X-ray 3D imaging-based microunderstanding of granular mixtures: When soft spheres make porous media stiffer
Porous media such as concrete represent a spherical packing of different components. The mechanical properties of such mixtures are difficult to calculate due to their discretized nature. A team led by Prof. Holger Steeb (University of Stuttgart) and Prof. Stefan Luding (University of Twente, The Netherlands) has now been able to investigate an unexpected property of mixtures of granular media consisting of soft and stiff spherical particles.
They used a combination of ultrasound and X-ray computed tomographic imaging, allowing a 3D-characterization and evaluation, as reported in PNAS. The discovery could contribute to safer construction in earthquake zones.
The analysis of the exact composition of porous materials, such as concrete or asphalt, and its influence on resulting mechanical material properties plays an extremely crucial role in various technical applications. Only by knowledge about the exact mixture ratio and the resulting effective material behavior can such porous materials be adapted to specific "application requirements."
For example, when a composite material consists of a soft polymer matrix with stiff reinforcing fibers, the effective elastic stiffness of the composite material can be increased by increasing the fiber content. The resulting effective stiffness can be experimentally determined non-destructively from the wave travel time of a sound pulse through the granular spherical packing.
Enhanced predictive models through targeted experimental investigations
In this context, the teams of Prof. Holger Steeb, principal investigator in the Collaborative Research Center 1313 as well as in the Center of Excellence SimTech (EXC 2075), and Prof. Stefan Luding (University of Twente, The Netherlands) investigated the effective elastic properties of spherical packings using ultrasound in the Porous Media Lab at the University of Stuttgart. Dr. Kianoosh Taghizadeh and Matthias Ruf from the Chair of Continuum Mechanics are part of the Stuttgart team.
In the experiment, the researchers first prepared spherical packings of equally sized stiff glass spheres and soft rubber spheres in different mixing ratios. These packings were mechanically investigated into an X-ray transparent (PMMA) cylinder equipped with piezoelectric ultrasonic sensors and actuators under defined axial loading conditions.
Interestingly, it turned out that adding up to 20% (soft) rubber spheres has not reduced the effective stiffness of the packings, but improved it. However, when the fraction of the rubber spheres is more than 30%, the stiffness begins to decrease since the overall network is no longer dominated by stiff particles.
"This behavior contradicts all classical mixing rules," says Holger Steeb. "To gain a better understanding of the unexpected mechanical response, the overall network of particles (force network), including the glass and rubber sub-networks have been analyzed."
No longer a classic solid material
The researchers successfully evaluated the morphology by combining ultrasound examinations with X-ray Computed Tomographic imaging characterization (XRCT). X-ray images have shown that the higher effective stiffness of the packings with rubber fractions of up to 20% can be explained by the length of force chains of glass particles.
"At the same time, the glass particles network is in a so-called jammed state with a correspondingly high coordination number. If the volume fraction of the rubber spheres rises above 30%, the force chains consist of mixed contacts between glass and rubber spheres, which are much softer. "
Furthermore, the evaluation of the local sphere neighborhoods showed that the coordination number, i.e. the number of neighboring spheres of the same type, becomes significantly smaller at these higher volume fractions.
"At this volume fraction, neither of the two spherical phases is in a jammed state and thus the effective material behavior is not comparable to a classical solid," says Holger Steeb. The scientists see a lot of practical potential for the building industry in the further development of this research.
For example, in earthquake-prone areas, the stiffness and damping properties of soils could be adjusted through specific composite ballast-rubber mixtures. The amplitudes and velocities of earthquake waves could be manipulated in a targeted manner. Buildings could be protected from these dangers efficiently and cost-effectively.
More information: K. Taghizadeh et al, X-ray 3D imaging–based microunderstanding of granular mixtures: Stiffness enhancement by adding small fractions of soft particles, Proceedings of the National Academy of Sciences (2023). DOI: 10.1073/pnas.2219999120
Journal information: Proceedings of the National Academy of Sciences
Provided by University of Stuttgart