Micropillar compression for finding heat-tolerant alloys

Micropillar compression for finding heat-tolerant alloys
The scientists measured the plastic deformation that happened when a tiny probe exerted force on the micropillar specimens with various loading axis orientations. Credit: National Institute for Materials Science (NIMS)

Metals containing niobium silicide are promising materials that can withstand high temperatures and improve efficiency of gas turbines in power plants and aircraft. But it has been difficult to accurately determine their mechanical properties due to their complex crystal structures. Now, scientists at Kyoto University in Japan have measured what happens at the micro-level when pressure is applied on tiny samples of these materials. The approach, published in the journal Science and Technology of Advanced Materials, could help scientists obtain the accurate measurements needed to understand the atomic-level behavior of complex crystals to develop more heat-tolerant components in gas turbines.

"Our results demonstrate the cutting edge of research into behavior in crystalline materials," says Kyosuke Kishida, the study's corresponding author.

Plastic deformation describes the distortion that occurs at the atomic level when a sustained force is applied to a crystal. It is difficult to measure in complex crystals. Kishida and his colleagues have been using a new approach to systematically measure deformation in crystals showing promise for use in high temperature gas turbines.

In this study, they measured plastic deformation in a niobium silicide called α-Nb5Si3. Tiny 'micropillars' of these crystals were exposed to very small amounts of stress using a machine with a flat-punch indenter at its end. The stress was applied to different faces of the sample to determine where and how plastic deformation occurs within the crystal. By using scanning electron microscopy on the samples before and after the test, they were able to detect the planes and directions in which deformation occurred. This was followed by simulation studies based on theoretical calculations to further understand what was happening at the atomic level. Finally, the team compared the results with those of a boron-containing molybdenum silicide (Mo5SiB2) they had previously examined.

"We found that instantaneous failure occurs rather easily in α-Nb5Si3, which is in marked contrast to Mo5SiB2," says Kishida.

This could mean α-Nb5Si3 is at a disadvantage compared to Mo5SiB2 for use as a strengthening component in metal-based alloys. Kishida and his team think, however, that this material's inherent brittleness could be improved by adding other alloying elements.

The team plans to use the approach to study of other crystalline materials with complex structures.

Explore further

Machine learning to predict and optimise the deformation of materials

More information: Kyosuke Kishida et al. Micropillar compression deformation of single crystals of α-Nb5Si3 with the tetragonal D8 l structure, Science and Technology of Advanced Materials (2020). DOI: 10.1080/14686996.2020.1855065
Citation: Micropillar compression for finding heat-tolerant alloys (2021, January 12) retrieved 19 May 2022 from https://phys.org/news/2021-01-micropillar-compression-heat-tolerant-alloys.html
This document is subject to copyright. Apart from any fair dealing for the purpose of private study or research, no part may be reproduced without the written permission. The content is provided for information purposes only.

Feedback to editors