Laser diode emits deep UV light

Laser diode emits deep UV light
Far field pattern of UV-C laser projected onto a fluorescent screen. Credit: 2019 Asahi Kasei Corp. and Nagoya University

Nagoya University scientists, in cooperation with Asahi Kasei Corporation, have designed a laser diode that emits deep-ultraviolet light, and have published a paper in the journal Applied Physics Express.

"Our emits the world's shortest lasing wavelength at 271.8 nanometers (nm), under pulsed [electric] current injection at room temperature," says Professor Chiaki Sasaoka of Nagoya University's Center for Integrated Research of Future Electronics.

Previous efforts in the development of ultraviolet had only managed to achieve emissions down to 336 nm, Sasaoka explains.

Laser diodes that emit short-wavelength ultraviolet light, which is called UV-C and is in the wavelength region of 200 to 280 nm, could be used for disinfection in healthcare, for treating skin conditions such as psoriasis, and for analyzing gases and DNA.

The Nagoya University deep-ultraviolet laser diode overcomes several issues encountered by scientists in their work towards the development of these semiconducting devices.

The team used a high-quality aluminum nitride (AlN) substrate as their base for building up the layers of the laser diode. This, they say, is necessary, since lower quality AlN contains a large amount of defects, which ultimately impact the efficiency of a laser diode's active in converting electrical into light energy.

Laser diode emits deep UV light
Cross-sectional structure of the UV-C semiconductor laser diode. Credit: 2019 Asahi Kasei Corp. and Nagoya University

In laser diodes, a '' and 'n-type' layer are separated by a quantum well. When an is passed through a laser diode, positively charged holes in the p-type layer and negatively charged electrons in the n-type layer flow toward the center to combine, releasing energy in the form of photons.

The researchers designed the quantum well so that it would emit deep UV light. The p- and n-type layers were made from aluminum gallium nitride (AlGaN). Cladding layers, also made from AlGaN, were placed on either side of the p- and n-type layers. The cladding below the n-type layer included silicon impurities, a process called doping. Doping is used as a technique to modify a material's properties. The cladding above the p-type layer underwent distributed polarization doping, which dopes the layer without adding impurities. The aluminum content in the p-side cladding was designed so that it was highest at the bottom, decreasing toward the top. The researchers believe this aluminum gradient enhances the flow of positively charged holes. A top contact layer was finally added that was made from p-type AlGaN doped with magnesium.

Laser diode emits deep UV light
Emission characteristics under pulsed operation. Credit: 2019 Asahi Kasei Corp. and Nagoya University

The researchers found that the polarization doping of the p-side cladding layer meant that a pulsed electric current of "remarkably low operating voltage" of 13.8V was needed for the emission of "the shortest wavelength reported so far."

The team is now conducting advanced joint research with Asahi Kasei Corporation to achieve continuous deep-UV lasing for the development of UV-C semiconductor laser products.

More information: Ziyi Zhang et al, A 271.8 nm deep-ultraviolet laser diode for room temperature operation, Applied Physics Express (2019). DOI: 10.7567/1882-0786/ab50e0

Provided by Nagoya University

Citation: Laser diode emits deep UV light (2020, January 20) retrieved 30 November 2022 from
This document is subject to copyright. Apart from any fair dealing for the purpose of private study or research, no part may be reproduced without the written permission. The content is provided for information purposes only.

Explore further

Understanding high efficiency of deep ultraviolet LEDs


Feedback to editors