June 21, 2021

This article has been reviewed according to Science X's editorial process and policies. Editors have highlighted the following attributes while ensuring the content's credibility:

Researchers obtain new results on corrosion behavior of alloy materials under extreme environments

Fig. 1. Schematic diagram of the high temperature and high pressure water dynamic corrosion device. Credit: LIU Chao
× close
Fig. 1. Schematic diagram of the high temperature and high pressure water dynamic corrosion device. Credit: LIU Chao

The service behavior of materials under extreme environments is one of the bottlenecks restricting the development of advanced nuclear energy systems. Researchers at the Institute of Modern Physics (IMP) of the Chinese Academy of Sciences (CAS) have lately obtained new results on the corrosion behavior of alloy materials under strong irradiation, high temperature and coolant corrosive environments.

To simulate the environment faced by the structural materials of supercritical -cooled reactors, the researchers have independently designed and built a high temperature and high pressure water dynamic corrosion test device, whose maximum operating temperature, pressure and water flow rate are respectively 700 degrees Celsius, 10 MPa and 10 m/s, and minimum oxygen concentration is 5 ppb.

Ferrite-martensitic steels SIMP and T91 are proposed as candidate materials for the supercritical water-cooled reactor. Researchers studied both the high temperature water corrosion kinetics and the corrosion behavior of SIMP and T91 under irradiation by using the Heavy Ion Research Facility in Lanzhou and the high temperature and high pressure water dynamic corrosion device.

It is found that SIMP steel has better water corrosion resistance than T91 steel. The corrosion rate is enhanced by the flow rate, which also has a significant effect on the phase of the oxide film.

The results of heavy ion pre-irradiation experiments confirm that irradiation causes a significant increase in the corrosion rate of materials. According to the , the researchers also discussed the high water corrosion behavior of the material and the mechanism of resistance degradation under irradiation.

Fig. 2. Corrosion kinetics curves of SIMP and T91 steels (5 m/s, 5 ppb). Credit: LIU Chao
× close
Fig. 2. Corrosion kinetics curves of SIMP and T91 steels (5 m/s, 5 ppb). Credit: LIU Chao
Fig. 3. Variation of oxide film thickness of T91 steel with irradiation dose (450 ℃, 5 m/s, 10 MPa, 5 ppb). Credit: LIU Chao
× close
Fig. 3. Variation of oxide film thickness of T91 steel with irradiation dose (450 ℃, 5 m/s, 10 MPa, 5 ppb). Credit: LIU Chao

These achievements provide not only an important research platform, but also experimental methods for the rapid screening and evaluation of candidate materials for advanced water-cooled reactors.

Results have been published in Corrosion Science.

More information: Chao Liu et al, The role of He irradiation in the corrosion behavior of T91 in high-temperature steam, Corrosion Science (2021). DOI: 10.1016/j.corsci.2021.109602

Chao Liu et al, Corrosion behavior of ferritic–martensitic steels SIMP and T91 in fast-flowing steam, Corrosion Science (2021). DOI: 10.1016/j.corsci.2021.109474

Load comments (0)