Finger-pricks a thing of the past

May 12, 2010
Finger-pricks a thing of the past
Exhaled air from diabetics contains slightly higher levels of acetone vapor than healthy persons. A new kind of sensor can now selectively detect acetone even in the smallest concentrations.

ETH-Zurich researchers have developed a new kind of sensor that can immediately gauge whether a person is suffering from type 1 diabetes upon coming into contact with their breath.

Acetone is also found in a healthy person's breath, but the concentration is only about 900 ppb (particles per billion); in people suffering from , however, the concentration is double that; and in the case of a ketoacidosis it can be even higher. That’s why the sensor developed at ETH Zurich works so well: it can detect as few as 20 ppb of and even works at extremely high humidity levels of over 90 percent - like in the human breath.

Sotiris Pratsinis, professor of particle technology at the Institute of Process Engineering, and his team showcased the novel sensor on May 1 in the journal Analytical Chemistry of the American Chemical Society. They used a substrate with gold electrodes for the sensor and coated it with an ultra-thin semiconductor film made of nanoparticles. These particles consisted of tungsten oxide mixed with silicon, thus greatly improving the sensitivity of the sensor. The mixture is produced in a flame at a temperature of over 2200° C; the nanoparticles rise in a greenish-yellow cloud and are collected on the carrier substrate, which the researchers then cool with water. Through this rapid heating and cooling, a vitreous semiconductor layer forms on the electrodes stably capturing.the metastable crystalline phase of epsilon tungsten oxide that resonates with acetone giving its required high selectivity for undisputable detection of acetone vapor in the human breath.

Using high-resolution electron microscopes, the researchers observed that the deposited material exhibited an unusual spongy structure. The acetone molecules get caught up in the pores and begin to react with the tungsten oxide; if the breath contains relatively high acetone concentrations (> 1800 ppm), the of the material drops drastically and thus more electricity flows between the electrodes generating a correspondingly strong signal. For lower concentrations of acetone, on the other hand, the resistance drops significantly less.

In the future, ETH-Zurich professor Sotiris Pratsinis also hopes to develop materials that would be able to detect other chronic illnesses by breath analysis using such sensors. As far as diabetes sufferers are concerned, a handy, easy-to-use device would make a huge difference; it would mean they could make their own quick and easy diagnoses instead of taking blood samples to measure the blood sugar level, as they have had to do up to now, making the irksome daily finger-pricks a thing of the past. Sensors like this could also be put to good use in hospital emergency rooms, where it would provide a fuss-free method of establishing whether a patient has suffered a diabetic ketoacidosis.

The sensor is just a prototype for now; however, Pratsinis is currently on the lookout for a partner from medicine to turn it into a measuring device for everyday use.

Non-invasive methods to diagnose illnesses are becoming increasingly important and being fast, cheap and easy to use breath analysis is a key aspect in lowering the spiraling medical costs. The breath mainly consists of a mixture of nitrogen, oxygen, carbon dioxide and water, along with over 1,000 volatile substances that are only present in very small concentrations; these also include volatile organic compounds produced by the body itself. Some are typical for particular illnesses and serve as markers - like acetone for type-1 diabetes.

Explore further: Faster, cheaper tests for sickle cell disease

More information: References:

Righettoni M, Tricoli A, Pratsinis SE. Si:WO3 Sensors for Highly Selective Detection of Acetone for Easy Diagnosis of Diabetes by Breath Analysis, Anal. Chem. 2010, 82, 3581. DOI:10.1021/ac902695n

Tricoli A, Graf M, Mayer F, Kühne S, Hierlemann A, Pratsinis SE. Micropatterning layers by flame aerosol deposition-annealing, Adv. Mater. 2008, 20, 3005. DOI:10.1002/adma.200701844

Tricoli A, Pratsinis SE. Dispersed nanoelectrode devices, Nature Nanotech. 2010, 5, 54. DOI:10.1038/nnano.2009.349

add to favorites email to friend print save as pdf

Related Stories

New Nano-Sensor Can Detect Asthma Symptoms

Aug 23, 2007

A sensor developed at the University of Pittsburgh could strip the element of surprise from some asthma attacks by detecting one before its onset. Fitted in a hand-held device, the tiny sensor provides people who have asthma ...

Breath or urine analysis may detect cancer, diabetes

Mar 10, 2009

(PhysOrg.com) -- A future sensor may take away a patient's breath while simultaneously determining whether the patient has breast cancer, lung cancer, diabetes or asthma. A University of Missouri researcher is developing ...

Carbon Nanotubes Detect Lung Cancer Markers in the Breath

Nov 20, 2008

(PhysOrg.com) -- Using an array of nanotube devices, each coated with a different organic material, researchers at the Israel Institute of Technology have developed diagnostic system that may be able to diagnose lung cancer ...

Recommended for you

Faster, cheaper tests for sickle cell disease

5 hours ago

Within minutes after birth, every child in the U.S. undergoes a battery of tests designed to diagnose a host of conditions, including sickle cell disease. Thousands of children born in the developing world, ...

Simulations for better transparent oxide layers

8 hours ago

Touchscreens and solar cells rely on special oxide layers. However, errors in the layers' atomic structure impair not only their transparency, but also their conductivity. Using atomic models, Fraunhofer ...

The chemistry of beer and coffee

12 hours ago

University of Alabama at Birmingham professor Tracy Hamilton, Ph.D., is applying his chemistry expertise to two popular beverages: beer and coffee.

User comments : 0