Metamaterials approach makes better satellite antennas

Jan 31, 2011
3-dimentional rendering of metamaterial lined feed horn antenna with low loss, low weight, and over an octave bandwidth for satellite communications shown with satellite. Credit: Penn State

(PhysOrg.com) -- Cheaper, lighter and more energy-efficient broadband devices on communications satellites may be possible using metamaterials to modify horn antennas, according to engineers from Penn State and Lockheed Martin Corp.

"Existing horn antennas have adequate performance, but have undergone little change over several decades except for advances in more accurate modeling techniques," said Erik Lier, technical Fellow, Lockheed Martin Space Systems Co. "Modifications enabled by metamaterials can either enhance performance, or they can lower the mass and thus lower the cost of putting the antenna in space."

Lighter antennas cost less to boost into space and more energy-efficient antennas can reduce the size of storage batteries and , which also reduces the mass.

Metamaterials derive their unusual properties from structure rather than composition and possess exotic properties not usually found in nature.

"Working with Penn State, we decided that the first year we were going focus on applications for antennas, where we thought we had a reasonable chance to succeed," said Lier.

According to Douglas H. Werner, professor of electrical engineering, Penn State, this is one of the first practical implementations of electromagnetic metamaterials that makes a real world device better.

"These results also help lay to rest the widely held viewpoint that metamaterials are primarily an academic curiosity and, due to their narrow and relatively high loss, will never find their way into real-world devices," the researchers report in the current issue of .

They specifically designed their electromagnetic metamaterials to avoid previous limitations of narrow bandwidth and high intrinsic material loss, which results in signal loss. Their aim was not to design theoretical metamaterial-enhanced antennas, but to build a working prototype.

"We have developed design optimization tools that can be employed to meet real device requirements," said Werner. "We can optimize the metamaterial to get the best device performance by tailoring its properties across a desired bandwidth to meet the specific needs of the horn antenna."

Wire grid metamaterial with low loss and a low refractive index (between 0 and 1) is used to line horn antennas for satellite communications. Credit: Penn State

The researchers wanted an antenna that could work over a broad band of frequencies -- at least an octave -- and improve upon existing antennas. An octave in the radio frequency spectrum is a stretch of bandwidth where the upper frequency is twice the lower frequency -- 3.5 to 7 gigahertz for example, which is wider than the standard C-band.

Horn antennas are part of that relay television and radio signals, telephone calls and data around the world. Two commonly used microwave bands on satellites are C-band -- used for long-distance radio and telecommunications -- and Ku-band -- used for broadcast television and remote television uplinks.

The researchers, who also included Qi Wu and Jeremy A. Bossard, postdoctoral fellows in electrical engineering, and Clinton P. Scarborough, graduate student, electrical engineering, all from Penn State, designed horn antenna liners from with special low-index electromagnetic properties -- effective refractive index between zero and one -- which do not physically exist in natural materials. To increase bandwidth and decrease loss, the antenna liners needed to have repetitive structure considerably smaller than the wavelengths the antenna is designed to transmit.

Ku-band -- 12 to 18 gigahertz -- antennas require small structural intervals that are easily fabricated using conventional printed circuit board manufacturing techniques, while super extended C-band -- 3.4 to 6.725 gigahertz -- could be achieved with a simple wire grid structure that is easily manufactured with an interval of about a quarter of an inch between wires. The researchers chose to convert the C-band application into a prototype.

"This is just an example of what we can do," said Lier. "It opens up the way for a broader range of other applications and is proof of the new metamaterial technology and an example of how it can be used."

Explore further: Lifting the brakes on fuel efficiency

Related Stories

Multimedia car radio of the future

Jan 25, 2007

Crackling radio stations, signal loss in tunnels and difficulties tuning to the correct frequency – the conventional car radio has had its day. ESA and its partners are developing the multimedia car radio ...

NASA Unveils New Antenna Network in White Sands, N.M.

Nov 09, 2007

Engineers from NASA’s Goddard Space Flight Center in Greenbelt, Md., showcased the new 18-meter Ka Band Antenna Network, the first such system in agency history, during a ribbon-cutting ceremony at the White ...

Recommended for you

Lifting the brakes on fuel efficiency

Apr 18, 2014

The work of a research leader at Michigan Technological University is attracting attention from Michigan's Governor as well as automotive companies around the world. Xiaodi "Scott" Huang of Michigan Tech's ...

Large streams of data warn cars, banks and oil drillers

Apr 16, 2014

Better warning systems that alert motorists to a collision, make banks aware of the risk of losses on bad customers, and tell oil companies about potential problems with new drilling. This is the aim of AMIDST, the EU project ...

User comments : 4

Adjust slider to filter visible comments by rank

Display comments: newest first

gwrede
1 / 5 (3) Jan 31, 2011
A bandwidth of one octave is presented as a big deal here.

The main article picture in Wikipedia "horn antenna" article shows an antenna for 0.8 to 18 GHz, which is 4.5 octaves.
fmfbrestel
1 / 5 (1) Jan 31, 2011
well, right. but it doesn't matter if your C-band communications satellite cant communicate in Ku-band too. What you care about is how much launching the thing into space will cost. If you want a general purpose antenna, buy a big heavy conventional horn. If you need a C-band antenna (and are paying thousands of dollars per kilogram) get the smaller and lighter one.

pointing out that some advance isn't a panacea to the entire field is a bit childish.
El_Nose
1 / 5 (2) Jan 31, 2011
please define octave for me when refering to antenna i am used to the classic musical sound frequency reference
fmfbrestel
5 / 5 (1) Jan 31, 2011
they do define octave

"An octave in the radio frequency spectrum is a stretch of bandwidth where the upper frequency is twice the lower frequency -- 3.5 to 7 gigahertz for example, which is wider than the standard C-band."

Way to read the article

More news stories

Ex-Apple chief plans mobile phone for India

Former Apple chief executive John Sculley, whose marketing skills helped bring the personal computer to desktops worldwide, says he plans to launch a mobile phone in India to exploit its still largely untapped ...

A homemade solar lamp for developing countries

(Phys.org) —The solar lamp developed by the start-up LEDsafari is a more effective, safer, and less expensive form of illumination than the traditional oil lamp currently used by more than one billion people ...

NASA's space station Robonaut finally getting legs

Robonaut, the first out-of-this-world humanoid, is finally getting its space legs. For three years, Robonaut has had to manage from the waist up. This new pair of legs means the experimental robot—now stuck ...