Solid-state electrolyte with lithium-ion conductivities comparable to liquid electrolytes

September 6, 2017
Lithium amide-borohydride is a promising candidate for a solid electrolyte. The crystalline structure of this material consists of two sub-lattices, shown in different colors. Under appropriate conditions, lithium ions (red), normally found in the elementary cells of only one sub-lattice (yellow), move to the empty cells of the second sub-lattice (blue) where they can freely propagate. Credit: IFJ PAN

Many mobile devices are powered by lithium-ion batteries, which could be smaller, lighter, safer and more efficient if the liquid electrolytes they contain were replaced by solids. A promising candidate for a solid-state electrolyte is a new class of materials based on lithium compounds, presented by physicists from Switzerland and Poland.

Commercially available batteries consist of two electrodes connected by a liquid . This electrolyte makes it difficult for engineers to reduce the size and weight of the battery. Additionally, they are subject to leakage; the lithium in the exposed electrodes then comes into contact with oxygen in the air and undergoes self-ignition. This issue caused the full grounding of Dreamliner flights, a spectacular example of the problems brought about by the use of modern .

Laboratories have been searching for solid capable of replacing liquid electrolytes for years. The most popular candidates include in which lithium ions are surrounded by sulphur or oxygen ions. However, in the journal Advanced Energy Materials, a Swiss-Polish team of scientists has presented a new class of ionic compounds where the charge carriers are lithium ions moving in an environment of amine (NH2) and tetrahydroborate (BH4) ions. The experimental part of the research project was carried out at Empa, the Swiss Federal Laboratories for Materials Science and Technology in Dübendorf, and at the University of Geneva (UG), led by Prof. Zbigniew Lodziana from the Institute of Nuclear Physics of the Polish Academy of Sciences (IFJ PAN) in Cracow.

"We were dealing with lithium amide-borohydride, a substance previously regarded as an inadequate ionic conductor. This compound is made by milling two constituents in a ratio of one to three. To date, nobody has ever tested what happens to ionic conductivity when the proportions between these constituents are changed. We were the first to do so, and it turned out that by reducing the number of NH2 groups to a certain limit, we could significantly improve the conductivity. It increases so much that it becomes comparable to the conductivity of liquid electrolytes," says Prof. Lodziana.

This huge boost in ionic conductivity opens up a new, unexplored direction in the search for a solid-state electrolyte. Previously, the focus was almost exclusively on changes in the composition of the chemical substance. It has now become apparent that at the stage of production of the compound, a the proportions of the ingredients used to manufacture them are key.

"Our lithium amide-borohydride is a representative of a promising new class of solid-state electrolyte materials. However, it will be some time before batteries built on such compounds come into use. For example, there should be no chemical reactions between the electrolyte and the electrodes leading to their degradation. This problem is still waiting for an optimal solution," says Prof. Lodziana.

The research prospects are promising. The scientists did not confine themselves simply to characterizing the physico-chemical properties of the new material. The compound was used as an electrolyte in a typical Li4Ti5O12 half-cell. The half-cell performed well in tests of depletion and recharging, proving stable over 400 cycles. The researchers have taken promising steps toward resolving another important issue. The lithium amide-borohydride described in the publication exhibited excellent ionic conductivity only at about 40 °C. In the most recent experiments, this has already been lowered below room temperature.

Theoretically, however, the new material remains a challenge. Previously, researchers have constructed models for substances in which the lithium ions move in an atomic environment. In the new material, ions move among light molecules that adjust their orientation to ease the lithium movement.

"In the proposed model, the excellent ionic conductivity is a consequence of the specific construction of the crystalline lattice of the tested material. This network in fact consists of two sub-lattices. It turns out that the ions are present here in the elementary cells of only one sub-lattice. However, the diffusion barrier between the sub-lattices is low. Under appropriate conditions, the ions thus travel to the second, empty sub-lattice, where they can move quite freely," explains Prof. Lodziana.

This explains only some of the observed features of the new material. The mechanisms responsible for its high are certainly more complex. Further study should significantly accelerate the search for optimal compounds for a solid-state electrolyte and consequently shorten the process of commercialization of new power sources that are most likely to revolutionize portable electronics.

Explore further: A solid-state electrolyte that is able to compete with liquid electrolytes for rechargeable batteries

More information: Yigang Yan et al, A Lithium Amide-Borohydride Solid-State Electrolyte with Lithium-Ion Conductivities Comparable to Liquid Electrolytes, Advanced Energy Materials (2017). DOI: 10.1002/aenm.201700294

Related Stories

Melting, coating, and all-solid-state lithium batteries

January 1, 2016

The joint research team of Prof. Yoon Seok Jung (UNIST, School of Energy and Chemical Engineering) and Prof. Seng M. Oh (Seoul National University) discovered a new way to develop all-solid-state lithium batteries without ...

Building a safer lithium-ion battery

July 12, 2017

Lithium-ion batteries have become an indispensable power source for our proliferating gadgets. They have also, on occasion, been known to catch fire. To yield insight into what goes wrong when batteries fail and how to address ...

Sodium and magnesium to replace lithium in batteries

May 2, 2017

Scientists supported by the SNSF have produced novel electrolytes for rechargeable sodium and magnesium batteries. The research group's objective was to develop alternatives to lithium-ion technology.

Recommended for you

More efficient separation of methane and CO2

October 18, 2017

To make natural gas and biogas suitable for use, the methane has to be separated from the CO2. This involves the use of membranes, filters that stop the methane and allow the CO2 to pass through. Researchers at KU Leuven ...

A new way to harness wasted methane

October 17, 2017

Methane gas, a vast natural resource, is often disposed of through burning, but new research by scientists at MIT could make it easier to capture this gas for use as fuel or a chemical feedstock.

0 comments

Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.