A Search for Stability for Platinum Catalysts

December 17, 2009
Transmission electron microscopic image of small platinum catalyst particles supported on a functionalized graphene sheet.

(PhysOrg.com) -- A new carbon support that greatly increases the durability of proton-exchange membrane fuel cells has been developed by scientists at Pacific Northwest National Laboratory and Princeton University. This new material significantly improves the stability of the fuel cell catalyst and will potentially lower the cost of these fuel cells. This breakthrough research hit number one on the most-downloaded list of Electrochemistry Communications articles this fall.

Currently, proton-exchange membrane fuel cells are not widely used because of the high manufacturing cost and relatively low endurance. To be commercially viable, the cost needs to be dramatically reduced. These new carbon supports might do just that.

Inside today's fuel cell, platinum catalyzes the reaction. The conditions inside the fuel cell are pretty harsh: high pressure, high temperature. Under these conditions, some of the platinum particles fly off the support, making them unavailable to speed the reactions. Some of the particles clump together. When this happens, the particles present less surface area. And, it is on the surface where the reaction happens. So, less surface area, less catalysis. The team investigated a new type of support.

For this study, they sliced graphite, similar to the carbon in a pencil, into single atomic layers to form dense wrinkled sheets called functionalized graphene sheets.

Then, they treated these sheets with the platinum catalyst. Using a , they saw the difference in how the catalysts particles were attached to the graphene sheets and a commercial support. The images clearly showed a uniform distribution of much smaller platinum on the graphene. Using an X-ray photoelectron , they proved the graphene has more functional groups available to bind the compared to the commercial support. Both of these instruments are at DOE's EMSL, a scientific user facility located at PNNL.

Their conclusion was that the graphene sheets have a stronger metal-support interaction and produced smaller catalysts particles that were more resistant to degradation. Functionalized graphene sheets could potentially lead to a more stable, efficient, and lower-cost fuel cell.

This study lays the foundation for future work with this promising carbon material. Future research will focus on increasing the efficiency of the material fabrication and the durability of the graphene sheets.

Explore further: Nano World: Methanol fuel cell thru nano

More information: R Kou, Y Shao, D Wang, MH Engelhard, JH Kwak, J Wang, VV Viswanathan, C Wang, Y Lin, Y Wang, IA Aksay, and J Liu. 2009. "Enhanced activity and stability of Pt catalysts on functionalized graphene sheets for electrocatalytic oxygen reduction." Electrochemistry Communications, Volume 11, Issue 5, May 2009, Pages 954-957. www.elsevier.com/locate/elecom/

Related Stories

Carbon Nanotubes Make Fuel Cells Cheaper

February 9, 2009

(PhysOrg.com) -- As fuel cells are becoming more popular due to their potential use in applications such as hydrogen-powered vehicles, auxiliary power systems, and electronic devices, the need for the precious metal platinum ...

Replacing Platinum in Fuel Cell Technology

October 20, 2009

(PhysOrg.com) -- One of the biggest hindrances to the development of fuel cell technology is its cost. In order to work properly, polymer electrolyte fuel cells require a catalyst. So far, though, the most efficient catalyst ...

Recommended for you

Reshaping the solar spectrum to turn light to electricity

July 28, 2015

When it comes to installing solar cells, labor cost and the cost of the land to house them constitute the bulk of the expense. The solar cells—made often of silicon or cadmium telluride—rarely cost more than 20 percent ...

Could stronger, tougher paper replace metal?

July 24, 2015

Researchers at the University of Maryland recently discovered that paper made of cellulose fibers is tougher and stronger the smaller the fibers get. For a long time, engineers have sought a material that is both strong (resistant ...

Changing the color of light

July 23, 2015

Researchers at the University of Delaware have received a $1 million grant from the W.M. Keck Foundation to explore a new idea that could improve solar cells, medical imaging and even cancer treatments. Simply put, they want ...

Wafer-thin material heralds future of wearable technology

July 27, 2015

UOW's Institute for Superconducting and Electronic Materials (ISEM) has successfully pioneered a way to construct a flexible, foldable and lightweight energy storage device that provides the building blocks for next-generation ...

0 comments

Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.