All that rubbing of your backpack straps on your shoulders may be put to good use, now that researchers have designed a novel type of energy harvesting backpack. The pack has straps made of a piezoelectric material that can convert the mechanical strain on the straps into electrical energy that may power or recharge portable electronics.
The piezoelectric backpack straps are the latest innovation in the area of “energy harvesting,” where otherwise-wasted, ambient energy is converted into electrical energy to prolong the life of electronics. Mechanical engineers Jonathan Granstrom and Joel Feenstra from Michigan Technological University, Henry Sodano from Arizona State University, and Kevin Farinholt from NanoSonic, Inc., have published their results in a recent issue of Smart Materials and Structures.
The group’s intentions in designing the energy harvesting backpack were to make a device that was transparent to the user by not interfering with the user’s flexibility or endurance, as well as providing enough energy to reduce the need for carrying heavy batteries to power portable electronics.
“The advantage of this system is that it seamlessly replaces a currently-used material with one that generates electrical energy,” Sodano told PhysOrg.com. “The strap would operate no differently than the strap on a traditional backpack.”
The backpack uses straps made of polyvinylidene fluoride (PVDF), a strong, flexible material that feels very similar to nylon. But unlike nylon, PVDF is piezoelectric, meaning that an applied stress generates an electrical charge.
When carrying a 100-pound load—a typical amount for a solider’s pack—and walking at 2-3 mph, simulations showed that the straps could generate 45.6 mW of power. The researchers said that this power output could either be used to power small electronics, or be accumulated over the duration of an excursion to be used as a weightless supplemental energy source instead of carrying extra batteries.
“Some devices that could be powered include an LED headlamp (~38 mW), an Ipod Nano (~46mW), and a Motorola Razr cell phone, which in standby requires ~9 mW of continuous powering and ~360 mW during talk mode,” Sodano said. “In general, we want to accumulate the power before using it so that we could walk for 20 minutes then talk for 2.5 minutes. Or you could charge an LED headlamp while you walk in the day and use it at night while you camp. The energy could also go toward powering a handheld GPS system, which requires ~165-200 mW of continuous power.”
One of the biggest challenges in designing the straps was finding an extremely robust and durable electrode, since typical electrodes cannot tolerate the high levels of strain imposed by the straps. The researchers teamed up with a company in Blacksburg, Virginia called NanoSonic, Inc., that provided a self-assembled nanocomposite material called “Metal RubberTM” to tailor an advanced electrode. Using nanotechnology to control its macroscopic properties, the researchers fabricated a 100-nm-thick electrode that could undergo strains of 1000% while maintaining conductivity, and then return to its original shape when released.
The researchers hope that additional energy harvesting systems can be also be seamlessly integrated into a user’s normal gear, perhaps based on the piezoelectric backpack straps.
Citation: Granstrom, Jonathan, Feenstra, Joel, Sodano, Henry A., and Farinholt, Kevin. “Energy harvesting from a backpack instrumented with piezoelectric shoulder straps. Smart Materials and Structures. 16 (2007) 1810-1820.
Copyright 2007 PhysOrg.com.
All rights reserved. This material may not be published, broadcast, rewritten or redistributed in whole or part without the express written permission of PhysOrg.com.
Explore further: Translocating frogs to lakes where disease wiped out previous populations may be the key to recovery