Study finds wildfire hazards in residential fences and mulch beds

Study finds wildfire hazards in residential fences and mulch beds
Fences and mulch are common contributors to the spread of fires in wildland-urban interface (WUI) communities. This photo depicts flames that spread from a burning fence to a building about 1.8 meters (6 feet) away during the 2018 Camp Fire. Credit: CAL FIRE

When building fences and landscaping their properties, homeowners should keep fire safety on the top of their minds, especially if they live in a wildfire-prone region, according to a new study.

Across nearly 200 fire experiments, researchers at the National Institute of Standards and Technology (NIST) burned residential fences and mulch beds to examine the role they play in spreading fire. They found that was generally disproportionately higher when combustible objects burned together. Flames rushed along mulch lining the base of fences, and infernos quickly swallowed up pairs of fences when they burned in close proximity to each other. In contrast, stand-alone fences clear of mulch or debris burned at a much slower pace. Based on their findings, the authors of the report recommended that homeowners not place two fences back to back, keep other combustible surfaces far apart and take important other actions.

Wildfires can spread quickly through and potentially overwhelm communities adjacent to the wilderness—the so-called wildland-urban interface (WUI). Post-wildfire studies, including NIST's study of the 2018 Camp Fire, have pinpointed fences and mulch as culprits in spreading fire.

"Fences that catch fire were often completely gone. If you looked closely, you could see some nails and screws remaining. The ones we saw partially burned were left standing because they were defended by someone," said report co-author Alexander Maranghides, who is leading NIST's Camp Fire study. "These things don't put themselves out."

Fences and mulch can act as bridges for flames to reach buildings and as launch pads for airborne embers to ignite fires far away, but fire codes in the U.S. do not address how they should be installed and maintained, and little guidance exists to help homeowners.

To help build a technical foundation for the development of guidelines in the future, the authors of the new report sought to study and mulch fires under conditions that are closer to real life than what has been used in previous studies.

The research team burned fences, mulch beds, and combinations of both outdoors, igniting the materials several meters downwind from a wind machine used to simulate real fire-spreading conditions. Downwind of the fire, the team set up a shed or mulch bed as a target.

Through 187 experiments, they burned fuels alone and in combination, including fences of several common designs made of wood, vinyl or wood-plastic composites and mulch beds composed of shredded hardwood, pine bark nuggets, pine straw or rubber.

The researchers captured footage of the blazes to gauge the speed and pattern of flame spread and to record how often embers ignited the target shed. They also conducted research in the lab to measure how quickly samples of fence raw materials released heat.

Taking all the data together, the authors categorized the relative fire threat level for the various test conditions.

"In the highest hazard category, the fences and mulch are going to carry the fire along toward your house in a matter of a few minutes, not hours," said NIST physicist Kathryn Butler, co-lead author of the report.

Study finds wildfire hazards in residential fences and mulch beds
An experiment wherein NIST researchers burned two privacy fences separated by 46 centimeters (18 inches), sitting on top of mulch, demonstrates the danger of placing fences back to back. In less than four minutes after ignition, the fences were entirely engulfed in flames, which extended several feet beyond the fences. Credit: NIST

The most dangerous fires observed were those that had multiple sources of fuel burning at the same time. In the tests where lined the bottom of a fence, fire tended to swiftly advance across the beds of fine combustibles, which served as rich sources of embers and allowed flames to quickly ignite the fence along its entire length.

The researchers learned that the fires could get much worse as well.

When two fences made of combustible materials were placed back to back—mimicking the scenario where two neighbors each put up a fence along their property lines—the most intense flames of the entire project erupted. After the fire was established, long-reaching flames quickly shot up, completely engulfing fence panels 2.4 meters (8 feet) long and 1.8 meters (6 feet) tall in as little as four minutes. Embers sparked fires on the target in almost every one of these tests.

"It's very well known that when you confine a fire on the sides, it's bad news. Keeping those hot gases between the fences with surfaces radiating intense heat to each other leads to explosive fire behavior," Butler said.

When fence panels burned alone, it was a different story. Flames slowly chewed away at the fences and did not spread very far during these experiments, with some progressing less than a meter (3.3 feet) in an hour. Although these fires burning slowly on a sole fuel source were less hazardous and more manageable, that may accompany a wildfire could blow debris toward the fence, adding fuel to the fire.

Butler, NIST mechanical engineer Erik Johnsson and the rest of the authors crafted seven recommendations for homeowners living in WUI zones based on their analysis. The first recommendation is to avoid doubling up on fences completely, as the study found that fences as far apart as 91 centimeters (3 feet) still produced large . The second says that combustible fences should be placed where they will not interfere with exit routes.

Other recommendations advise keeping combustibles as far away from each other as possible, even between property lines, and clearing yards—and especially the space near or between fences—of debris, such as leaves or fallen branches.

The report also indicates that homeowners should replace combustible landscape features with those consisting of noncombustible material such as stone, steel or cement, when possible.

Because of the ever-present danger of embers during wildfires—even when there is a large distance between a structure and the fire—the researchers also urge homeowners to enhance their homes to resist ember ignition through a process called hardening. The detailed steps for hardening are described in a separate NIST report on mitigating wildfires.

The team members intend to keep pushing forward to cover new ground in wildfire research.

With additional experiments, they plan to offer additional insights on risk mitigation and eventually lay a groundwork for new guidance, standards and fire codes that could curb the real wildfire hazards that endanger life and property in the U.S.

The research was published as NIST Technical Note 2228.

More information: Kathryn Butler, Wind-Driven Fire Spread to a Structure from Fences and Mulch, NIST Technical Note 2228 (2022). DOI: 10.6028/NIST.TN.2228

Citation: Study finds wildfire hazards in residential fences and mulch beds (2022, August 11) retrieved 4 October 2023 from
This document is subject to copyright. Apart from any fair dealing for the purpose of private study or research, no part may be reproduced without the written permission. The content is provided for information purposes only.

Explore further

Study shows wildfire does not damage barbed wire


Feedback to editors