Scientists improve chip memory by stacking cells

Dec 21, 2009

(PhysOrg.com) -- Scientists at Arizona State University have developed an elegant method for significantly improving the memory capacity of electronic chips.

Led by Michael Kozicki, an ASU electrical engineering professor and director of the Center for Applied Nanoionics, the researchers have shown that they can build stackable memory based on “ionic ,” which could make them ideal candidates for storage cells in high-density memory. Best of all, the new method uses well-known electronics materials.

“This opens the door to inexpensive, high-density data storage by ‘stacking’ memory layers on top one another inside a single chip,” Kozicki said. “This could lead to hard drive data storage capacity on a chip, which enables portable systems that are smaller, more rugged and able to go longer between battery charges.”

“This is a significant improvement on the technology we developed two years ago where we made a new type of memory that could replace Flash, using materials common to the (copper-doped ). What we have done now is add some critical functionality to the memory cell merely by involving another common materia - silicon.”

Kozicki outlined the new in a technical presentation he made in November at the 2009 International Electron Devices and Materials Symposia in Taiwan. He worked with Sarath C. Puthen Thermadam, an ASU electrical engineering graduate student.

Kozicki said that given current technology, electronics researchers are fast reaching the physical limits of device memory. This fact has spurred research into new types of memory that can store more information into less and less physical space. One way of doing this is to stack memory cells.

The concept of stackable memory is akin to one’s ability to store boxes in a small room. You can store more boxes (each representing a memory cell) if you stack them and take advantage of three dimensions of the room, rather than only putting each box on the floor.

Kozicki said stacking memory cells has not been achieved before because the cells could not be isolated. Each memory cell has a storage element and an access device; the latter allowing you to read, write or erase each storage cell individually.

“Before, if you joined several memory cells together you wouldn’t be able to access one without accessing all of the others because they were all wired together,” Kozicki said. “What we did was put in an access, or isolation device, that electrically splits all of them into individual cells.”

Up until now, people built these access elements into the silicon substrate.

“But if you do that for one layer of memory and then you build another layer, where will you put the access device,” Kozicki asked. “You already used up the silicon on the first layer and it’s a single crystal, it is very difficult to have multiple layers of single crystal material.”

The new approach does use silicon, but not single crystal silicon, which can be deposited in layers as part of the three-dimensional memory fabrication process. Kozicki said his team was wrestling with how to find a way to build an electrical element, called a diode, into the memory cell. The diode would isolate the cells.

Kozicki said this idea usually involves several additional layers and processing steps when making the circuit, but his team found an elegant way of achieving diode capability by substituting one known material for another, in this case replacing a layer of metal with doped silicon.

“We can actually use a number of different types of silicon that can be layered,” he said. “We get away from using the substrate altogether for controlling the and put these access devices in the layers of memory above the silicon substrate.”

“Rather than having one transistor in the substrate controlling each memory cell, we have a memory cell with a built-in diode (access device) and since it is built into the cell, it will allow us to put in as many layers as we can squeeze in there,” Kozicki said. “We’ve shown that by replacing the bottom electrode with silicon it is feasible to go any number of layers above it.

With each layer applied, significantly expands.

“Stackable memory is thought to be the only way of reaching the densities necessary for the type of solid state memory that can compete with hard drives on cost as well as information storage capacity,” Kozicki said. “If you had eight layers of memory in a single chip, this would give you almost eight times the density without increasing the area.”

Kozicki said the advance mimics an idea employed in early radios.

“We created a modern analog to the ‘cat’s whisker,’ where we are growing a nanowire, a copper nanowire, right onto the silicon to create a diode,” he said.

Cat’s whisker radios, a product of the 1930s, were simple devices that employed a small wire to scratch the surface of a semiconductor material. The connection between the semiconductor and the wire created a diode that they could use as part of a radio.

“It turns out to be a ridiculously simple idea, but it works,” Kozicki said of his stackable memory advance. “It works better than the complicated ideas work.”

“The key was the diodes, and making a diode that was simple and essentially integrated in with the cell. Once you do that, the rest is pretty straightforward.”

Explore further: X-ray detector on plastic delivers medical imaging performance

add to favorites email to friend print save as pdf

Related Stories

Toshiba Develops New NAND Flash Technology

Jun 12, 2007

Toshiba Corporation today announced a new three dimensional memory cell array structure that enhances cell density and data capacity without relying on advances in process technology, and with minimal increase ...

Organic flash memory developed

Dec 17, 2009

(PhysOrg.com) -- Researchers at the University of Tokyo have developed a non-volatile memory that has the same basic structure as a flash memory but is made from cheap, flexible, organic materials.

Spansion 512Mb NOR Flash Memory Ships In Mobile Phone

Jun 13, 2005

Spansion LLC, the Flash memory venture of AMD and Fujitsu Limited, today announced that top French handset manufacturer, SAGEM, has developed the SAGEM myX-8 mobile phone using the Spansion S29GL512N Flash memory device – ...

Recommended for you

Growing app industry has developers racing to keep up

7 hours ago

Smartphone application developers say they are challenged by the glut of apps as well as the need to update their software to keep up with evolving phone technology, making creative pricing strategies essential to finding ...

Review: With Galaxy S5, Samsung proves less can be more

9 hours ago

Samsung Electronics Co. has produced the most formidable rival yet to the iPhone 5S: the Galaxy S5. The device, released over the weekend, is the fifth edition of the company's successful line of Galaxy S ...

User comments : 3

Adjust slider to filter visible comments by rank

Display comments: newest first

plasticpower
4.5 / 5 (2) Dec 21, 2009
I always wondered why nobody has stacked memory chips before. Seems like such an obvious idea. Glad the article explains the struggles and solutions.
SincerelyTwo
5 / 5 (1) Dec 21, 2009
plasticpower,

It's not that people didn't realize they could stack memory, it's that they haven't been *able to make it work well, or at all, for general use.
plasma_guy
5 / 5 (3) Dec 22, 2009
Stacking saves array area (or rather keeps it the same while increasing bits) but adds more to periphery area, since you need more circuitry to control each layer. Unless you have CMOS periphery on each layer (only possible by stacking wafers), you don't improve area efficiency but make it worse.

More news stories

Growing app industry has developers racing to keep up

Smartphone application developers say they are challenged by the glut of apps as well as the need to update their software to keep up with evolving phone technology, making creative pricing strategies essential to finding ...

Making graphene in your kitchen

Graphene has been touted as a wonder material—the world's thinnest substance, but super-strong. Now scientists say it is so easy to make you could produce some in your kitchen.