A new design for an easily fabricated, flexible and wearable white-light LED

A new design for an easily fabricated, flexible and wearable white-light LED
A large area warm white light source with bending capability. Credit: Chin-Wei Sher, Chien-chung Lin, Hao-Chung Kuo/National Chiao Tung University.

Researchers from National Chiao Tung University, Taiwan have created highly flexible, efficient white LEDs with potential use in wearable displays and non-flat surfaces, such as curved and flexible television screens. While the design itself is new, the LED was completely fabricated from pre-existing technologies, allowing others to easily replicate and build on the platform.

"Compared to , this design of flexible LEDs can be very attractive, due to the low cost, prolonged lifetime and high efficiency. In addition, all of the technologies associated with this design are currently available," said Chien-Chung Lin, associate professor, College of Photonics, National Chiao Tung University, Taiwan.

A paper by Lin, Professor Hao-Chung Kuo, and their research team appears this week in Optics Express, a journal published by The Optical Society (OSA). This is their first flexible LED device, while their previous work had involved conventional gallium-nitride LEDs.

The researchers' off-the-shelf LED device gets its flexibility from its two primary materials, polyimide and polydimethylsiloxane. To construct it, Lin and his colleagues first covered a polyimide substrate with copper foil shielding tape. In a process known as flip-chip bonding, which reduces thermal resistance and results in higher heat dissipation than traditional wire bonding, they mounted 81 Blue LED chips, measuring 1.125 mm x 1.125 mm, to the foil in an upside down position.

To provide a warm white-yellow light, the researchers then added another layer consisting of a yellow phosphor film that had been mixed and spin-coated in polydimethylsiloxane, or PDMS, a widely used silicone-based organic polymer. It was chosen for its high degree of transparency, stability, and flexibility. The final film measured five centimeters by five centimeters, but there is no reasonable limitation to the size of the film.

The researchers ran the device for a standard 1,000 hours, to test its durability, finding that its emission decayed by only 5%. Its potential for use in wearables was demonstrated when subjected to bending tests. It held its power output when bent to a curvature with a 1.5-cm radius. It also exhibited a light efficiency of 120 lumens per watt.

"Because the components are all available by current technology, the combined reliability can be very good," Lin said. "Most of the novel processes or materials require a lengthy procedure to verify their reliability, but our design uses only available parts to avoid this issue."


Explore further

New technology can expand LED lighting, cutting energy use and greenhouse gas emissions

More information: C. Sher, K. Chen, C. Lin, H. Han, H. Lin, Z. Tu, H. Tu, K. Honjo, H. Jiang, S. Ou, R. Horng, X. Li, C. Fu H. Kuo. "Large-area, uniform white light LED source on a flexible substrate," Optics Express 23, 1167-1178 (2015). www.osapublishing.org/oe/abstr … m?uri=oe-23-19-A1167
Journal information: Optics Express

Citation: A new design for an easily fabricated, flexible and wearable white-light LED (2015, August 20) retrieved 14 May 2021 from https://phys.org/news/2015-08-easily-fabricated-flexible-wearable-white-light.html
This document is subject to copyright. Apart from any fair dealing for the purpose of private study or research, no part may be reproduced without the written permission. The content is provided for information purposes only.
2093 shares

Feedback to editors

User comments