Printable luminous particles enable cost-effective, large and curved luminous surfaces

Researchers at the INM – Leibniz Institute for New Materials have now developed a new method that enables electroluminescence on large, curved surfaces in a cost-effective way: in this case, the light-emitting layer and all other components are produced by means of wet-chemical, printable methods.

Light-emitting diodes (LEDs) are the modern lighting devices used in lamps, signals, signs or displays. By contrast, organic semiconducting -emitting materials (OLEDs) can be incorporated in thin layers and used on curved surfaces. However, OLEDs for large-area illumination are cost-intensive at present owing to their low efficiency and short lifetime.

One promising alternative for modern lighting is . Special , so-called phosphors, are excited in an electric field to emit light. Researchers at the INM – Leibniz Institute for New Materials have now developed a new method that enables electroluminescence on large, in a cost-effective way: in this case, the light-emitting layer and all other components are produced by means of wet-chemical, printable methods.

From 28 to 30 January, the researchers from the INM will present this result and further results in the German Pavilion at nano tech 2015 in Tokyo, Japan.

"For processing we only need temperatures below 200 degrees Celsius. This means that we can apply all the required partial layers even to films or other flexible substrates," explains Peter William de Oliveira, head of the program division Optical Materials. Hence, "luminous surfaces" could be produced very cost-effectively and even in large formats.

The luminous unit consists of two electrically conductive layers, between which the light-emitting particles are sandwiched in a dielectric binder layer. At least one of the conductive layers is also transparent. Due to the insulating layer, the absorbed energy is efficiently converted into light and appreciable heating is avoided. On application of an AC voltage, light is emitted from the electroluminescent layer. "We embed luminous particles in the form of functionalized zinc sulphide nanoparticles as phosphors into the binder layer," explains de Oliveira "these are doped with copper or manganese. At present this allows the generation of green and blue-green light."

The electroluminescent light sheets developed at the INM can be directly connected to the customary mains voltage of 230 volts. Rectifiers, ballast capacitors or other switching units that first adapt the voltage can be omitted.

The researchers are currently working on further functionalization of the phosphor nanoparticles. "Our goal is to generate white light by means of an altered doping or by introducing coloured pigments into the luminous ," says physicist de Oliveira. At the same time the developers want to alter the materials in such a way that the light sheets can be used even at a lower mains voltage.

Citation: Printable luminous particles enable cost-effective, large and curved luminous surfaces (2015, January 21) retrieved 22 September 2024 from https://phys.org/news/2015-01-printable-luminous-particles-enable-cost-effective.html
This document is subject to copyright. Apart from any fair dealing for the purpose of private study or research, no part may be reproduced without the written permission. The content is provided for information purposes only.

Explore further

New conductive coatings for flexible touchscreens

8 shares

Feedback to editors