Tuning the wavelength of fluorescent carbon tubes

Carbon is not just the most important element for life, it also has fascinating properties of its own. Graphene—a pure carbon sheet just one atom thick—is one of the strongest materials. Roll graphene into a cylinder and you get carbon nanotubes (CNTs), the key to many emerging technologies.

Now, in a study reported in Chemical Communications, researchers at Japan's Kyushu University learned to control the of CNTs, potentially allowing new applications.

CNTs are naturally fluorescent—when placed under light, they respond by releasing light of their own, a process called photoluminescence. The (color) of fluorescence depends on the tubes' structure, such as the angle at which they are rolled. Fluorescent CNTs have been studied for use in LED lighting and medical imaging.

The Kyushu team aimed to gain finer control over the emission wavelength. "Fluorescence occurs when electrons use energy from light to jump into higher orbitals around atoms," the lead authors explain. "They sink back to a lower orbital, then release excess energy in the form of light. The wavelength of emitted light differs from the input , depending on the energy of the emitting orbital." Although fluorescence is often associated with yellow materials, the fluorescence of these CNTs is infrared, which is invisible to the eye but can be detected by sensors.

The researchers used chemistry to tether organic molecules—hexagons of atoms—onto the CNTs. This pushed the orbitals up or down, thus tuning the fluorescence. One of the six atoms in each hexagon was bonded to a CNT, anchoring the molecule to the tube. Another was bonded to an extra group of atoms (a substituent). Because of the hexagonal shape, the two bonded carbons could be adjacent (denoted "o"), or separated by one carbon ("m"), or by two ("p"). Most studies use the "p" arrangement, where the substituent points away from the CNT, but the Kyushu team compared all three.

The "o" pattern produced very different fluorescence from "m" and "p"—instead of one , the CNTs now emitted two. This resulted from distortion of the tubes by the substituents, which were squeezed against the tube walls. Meanwhile, for the "m" and "p" arrangements, the energies depended on which elements were in the substituent. For example, NO2 produced bigger gaps between orbitals than bromine. This was no surprise, as NO2 is better at attracting electrons, creating an electric field (dipole). However, the size of the effect differed between "m" and "p."

"The variation in orbital energies with different substituents gives us fine control of the emission wavelength of CNTs over a broad range," the authors say. "The most important outcome is to understand how dipoles influence fluorescence, so we can rationally design CNTs with the very precise wavelengths needed by biomedical devices. This could be very important for the development of bioimaging in the near future."

The article, "Near infrared photoluminescence modulation by defect site design using aryl isomers in locally functionalized ," was published in Chemical Communications.

Explore further

The electronic origins of fluorescence in carbon nanotubes

More information: Tomohiro Shiraki et al, Near infrared photoluminescence modulation by defect site design using aryl isomers in locally functionalized single-walled carbon nanotubes, Chemical Communications (2017). DOI: 10.1039/c7cc06663e
Journal information: Chemical Communications

Provided by Kyushu University
Citation: Tuning the wavelength of fluorescent carbon tubes (2017, November 28) retrieved 28 June 2022 from https://phys.org/news/2017-11-tuning-wavelength-fluorescent-carbon-tubes.html
This document is subject to copyright. Apart from any fair dealing for the purpose of private study or research, no part may be reproduced without the written permission. The content is provided for information purposes only.

Feedback to editors