Superconducting nanowire memory cell, miniaturized technology

June 13, 2017
Superconducting nanoscale memory device. The binary information is encoded in the direction of the electrical current in the loop. When the current flows clockwise, this is considered a '0' state of the memory device. When it flows counter clockwise, this is a '1' state of the memory device. Because the electrons are superconducting, the current flows indefinitely in the loops, making the memory nonvolatile. (a) A photograph of the memory device, consisting of a superconducting strip of Mo75Ge25 (yellow) with a pair of superconducting nanowires forming a closed loop (also yellow): The width of the nanowires is 24 nm and 22 nm, as marked. (b) The critical current, i.e., the maximum current which can be injected into the device without destroying superconductivity, is plotted as a function of magnetic field. To set the memory state '0', we apply positive current targeting the shaded diamond. To set the memory to the state '1', a negative current is applied (as the same external magnetic field). To read out the memory state, the current is ramped to a higher value, as shown by the red rhombus, and the current value at which voltage occurs is measured. Such value is the critical current. Its statistical distribution is shown in (c). The measured value of the critical current depends on the pre-set memory value, '0' or '1'. Thus by measuring the critical current we are able to determine the state of the memory cell. Credit: . Alexey Bezryadin and Andrew Murphey, University of Illinois at Urbana-Champaign

Developing a superconducting computer that would perform computations at high speed without heat dissipation has been the goal of several research and development initiatives since the 1950s. Such a computer would require a fraction of the energy current supercomputers consume, and would be many times faster and more powerful. Despite promising advances in this direction over the last 65 years, substantial obstacles remain, including in developing miniaturized low-dissipation memory.

Researchers at the University of Illinois at Urbana-Champaign have developed a new nanoscale cell that holds tremendous promise for successful integration with superconducting processors. The new technology, created by Professor of Physics Alexey Bezryadin and graduate student Andrew Murphy, in collaboration with Dmitri Averin, a professor of theoretical physics at State University of New York at Stony Brook, provides stable memory at a smaller size than other proposed memory devices.

The device comprises two superconducting nanowires, attached to two unevenly spaced electrodes that were "written" using electron-beam lithography. The nanowires and electrodes form an asymmetric, closed superconducting loop, called a nanowire 'SQUID' (superconducting quantum interference device). The direction of current flowing through the loop, either clockwise or counterclockwise, equates to the "0" or "1" of binary code.

The memory state is written by applying an oscillating current of a particular magnitude, at a specific magnetic field. To read the memory state the scientists ramp up the current and detect the current value at which superconductivity gets destroyed. It turns out that such destruction or critical current is different for the two memory states, "0" or "1". The scientists tested memory stability, delaying reading of the state, and found no instances of memory loss. The team performed these experiments on two nanowire SQUIDS, made of the superconductor Mo75Ge25, using a method called molecular templating. The results are published in the June 13, 2017 New Journal of Physics.

Bezryadin comments, "This is very exciting. Such superconducting memory cells can be scaled down in size to the range of few tens of nanometers, and are not subject to the same performance issues as other proposed solutions."

Murphy adds, "Other efforts to create a scaled-down superconducting memory cell weren't able to reach the scale we have. A superconducting memory device needs to be cheaper to manufacture than standard memory now, and it needs to be dense, small, and fast."

Up to now, the most promising supercomputing memory devices, called 'single-flux quanta' devices, rely on manipulating circuits composed of Josephson junctions and inductive elements. These are in the micrometer range, and miniaturization of these devices is limited by the size of the Josephson junctions and their geometric inductances. Some of these also require ferromagnetic barriers to encode information, where Bezryadin and Murphy's device does not require any ferromagnetic components and eliminates magnetic-field cross-talk.

"Because the kinetic inductance increases with decreasing cross-sectional dimensions of the wire, nanowire SQUID memory elements could be reduced further, into the range of tens of nanometers," Bezryadin continues.

The researchers argue that this device can operate with a very low dissipation of energy, if the energies of two binary states are equal or near equal. The theoretical model for such operations was developed in collaboration with Averin The switching between the states of equal energy will be achieved either by quantum tunneling or by adiabatic processes composed of multiple jumps between the states.

In future work, Bezryadin plans to address the measurements of the switching time and to study larger arrays of the nanowire squids in functioning as arrays of memory elements. They will also test superconductors with higher critical temperatures, with the goal of a memory circuit that would operate at 4 Kelvin. Rapid operations will be achieved by utilizing microwave pulses.

Explore further: Scientists develop a control system for rapid superconducting memory cells

More information: Andrew Murphy et al. Nanoscale superconducting memory based on the kinetic inductance of asymmetric nanowire loops, New Journal of Physics (2017). DOI: 10.1088/1367-2630/aa7331

Related Stories

A New Approach to Superconducting Memory

November 6, 2006

Despite the potential of superconductor-based electronics to significantly impact the electronics industry – for example, a superconducting computer chip is a thousand times faster than the one within the laptop I'm using ...

Hybrid memory device for superconducting computing

January 26, 2015

A team of NIST scientists has devised and demonstrated a novel nanoscale memory technology for superconducting computing that could hasten the advent of an urgently awaited, low-energy alternative to power-hungry conventional ...

Recommended for you

Magnetic nanoknots evoke Lord Kelvin's vortex theory of atoms

June 23, 2017

(β€”In the late 1800s when scientists were still trying to figure out what exactly atoms are, one of the leading theories, proposed by Lord Kelvin, was that atoms are knots of swirling vortices in the aether. Although ...

Making ferromagnets stronger by adding non-magnetic elements

June 23, 2017

Researchers at the U.S. Department of Energy's Ames Laboratory discovered that they could functionalize magnetic materials through a thoroughly unlikely method, by adding amounts of the virtually non-magnetic element scandium ...


Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.