Scientists construct complementary circuits from organic materials

March 1, 2007
Scientists construct complementary circuits from organic materials
The circuit diagram and the photograph of a complementary inverter made of one p and one n channel thin film transistor (TFT), i.e. a transistor with either a p or n conductive semiconductor layer. A complementary circuit like this saves energy because in each of the two logical states - either high input energy and low output voltage or the contrary - one or other of the two transistors (p or n) blocks the current flow. This energy saving is an important advantage of complementary circuits as compared to unipolar circuits, which consist of only p channel transistors or n channel transistors. Image: Max Planck Institute for Solid State Research

A flat screen that can be rolled up and put into a jacket pocket - organic transistors with low energy consumption could make this possible. Scientists at the Max Planck Institute for Solid State Research in Stuttgart and at the Universities of Stuttgart and Erlangen have constructed complementary circuits from organic transistors characterised by low supply voltages and low consumption values. These energy-saving electronic components consist of two different transistor types.

The new organic electronic components can be operated with significantly lower voltages than previous organic circuits - voltages, such as those supplied by normal household batteries from 1.5 to 3 volts (Nature, February 2007).

Transistors made from organic materials have an advantage over normal silicon transistors. They can be constructed on flexible surfaces, such as plastic film, making organic circuits ideal for portable and mobile devices. However, until now, organic transistors have also had a big disadvantage: they consumed too much energy. Scientists have now constructed energy-saving organic circuits.

To this purpose, they make use of two principles: on the one hand, they use self-organising organic monolayers as the insulator for the transistor. Certain organic compounds deposit themselves under specific conditions on a substrate with an active surface. The coating consists of a layer of organic molecules less than 3 nm thick. This monolayer lowers the operating voltage of the transistor as this is directly dependent on the thickness of the insulator. On the other hand, the scientists linked p channel transistors and n channel transistors in complementary circuits. Up to now, organic circuits have mostly been realised in the form of unipolar circuits, which consist of transistors of just one type only (either p channel or n channel). In this kind of unipolar circuit, there is a constant undesirable cross-current, whereas with the complementary construction, one of the two transistors blocks the flow of the current - an opportunity to save energy. According to Dr. Hagen Klauk of the Max Planck Institute for Solid State Research, "Complementary circuits have been standard in silicon technology for 25 years. We believe that organic electronics can also benefit from the advantages of complementary circuit technology. And by combining it with self-organising monolayers, we could lower the supply voltage to that of small batteries."

The scientists thus created organic field effect transistors on a glass substrate. A field effect transistor has three circuit points - gate, source and drain. Irrespective of the voltage at the gate, a current flows from the source to the drain electrode through the charge carrier formed in the semiconductor. The scientists use the air-stable organic compounds: pentacene; and hexadecafluoro copper phthalocyanine. Between the gate and the semi-conductor layer there is an insulator, in this case a very thin self-organising monolayer. Aluminium is used for the gate electrode. Applying aluminium in a defined pattern to the glass substrate makes possible the construction of complementary circuits.

The researchers made different electronic circuits, including complementary inverters, NAND gates and ring oscillators. Of particular importance: the materials used allowed them to make the transistors and circuits at temperatures up to 90 degrees Celsius. A relatively low temperature is necessary for electronic components to allow a change to flexible and transparent plastic substrates. The scientists demonstrated that their method was also suitable for this purpose: they built these transistors on PEN, polyethylene naphthalate. Hagen Klauk explains why that was an advantage: "Silicon transistors need a substrate that is resistant to the high temperatures created in the manufacture of the transistors. In contrast, organic transistors can be created at temperatures less than 100 degrees Celsius - plastics can therefore be used as the substrate. These are flexible and nevertheless robust." Organic complementary circuits can consequently be used everywhere where products need to be simultaneously robust and mobile, for example in a portable, battery-powered flat screen.

Citation: Hagen Klauk, Ute Zschieschang, Jens Pflaum, Marcus Halik, Ultralow-power organic complementary circuits, Nature, 15 February 2007

Source: Max Planck Institute for Solid State Research

Explore further: Researchers report advances in stretchable semiconductors, integrated electronics

Related Stories

Engineers produce smallest 3-D transistor yet

December 10, 2018

Researchers from MIT and the University of Colorado have fabricated a 3-D transistor that's less than half the size of today's smallest commercial models. To do so, they developed a novel microfabrication technique that modifies ...

The splendid generative potential of the Sierpinski triangle

December 14, 2018

One transistor can become an oscillator with a surprising richness of behavior. However, even more interesting effects emerge if the structure of connections is fractal and shows some imperfections. Could similar rules explain ...

Recommended for you

ATLAS experiment observes light scattering off light

March 20, 2019

Light-by-light scattering is a very rare phenomenon in which two photons interact, producing another pair of photons. This process was among the earliest predictions of quantum electrodynamics (QED), the quantum theory of ...

How heavy elements come about in the universe

March 19, 2019

Heavy elements are produced during stellar explosion or on the surfaces of neutron stars through the capture of hydrogen nuclei (protons). This occurs at extremely high temperatures, but at relatively low energies. An international ...

Trembling aspen leaves could save future Mars rovers

March 18, 2019

Researchers at the University of Warwick have been inspired by the unique movement of trembling aspen leaves, to devise an energy harvesting mechanism that could power weather sensors in hostile environments and could even ...

Quantum sensing method measures minuscule magnetic fields

March 15, 2019

A new way of measuring atomic-scale magnetic fields with great precision, not only up and down but sideways as well, has been developed by researchers at MIT. The new tool could be useful in applications as diverse as mapping ...

0 comments

Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.