2016

Researchers at the University of California, Riverside have created a new silicon-tin nanocomposite anode that could lead to lithium-ion batteries that can be charged and discharged more times before they reach the end of ...

Novel anode material for lithium-ion batteries

July 29, 2016

A novel, low cost and green lithiated tin vanadium oxide compound has been synthesized via simple, economical and scalable sol-gel method to replace the conventional graphite as electrode material for lithium-ion batteries. ...

Loofah-based material could give lithium batteries a boost

June 15, 2016

Today's mobile lifestyle depends on rechargeable lithium batteries. But to take these storage devices to the next level—to shore up the electric grid or for widespread use in vehicles, for example—they need a big boost ...

Recommended for you

Researchers find tweeting in cities lower than expected

February 20, 2018

Studying data from Twitter, University of Illinois researchers found that less people tweet per capita from larger cities than in smaller ones, indicating an unexpected trend that has implications in understanding urban pace ...

Augmented reality takes 3-D printing to next level

February 20, 2018

Cornell researchers are taking 3-D printing and 3-D modeling to a new level by using augmented reality (AR) to allow designers to design in physical space while a robotic arm rapidly prints the work.

0 comments

Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.