Webb's fully integrated 'heart' lowered into the chamber (w/ Video)

June 17, 2014 by Laura Betz
Webb's fully integrated 'heart' lowered into the chamber (w/ Video)

(Phys.org) —Engineer Jack Marshall held his breath. The "heart" of the James Webb Space Telescope hung from a cable 30 feet in the air as it was lowered slowly into the massive thermal vacuum chamber at NASA's Goddard Space Flight Center in Greenbelt, Maryland.

This "heart" of Webb is called the ISIM or Integrated Science Instrument Module, which along with its thermal vacuum test frame and supporting hardware, weighs about as much as an elephant. Within this test frame, ISIM sits inside a big-mirrored cube of cryo-panels and blankets. This process can be seen in a video by a Goddard videographer.

"This is the first time we are able to test the 'heart' in this configuration, which includes all four of Webb's science instruments installed on ISIM," said Marshall.

This major milestone was reached on schedule, but before the thermal can be put into use ISIM's cooling system must be checked out. This cooling system relies on using says team member Marc Sansebastian of NASA Goddard who is carefully checking for any leaks.

"Helium is a very hard gas to contain because it is such a small molecule," said Sansebastian.

This video shows as the James Webb Space Telescope's "heart" (formally the Integrated Science Instrument Module, or ISIM) exits a clean room and descends into a vacuum chamber at NASA's Goddard Space Flight Center in Greenbelt, Maryland. Credit: NASA's Goddard Space Flight Center

Once the Webb team is assured that all of the cooling lines are helium tight and all electrical connections have been completed and tested, a four-months long test on ISIM will begin by pumping out all of the air, and then dropping temperatures in the chamber, down to simulate the exceptionally cold temperatures in space.

Goddard's massive thermal vacuum chamber, called the Space Environment Simulator, uses eight vacuum pumps to achieve a vacuum and plumbing with nitrogen and cold gaseous helium to reduce the temperature inside a helium shroud to as low as -423.6 F (-253.15 C or 20 kelvins).

During this testing of ISIM, there are over 1,000 temperature sensors, almost 200 heater circuits, ten helium lines and a lot of thermal zones that need to be hooked up, says Calinda Yew, Webb test engineer for the .

"Now we are in the process of connecting all of those sensors and heaters. The sensors will help monitor temperatures during the test and the heaters will help achieve target temperatures. We will inject helium into a shroud to lower the science instruments temperatures even further," says Yew.

After four months of testing, the "heart" of Webb, ISIM, will return back to the world's largest clean room at Goddard for additional work and testing. Another thermal vacuum of ISIM is scheduled in 2015.

The James Webb Space Telescope is the successor to NASA's Hubble Space Telescope. It will be the most powerful ever built and will observe the most distant objects in the universe, provide images of the first galaxies formed, and see unexplored planets around distant stars. The Webb telescope is a joint project of NASA, the European Space Agency and the Canadian Space Agency.

Explore further: Image: NASA clean room gets a heart-full of Webb

Related Stories

Image: NASA clean room gets a heart-full of Webb

November 28, 2013

The James Webb Space Telescope's team welcomed back the "heart" of the observatory, known as the Integrated Science Instrument Module or ISIM, to the world's largest clean room at NASA's Goddard Space Flight Center in Greenbelt, ...

Thermal shield testing on Webb's MIRI

May 9, 2013

(Phys.org) —NASA engineer Acey Herrera recently checked out copper test wires inside the thermal shield of the Mid-Infrared Instrument, known as MIRI, that will fly aboard NASA's James Webb Space Telescope. The shield is ...

'Giant erector set' supports Webb Telescope test component

October 17, 2012

(Phys.org)—A new photograph taken inside the giant clean room at NASA's Goddard Space Flight Center in Greenbelt, Md., shows what looks like a giant Erector Set supporting a test component of the James Webb Space Telescope.

Scanning Webb's surrogate eye

July 6, 2012

(Phys.org) -- Engineer Erin Wilson adds aluminum tape to electrical cables to protect them from the cold during environmental testing of special optical equipment. These tests will verify the alignment of the actual flight ...

Recommended for you

NASA telescope studies quirky comet 45P

November 22, 2017

When comet 45P zipped past Earth early in 2017, researchers observing from NASA's Infrared Telescope Facility, or IRTF, in Hawai'i gave the long-time trekker a thorough astronomical checkup. The results help fill in crucial ...

Uncovering the origins of galaxies' halos

November 21, 2017

Using the Subaru Telescope atop Maunakea, researchers have identified 11 dwarf galaxies and two star-containing halos in the outer region of a large spiral galaxy 25 million light-years away from Earth. The findings, published ...

Cassini image mosaic: A farewell to Saturn

November 21, 2017

In a fitting farewell to the planet that had been its home for over 13 years, the Cassini spacecraft took one last, lingering look at Saturn and its splendid rings during the final leg of its journey and snapped a series ...

0 comments

Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.