Optical strontium atomic clock sets new stability record

February 10, 2016
Noise contributions of the strontium lattice clock as a function of the number of atoms. The predicted total noise at suppressed frequency noise of the interrogation laser (green line) is confirmed by experimental data (green circles). The quantum projection noise (blue line) already dominates with few atoms. Credit: PTB

Researchers from the Physikalisch-Technische Bundesanstalt (PTB) have thoroughly analyzed the noise processes in their optical lattice clock with neutral strontium atoms. This analysis proves that their optical atomic clock has reached the best stability worldwide thanks to a newly developed laser system whose frequency is extremely stable. This allows high-precision measurements in a short time and considerably facilitates the future reduction of the total measurement uncertainty down to a few parts in 1018.

In the research community, optical clocks have been attracting increasing interest. They could allow the SI base unit of time, the second, to be realized with even greater accuracy in future and thus replace the current definition which is based on the interaction between microwave radiation and cesium atoms. The most highly precise clocks, however, cover a wide range of applications which range from geodesy (where they allow the direct and more accurate measurement of the gravitational potential of the Earth), to the investigation of the "great questions" of modern physics (such as a unified theory of the fundamental interactions) by searching for possible variations in fundamental constants (e.g. the fine-structure constant) by comparing diverse clocks with each other.

The accuracy and the stability of optical clocks are mainly based on the fact that the of the optical radiation used is higher (by several orders of magnitude) than that of the which is used in cesium atomic clocks, which makes optical clocks much more precise than cesium clocks. In a strontium clock, laser cooling is used to slow an atomic gas down to temperatures near absolute zero. Then, an extremely narrow transition between long-lived eigenstates of the atoms is excited in order to stabilize the frequency of the excitation laser to that of the atoms. The simultaneous interrogation of numerous atoms leads to a particularly high signal-to-noise ratio and, thus, to high stability.

However, since an atomic cloud must be prepared after each interrogation, interruptions in the observation of the occur. The laser itself hence serves as a "flywheel" and is commonly pre-stabilized to an optical resonator which keeps the laser frequency stable over short periods of time. The scientists from PTB have therefore developed a resonator whose frequency is among the most stable worldwide: with a length of 48 cm and ingenious thermal and mechanical isolation from its environment, it reaches a fractional frequency instability of 8 10-17.

The scientists analyzed the individual contributions to noise of the detected excitation probabilities of their clock. Based on their analysis, PTB's strontium clock attains the quantum projection noise limit, which is due to the laws of physics, with as few as 130 atoms. This noise results from the state measurement itself, since after excitation, each atom is first in a superposition of the two eigenstates and is randomly projected into one of the two states only when the measurement is performed.

To analyze the clock's instability, the model derived from this was supplemented by the known influence of the laser frequency noise, and its prediction was experimentally verified by a self-comparison of the clock. From this, the scientists at PTB derived a fractional instability in normal operation amounting to 1.6 10-16/τ1/2 as a function of the averaging time τ in seconds. This is the best published value for an atomic clock so far. It is expected to considerably facilitate the further reduction of the total uncertainty of the strontium clock down to a few parts in 1018.

Explore further: Highly-precise comparison of mercury and strontium optical lattice clocks

More information: Ali Al-Masoudi et al. Noise and instability of an optical lattice clock, Physical Review A (2015). DOI: 10.1103/PhysRevA.92.063814

Related Stories

Optical Atomic Clock: A long look at the captured atoms

February 5, 2008

Optical clocks might become the atomic clocks of the future. Their "pendulum", i.e. the regular oscillation process which each clock needs, is an oscillation in the range of the visible light. As its frequency is higher than ...

Optical strontium clock to become much more accurate

January 9, 2013

(Phys.org)—An optical clock with neutral strontium atoms is considered one of the top candidates for the definition of a "new" second. The probabilities have increased considerably, since its frequency will now be determined ...

New 'pendulum' for the ytterbium clock

March 9, 2012

The faster a clock ticks, the more precise it can be. Due to the fact that lightwaves vibrate faster than microwaves, optical clocks can be more precise than the caesium atomic clocks which presently determine time. The Physikalisch-Technische ...

Quantum mechanic frequency filter for atomic clocks

March 9, 2015

Atomic clocks are the most accurate clocks in the world. In an atomic clock, electrons jumping from one orbit to another decides the clock's frequency. To get the electrons to jump, researchers shine light on the atoms using ...

Atomic fountain clocks are becoming still more stable

March 18, 2009

They are at present the most accurate clocks in the world: Caesium fountain clocks furnish the second accurate to 15 places after the decimal point. Until they reach this accuracy, caesium fountain clocks, however, need a ...

Recommended for you

Complete design of a silicon quantum computer chip unveiled

December 15, 2017

Research teams all over the world are exploring different ways to design a working computing chip that can integrate quantum interactions. Now, UNSW engineers believe they have cracked the problem, reimagining the silicon ...

Single-photon detector can count to four

December 15, 2017

Engineers have shown that a widely used method of detecting single photons can also count the presence of at least four photons at a time. The researchers say this discovery will unlock new capabilities in physics labs working ...

Real-time observation of collective quantum modes

December 15, 2017

A cylindrical rod is rotationally symmetric - after any arbitrary rotation around its axis it always looks the same. If an increasingly large force is applied to it in the longitudinal direction, however, it will eventually ...

A shoe-box-sized chemical detector

December 15, 2017

A chemical sensor prototype developed at the University of Michigan will be able to detect "single-fingerprint quantities" of substances from a distance of more than 100 feet away, and its developers are working to shrink ...


Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.