Light-induced degradation in amorphous silicon thin film solar cells: New insight into microscopic mechanism

February 13, 2014
In the initial state (left), the voids' internal surfaces are saturated with hydrogen atoms so that no defects are observed. Light-induced charge carriers (h+) destabilize atomic bonds. The breaking of atomic bonds causes defects (indicated by the vertical arrows on the right hand side), which translates to reduced solar cell efficiency. Credit: HZB

Researchers at the Helmholtz Center Berlin (HZB) have taken a leap forward towards a deeper understanding of an undesired effect in thin film solar cells based on amorphous silicon – one that has puzzled the scientific community for the last 40 years. The researchers were able to demonstrate that tiny voids within the silicon network are partly responsible for reducing solar cell efficiency by some 10 to 15 percent as soon as you start using them. Their work has now been published in Physical Review Letters.

Amorphous silicon thin film are considered a promising alternative to solar cells based on highly purified silicon wafers, which have been dominating photovoltaic power generation. A major advantage of amorphous silicon thin film photovoltaics, where a glass substrate is coated with a light active material less than a thousandth of a millimeter thick, is that the cell fabrication is considerably simpler and much less costly than in the case of conventional crystalline silicon solar cells. On the other hand, a potential disadvantage is the low conversion efficiency from solar energy to electricity. Because of the disordered nature of amorphous silicon, solar cells are subject to the Staebler-Wronski effect, which reduces the by up to 15 percent within the first 1000 hours.

This undesired effect is triggered by internal annihilation – known in physics as recombination - of charge that has not been extracted from the solar cell. The released recombination energy induces defects in the amorphous network - which is why this effect is not observed in crystalline wafer solar cells. "However, where defects are produced in the material and whether voids of nanoscale size play a role in all this has not been understood – until now, that is," says HZB's own Matthias Fehr of the Institute for Silicon Photovoltaics. Fehr together with his HZB colleagues, scientists from Jülich Research Center and the Free University of Berlin have now made major strides towards unraveling this mystery.

Since the defects that form exhibit paramagnetic properties, they have a characteristic magnetic fingerprint, which depends on their microscopic environment. The Berlin researchers were able to identify this fingerprint using electron-paramagnetic resonance (EPR) spectroscopy and electron-spin echo (ESE) experiments. With the help of these highly sensitive techniques, they determined that defects in amorphous silicon actually come in two types: those that are uniformly distributed and those that are concentrated in clusters on internal surfaces of small voids - known in scientific circles as microvoids - which form within the material during the solar cell manufacturing process.

"Our guess is that clusters of defects are generated on the internal walls of microvoids, which have a diameter of a mere one to two nanometers," explains HZB physicist Fehr. "Our findings seem to suggest that microvoids most likely contribute to light-induced degradation of . For us, it's been a leap forward towards a better understanding of the microscopic mechanism of light-induced degradation," says Fehr who, in 2013, spent a year conducting research in the US as a Feodor Lynen Scholar of the Alexander Humboldt Foundation. A new series of experiments has been designed to allow the Berlin researchers to glean further insights into the atomic and electronic processes of the Staebler-Wronski effect, named for the two scientists who first discovered it.

Explore further: Dutch researchers raise energy yield of 'cheap' solar panels

More information: Fehr, M., Schnegg, A., Rech, B., Astakhov, O., Finger, F., Bittl, R., Teutloff, C., Lips, K. (2014) Metastable defect formation at microvoids identified as a source of light-induced degradation in a-Si:H. Phys. Rev. Lett. (accepted) DOI: 10.1103/PhysRevLett.112.066403

Related Stories

Recommended for you

A quantum of light for materials science

December 1, 2015

Computer simulations that predict the light-induced change in the physical and chemical properties of complex systems, molecules, nanostructures and solids usually ignore the quantum nature of light. Scientists of the Max-Planck ...

Quantum dots used to convert infrared light to visible light

December 1, 2015

(—A team of researchers at MIT has succeeded in creating a double film coating that is able to convert infrared light at modest intensities into visible light. In their paper published in the journal Nature Photonics, ...

Test racetrack dipole magnet produces record 16 tesla field

November 30, 2015

A new world record has been broken by the CERN magnet group when their racetrack test magnet produced a 16.2 tesla (16.2T) peak field – nearly twice that produced by the current LHC dipoles and the highest ever for a dipole ...

Turbulence in bacterial cultures

November 30, 2015

Turbulent flows surround us, from complex cloud formations to rapidly flowing rivers. Populations of motile bacteria in liquid media can also exhibit patterns of collective motion that resemble turbulent flows, provided the ...


Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.