Watching an electron being born

Atomic processes take place on extremely short time scales. Measurements at the Vienna University of Technology (TU Vienna) can now visualize these processes.

A strong laser beam can remove an electron from an atom – a process which takes place almost instantly. At the Vienna University of Technology, this phenomenon could now be studied with a time resolution of less than ten attoseconds (ten billionths of a billionth of a second). Scientists succeeded in watching an atom being ionized and a free electron being “born”.  These measurements yield valuable information about the electrons in the atom, which up until now  hasn't been experimentally accessible, such as the time evolution of the electron’s quantum phase – the beat to which the quantum waves oscillate.

Wave-like Quantum Interference

In the experiment, short laser pulses are fired at atoms. Each laser pulse can be described as a light wave - the wave sweeps over the atom, and therefore, the electric field around the atom changes. The electric field rips an electron away from the atom – but the precise moment at which this happens cannot be defined. “The electron is not removed from the atom at one point in time during the interaction with the laser pulse. There is a superposition of several processes, as it is often the case in quantum mechanics”, says Markus Kitzler from the Photonics Institute at TU Vienna. One single electron leaves the atom at different points in time, and these processes combine, much like waves on a water surface, combining to a complex wave pattern.

“These quantum mechanical wave-interferences give us information about the initial quantum state of the electron during the ionization process”, says Professor Joachim Burgdörfer (Institute for Theoretical Physics, TU Vienna), whose research team closely collaborated with the experimentalists at the Photonics Institute.

It’s All About the Phase

Like waves, quantum particles in this experiment can interfere constructively or destructively. The wave cycle of the electrons is extremely short, the quantum phase changes rapidly. “Usually, this quantum phase can hardly be measured”, says Markus Kitzler. Combining high precision measurements and elaborate theoretical calculations, information about the electron’s quantum phase  can now be obtained.

An important tool for these measurements was a very special laser beam, containing two different wavelengths. The laser pulse interacting with the atom could be tailored very precisely. Using these pulses, the scientists could measure the quantum phase which the electron had inside the atom (with respect to the beat defined by the laser light) before it was removed by the laser. “This quantum phase that we can measure now, also tells us about the electron’s energy states inside the atom, and about the precise position at which the ionization took place”, says Markus Kitzler. To do that, the scientists had to measure the quantum phase with an incredible precision of less than ten attoseconds.

Ultrashort timescales – far away from everyday experience

The time span of ten attoseconds (10*10^(-18) seconds) is so short that any comparison to everyday timescales fails. The ratio of ten years to a second is 300 million to one. Dividing a second by the same factor takes us to the incredibly short time scale of three nanoseconds – in this period, light travels one meter. This is the time scale of microelectronics. Again dividing this tiny period of time by a factor of 300 million, we arrive at about ten attoseconds. This, is the timescale of atomic processes. It is the order of magnitude of an electron’s period orbiting the nucleus. In order to measure or to influence these processes, scientists have been striving to access these timescales for years.