July 5, 2022

This article has been reviewed according to Science X's editorial process and policies. Editors have highlighted the following attributes while ensuring the content's credibility:

How land deformation occurs when fault sections creep

Strike-slip faults like the San Andreas have sections of locked movement and sections of slow and steady creep. Researchers now have physically modeled what happens to the land around faults with different types of movement. Credit: John Wiley/Wikimedia, CC BY 3.0
× close
Strike-slip faults like the San Andreas have sections of locked movement and sections of slow and steady creep. Researchers now have physically modeled what happens to the land around faults with different types of movement. Credit: John Wiley/Wikimedia, CC BY 3.0

Strike-slip faults can be fickle about their movement—they can move slow and steady or remain stationary until their built-up stress is let loose in one go. But how do these faults' movements change from a locked and sudden release to a steady creep? And how does this change affect the rocks around the fault? Understanding where these deformation styles occur and the variables that contribute to the kind of movement is important in determining earthquake hazards.

To uncover what happens near a change in slip, Ross et al. created a to isolate slip behavior along a strike-slip structure. They used deforming silicone as an analog for Earth's crust, which allowed them to disregard other variables that can influence slip types, including lithology differences, deformation history, and fault geometry.

One side of the experiment remained stationary while the other side moved, and along that boundary between the two sides, one portion was stuck to itself, or locked, while another was cut to simulate creeping. Colored sand grains were sprinkled on the surface to track motions. Top-down time-lapse photography captured 2D deformation, whereas 3D deformation was tracked with photogrammetry.

They found that contraction develops where the creeping portion of the fault runs into the locked section of the fault. Simultaneously, extension occurs on the opposite side of the fault as the creeping section pulls away from the locked section. This pattern repeats in secondary locations, creating an alternating pattern of extension and contraction. These have opposite vertical motions, creating topographic highs and lows.

When the researchers compared their model to field data on the San Andreas Fault in central California, they found that both model and showed a pattern of alternating extension and contraction across the creeping fault sections. According to the authors, this work shows that a change in slip behavior can lead to off-fault deformation and could explain some of the patterns seen along the San Andreas Fault.

More information: Emily O. Ross et al, Relating Slip Behavior to Off‐Fault Deformation Using Physical Models, Geophysical Research Letters (2022). DOI: 10.1029/2021GL096784

Journal information: Geophysical Research Letters

Load comments (0)