Switching with a few photons for quantum computing

December 5, 2012 by Bill Steele, Cornell University
Switching with a few photons for quantum computing
Electron microscope photo of a cross-section of photonic bandgap fiber. Tiny glass tubes surrounding the core bend light waves in such a way that they interfere and cancel out, focusing all the energy of a beam into the hollow core. Credit: Gaeta Lab

(Phys.org)—Quantum computing, where bits of information, or "qubits," are represented by the state of single atomic particles or photons of light, won't be of much use unless we can read the results. Cornell researchers have taken a step in that direction with a device that can measure the presence of just a few photons without disturbing them.

The experiment mixes a strong beam of with a very weak "signal" beam consisting of fewer than 20 photons in such a way that the phase—a measure of the timing of a wave—of the strong beam changes in proportion to the number of photons in the signal.

"Ideally what people want is to be able to measure the presence of a single photon, without destroying it," said Alex Gaeta, professor and director of applied and . "Nevertheless, there are interesting algorithms you can do with just a few photons." Switching a light beam with a single photon would be the equivalent of a "gate" in a conventional electronic computer, where a 1 or 0 input switches the output between 1 and 0. In future applications this could communicate the state of a qubit in a quantum computer, or the photons themselves might be the .

The device created by Gaeta's research group makes use of a new type of optical fiber known as photonic bandgap fiber, which consists of a hollow core surrounded by a honeycomb of tiny glass tubes. The honeycomb acts as a that bends light in such a way that all wavelengths are canceled except for a narrow gap at the fundamental wavelength of the light to be transported, confining that light to an intense beam in the core. The advantage over conventional glass fiber is that the core can be filled with a gas.

In experiments reported in the Dec. 2 online issue of the journal , the researchers filled the core of a fiber about 9 centimeters long with rubidium vapor to exploit what's known as the Kerr effect, in which the oscillating electromagnetic fields in a beam of light interact with the electromagnetic fields of the electrons in atoms to change the refractive index of the medium, which changes the way light is affected when it passes through. The weak signal beam changes the refractive index of the rubidium vapor enough to change the phase of the strong beam, which can be measured after the beam emerges from the fiber. The process is "nondestructive" in that the number of photons in the signal beam is not affected.

Varying the intensity of the signal, and thereby the number of photons, the researchers measured a phase change of about .3 milliradians (a unit of angle) per photon, suggesting that eventually single photons could be detected, and that such a device could be used to count . Varying the length of pulses of the strong beam showed that the system could respond in less than 5 nanoseconds, indicating that the strong beam could be modulated at frequencies up to 50 MHz.

Similar measurements have been performed in apparatus cooled to cryogenic temperatures, the researchers noted, but this is the first time it has been done at room temperature.

Explore further: Switching light on and off - with photons

Related Stories

Switching light on and off - with photons

November 9, 2011

(PhysOrg.com) -- Cornell researchers have demonstrated that the passage of a light beam through an optical fiber can be controlled by just a few photons of another light beam.

Breakthrough for photons in the microwave frequency range

February 22, 2011

Photons in the microwave frequency range are important in quantum research - for quantum information processors, for example. Now, for the first time, researchers have achieved the controlled production of single photons ...

Fast, low-power, all-optical switch

May 3, 2012

An optical switch developed at the Joint Quantum Institute (JQI) spurs the prospective integration of photonics and electronics. What, isn't electronics good enough? Well, nothing travels faster than light, and in the effort ...

Recommended for you

Information engine operates with nearly perfect efficiency

January 19, 2018

Physicists have experimentally demonstrated an information engine—a device that converts information into work—with an efficiency that exceeds the conventional second law of thermodynamics. Instead, the engine's efficiency ...

Team takes a deep look at memristors

January 19, 2018

In the race to build a computer that mimics the massive computational power of the human brain, researchers are increasingly turning to memristors, which can vary their electrical resistance based on the memory of past activity. ...

Artificial agent designs quantum experiments

January 19, 2018

On the way to an intelligent laboratory, physicists from Innsbruck and Vienna present an artificial agent that autonomously designs quantum experiments. In initial experiments, the system has independently (re)discovered ...


Adjust slider to filter visible comments by rank

Display comments: newest first

2 / 5 (3) Dec 05, 2012
"can measure the presence of just a few photons without disturbing them" this doesn't break the ruels of quantum physics?
1 / 5 (1) Dec 05, 2012
Every few weeks we hear of a new discovery that will bring quantum computing closer to reality. I'm just wondering if all these things are being compiled somewhere in a useful way, or are they just out there ... waiting?

Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.