Magnetic-field detector is 1,000 times more efficient than its predecessors

Better sensors for medical imaging, contraband detection
In this image, laser light enters a synthetic diamond from a facet at its corner and bounces around inside the diamond until its energy is exhausted. This excites "nitrogen vacancies" that can be used to measure magnetic fields. Credit: H. Clevenson/MIT Lincoln Laboratory

MIT researchers have developed a new, ultrasensitive magnetic-field detector that is 1,000 times more energy-efficient than its predecessors. It could lead to miniaturized, battery-powered devices for medical and materials imaging, contraband detection, and even geological exploration.

Magnetic-field detectors, or magnetometers, are already used for all those applications. But existing technologies have drawbacks: Some rely on gas-filled chambers; others work only in narrow frequency bands, limiting their utility.

Synthetic diamonds with nitrogen vacancies (NVs)—defects that are extremely sensitive to magnetic fields—have long held promise as the basis for efficient, portable magnetometers. A diamond chip about one-twentieth the size of a thumbnail could contain trillions of nitrogen vacancies, each capable of performing its own measurement.

The problem has been aggregating all those measurements. Probing a nitrogen vacancy requires zapping it with , which it absorbs and re-emits. The intensity of the emitted carries information about the vacancy's magnetic state.

"In the past, only a small fraction of the pump light was used to excite a small fraction of the NVs," says Dirk Englund, the Jamieson Career Development Assistant Professor in Electrical Engineering and Computer Science and one of the designers of the new device. "We make use of almost all the pump light to measure almost all of the NVs."

The MIT researchers report their new device in the latest issue of Nature Physics. First author on the paper is Hannah Clevenson, a graduate student in who is advised by senior authors Englund and Danielle Braje, a physicist at MIT Lincoln Laboratory. They're joined by Englund's students Matthew Trusheim and Carson Teale (who's also at Lincoln Lab) and by Tim Schröder, a postdoc in MIT's Research Laboratory of Electronics.

Telling absence

A pure diamond is a lattice of carbon atoms, which don't interact with magnetic fields. A nitrogen vacancy is a missing atom in the lattice, adjacent to a nitrogen atom. Electrons in the vacancy do interact with magnetic fields, which is why they're useful for sensing.

When a light particle—a photon—strikes an electron in a nitrogen vacancy, it kicks it into a higher . When the electron falls back down into its original energy state, it may release its excess energy as another photon. A magnetic field, however, can flip the electron's magnetic orientation, or spin, increasing the difference between its two energy states. The stronger the field, the more spins it will flip, changing the brightness of the light emitted by the vacancies.

Making accurate measurements with this type of chip requires collecting as many of those photons as possible. In previous experiments, Clevenson says, researchers often excited the nitrogen vacancies by directing laser light at the surface of the chip.

"Only a small fraction of the light is absorbed," she says. "Most of it just goes straight through the diamond. We gain an enormous advantage by adding this prism facet to the corner of the diamond and coupling the laser into the side. All of the light that we put into the diamond can be absorbed and is useful."

Covering the bases

The researchers calculated the angle at which the laser beam should enter the crystal so that it will remain confined, bouncing off the sides—like a tireless cue ball ricocheting around a pool table—in a pattern that spans the length and breadth of the crystal before all of its energy is absorbed.

"You can get close to a meter in path length," Englund says. "It's as if you had a meter-long diamond sensor wrapped into a few millimeters." As a consequence, the chip uses the pump laser's energy 1,000 times as efficiently as its predecessors did.

Because of the geometry of the nitrogen vacancies, the re-emitted photons emerge at four distinct angles. A lens at one end of the crystal can collect 20 percent of them and focus them onto a light detector, which is enough to yield a reliable measurement.


Explore further

Toward practical quantum computers: Technique extends duration of fragile quantum states

More information: Broadband magnetometry and temperature sensing with a light-trapping diamond waveguide, DOI: 10.1038/nphys3291
Journal information: Nature Physics

Citation: Magnetic-field detector is 1,000 times more efficient than its predecessors (2015, April 6) retrieved 23 July 2019 from https://phys.org/news/2015-04-magnetic-field-detector-efficient-predecessors.html
This document is subject to copyright. Apart from any fair dealing for the purpose of private study or research, no part may be reproduced without the written permission. The content is provided for information purposes only.
3621 shares

Feedback to editors

User comments

Apr 06, 2015
That's so neat !!

Apr 06, 2015
what is the lowest magnetic field strength it can detect?
Pretty low, the superconductive magnetometers called SQUIDs can detect the change of magnetic field during pulsing of your heart or thinking. Of course such a measurements require specially shielded room.

Apr 07, 2015
"A diamond chip about one-twentieth the size of a thumbnail could contain trillions of nitrogen vacancies"

I hate those imperial units. Cannot even google the thumbnail unit for conversion to its measure in SI.

Does maybe 1/20 of a thumbnail equal to the square of a side of 3228 times a thickness of a persian cat's hair?

Apr 08, 2015
what is the lowest magnetic field strength it can detect?
The researchers used their device to measure magnetic fields that varied at a frequency of 1 Hz and achieved a sensitivity of a few picotesla – about three orders of magnitude less sensitive than the best SQUIDs.

Please sign in to add a comment. Registration is free, and takes less than a minute. Read more