Containing our 'electromagnetic pollution': MXene can protect mobile devices from electromagnetic interference

September 8, 2016
Drexel University researchers have demonstrated that MXene can be a highly effective, light weight, low volume shield to protect electronics devices from electromagnetic interference. Credit: Drexel University

If you've ever heard your engine rev through your radio while listening to an AM station in your car, or had your television make a buzzing sound when your cell phone is near it, then you've experienced electromagnetic interference. This phenomenon, caused by radio waves, can originate from anything that creates, carries or uses an electric current, including television and internet cables, and, of course cell phones and computers. A group of researchers at Drexel University and the Korea Institute of Science & Technology is working on cleaning up this electromagnetic pollution by containing the emissions with a thin coating of a nanomaterial called MXene.

Electromagnetic radiation is everywhere—that's been the case since the beginning of the universe. But the proliferation of electronics in recent decades has contributed both to the volume of radiation generated on our planet and its noticeability.

"As technology evolves and electronics become lighter, faster and smaller, their electromagnetic interference increases dramatically," said Babak Anasori, PhD, a research assistant professor in the A.J. Drexel Nanomaterials Institute, and a co-author of the paper "Electromagnetic Interference Shielding with 2D Transition Metal Carbides (MXenes)," which was recently published in the journal Science. "Internal electromagnetic noise coming from different electronic parts can have a serious effect on everyday devices such as cell phones, tablets and laptops, leading to malfunctions and overall degradation of the device."

These effects range from temporary monitor "fuzziness," strange buzzing from a Bluetooth device, to a slow in processing speed of a mobile device. Shielding against electromagnetic interference typically includes encasing the interior of devices with a shroud or cage of a conductive metal like copper or aluminum, or a coating of metallic ink. And while this is effective, it also adds weight to the device and is considered a restriction on how small the device can be designed.

"In general, adequate shielding can be achieved by using thick metals, however, material consumption and weight leave them at a disadvantage for use in aerospace and telecommunication applications," Anasori said. "Therefore, it is of great importance to achieve better protection with thinner films."

Researchers at Drexel University have developed a nanomaterial, called MXene, that could potentially be used in electronics devices to block out and insulate electromagnetic waves. Credit: Drexel University

Their findings suggest that a few-atoms thin titanium carbide, one of about 20 two-dimensional materials in the MXene family discovered by Drexel University scientists, can be more effective at blocking and containing electromagnetic interference, with the added benefit of being extremely thin and easily applied in a coating just by spraying it onto any surface—like paint.

"With technology advancing so fast, we expect smart devices to have more capabilities and become smaller every day. This means packing more electronic parts in one device and more devices surrounding us," said Yury Gogotsi, PhD, Distinguished University and Trustee Chair professor in the College of Engineering and Director of the A.J. Nanomaterials Institute who proposed the idea and led this research. "To have all these electronic components working without interfering with each other, we need shields that are thin, light and easy to apply to devices of different shapes and sizes. We believe MXenes are going to be the next generation of shielding materials for portable, flexible and wearable electronics."

Researchers tested samples of MXene films ranging in thickness from just a couple micrometers (one-thousandth of a millimeter) up to 45 micrometers, which is slightly thinner than a human hair. This is significant because a material's shielding effectiveness, a measure of a material's ability to block electromagnetic radiation from passing through it, tends to increase with its thickness, and for purposes of this research the team was trying to identify the thinnest iteration of a shielding material that could still effectively block the radiation.

What they found is that the thinnest film of MXene is competing with copper and aluminum foils when it comes to shielding effectiveness. And by increasing thickness of the MXene to 8 micrometers, they could achieve 99.9999 percent blockage of radiation with frequencies covering the range from cell phones to radars.

In comparison to other synthetic materials, such as graphene or carbon fibers, the thin sample of MXene performed much better. In fact, to achieve commercial electromagnetic shielding requirements, currently used carbon-polymer composites would have to be more than one millimeter thick, which would add quite a bit of heft to a device like an iPhone, that is just seven millimeters thick.

MXene is versatile enough to be combined with a polymer solution to make a thin spray coating for electronics components that would serve as a shield from electromagnetic interference. Credit: Drexel University

The key to MXene's performance lies in its high electrical conductivity and two-dimensional structure. According to the authors, when electromagnetic waves come in contact with MXene, some are immediately reflected from its surface, while others pass through the surface but they lose energy amidst the material's atomically thin layers. The lower energy electromagnetic waves are eventually reflected back and forth off the internal layers until they're completely absorbed in the structure.

One other result, that already portends MXene's usefulness in protecting wearable devices, is that its shielding effectiveness is just as stout when it is combined with a polymer to make a composite coating. And, on weight basis, it even outperforms pure copper.

"This finding is significant since several commercial requirements for an shield product are engrained in a single material," Gogotsi said. "MXene displays many of these characteristics, including high shielding effectiveness, low density, small thickness, high flexibility and simple processing. So it is an excellent candidate for use in numerous applications."

This technological development resulted from a fundamental study of MXene properties, which was funded by the National Science Foundation. The next step for the research team will be to find support for a broader study on other MXenes, selecting the best shielding material and testing it in devices.

Explore further: Bending—but not breaking—in search of new materials

More information: "Electromagnetic interference shielding with 2D transition metal carbides (MXenes)" Science, science.sciencemag.org/cgi/doi … 1126/science.aag2421

Related Stories

Bending—but not breaking—in search of new materials

November 11, 2014

Making a paper airplane in school used to mean trouble. Today it signals a promising discovery in materials science research that could help next-generation technology -like wearable energy storage devices- get off the ground. ...

A graphene solution for microwave interference

March 23, 2015

Microwave communication is ubiquitous in the modern world, with electromagnetic waves in the tens of gigahertz range providing efficient transmission with wide bandwidth for data links between Earth-orbiting satellites and ...

Shaping the future of energy storage with conductive clay

November 26, 2014

In the race to find materials of ever increasing thinness, surface area and conductivity to make better performing battery electrodes, a lump of clay might have just taken the lead. Materials scientists from Drexel University's ...

Recommended for you

Researchers discover new way to power electrical devices

December 11, 2017

A team of University of Alberta engineers developed a new way to produce electrical power that can charge handheld devices or sensors that monitor anything from pipelines to medical implants.The discovery sets a new world ...

1 comment

Adjust slider to filter visible comments by rank

Display comments: newest first

pntaylor
5 / 5 (1) Sep 09, 2016
"If you've ever heard your engine rev through your radio while listening to an AM station in your car, or had your television make a buzzing sound when your cell phone is near it, then you've experienced electromagnetic interference."

The author is showing his age. You need to have, or had, a car or television, from the 80s, to have had this experience. Most folks reading articles here have no understanding of this phenomenon.

Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.