New surface chemistry may extend life of technology for making transistors

September 28, 2004

Researchers at the University of Illinois at Urbana-Champaign have developed a technique that uses surface chemistry to make tinier and more effective p-n junctions in silicon-based semiconductors. The method could permit the semiconductor industry to significantly extend the life of current ion-implantation technology for making transistors, thereby avoiding the implementation of difficult and costly alternatives.
To make faster silicon-based transistors, scientists much shrink the active region in p-n junctions while increasing the concentration of electrically active dopant. Currently about 25 nanometers thick, these active regions must decrease to about 10 nanometers, or roughly 40 atoms deep, for next-generation devices.

The conventional process, ion implantation, shoots dopant atoms into a silicon wafer in much the same way that a shotgun sends pellets into a target. To be useful, dopant atoms must lie close to the surface and replace silicon atoms in the crystal structure. In the atomic-scale chaos that accompanies implantation, however, many dopant atoms and silicon atoms end up as interstitials – lodged awkwardly between atoms in the crystal.

Ion implantation also creates defects that damage the crystal in a way that degrades its electrical properties. Heating the wafer – a process called annealing – heals some of the defects and allows more dopant atoms to move into useful crystalline sites. But annealing also has the nasty effect of further diffusing the dopant and deepening the p-n junction.

“We developed a way of using surface chemistry to obtain shallower active regions and enhanced dopant activation simultaneously,” said Edmund Seebauer, a professor of chemical and biomolecular engineering at Illinois. “By modifying the ability of the silicon surface to absorb atoms from the substrate, our technique can control and correct the defects induced during implantation.”

Inside the active region, atoms sitting on lattice sites have bonds to four neighbors, which saturates the bonding capacity of the silicon atoms. Atoms sitting on the surface have fewer neighbors, leading to unused, or “dangling” bonds. Atoms of a gas such as hydrogen, oxygen or nitrogen can saturate the dangling bonds.

“These dangling bonds can also react with interstitial atoms, and remove them from the crystal,” Seebauer said. “The process selectively pulls silicon interstitials to the surface, while leaving active dopant atoms in place. The preferential removal of silicon interstitials is exactly what is needed to both suppress dopant diffusion and increase dopant activation.”

Seebauer and his colleagues – chemical and biomolecular engineering professor Richard Braatz and graduate research assistants Kapil Dev and Charlotte Kwok – use ammonia and other nitrogen-containing gases to saturate some of the dangling bonds and control the ability of the surface to remove interstitials.

“The amount of surface nitrogen compound formed, and therefore the number of dangling bonds that become saturated, can be varied by changing the type of gas and the degree of exposure,” Seebauer said. “As an added benefit, nitrogen compounds are also quite compatible with conventional chip manufacturing processes.”

Through computer simulations and experimental verification, the researchers have shown that “defect engineering” by means of surface chemistry can extend the life of current ion-implantation technology and create smaller, faster electronic devices. Seebauer will present the team’s latest findings at the 51st International Symposium of the AVS Science and Technology Society, to be held Nov. 14-19 in Anaheim, Calif.

Funding was provided by International SEMATECH and the National Science Foundation. The researchers have applied for a patent.

Source: University of Illinois at Urbana-Champaign

Explore further: Physicists explain metallic conductivity of thin carbon nanotube films

Related Stories

Deep-depletion: A new concept for MOSFETs

October 26, 2017

Silicon has provided enormous benefits to the power electronics industry. But performance of silicon-based power electronics is nearing maximum capacity.

Engineers chart semiconductors on the scale of atoms

August 1, 2005

Spanning fewer than a thousand atoms, the electronic devices on semiconductor chips have become so miniscule they defy most efforts to characterize them. Now for the first time, engineers have demonstrated a way to image ...

Recommended for you

How the Earth stops high-energy neutrinos in their tracks

November 22, 2017

Neutrinos are abundant subatomic particles that are famous for passing through anything and everything, only very rarely interacting with matter. About 100 trillion neutrinos pass through your body every second. Now, scientists ...

Mysterious deep-Earth seismic signature explained

November 22, 2017

New research on oxygen and iron chemistry under the extreme conditions found deep inside the Earth could explain a longstanding seismic mystery called ultralow velocity zones. Published in Nature, the findings could have ...

Quantum internet goes hybrid

November 22, 2017

In a recent study published in Nature, ICFO researchers led by ICREA Prof. Hugues de Riedmatten report an elementary "hybrid" quantum network link and demonstrate photonic quantum communication between two distinct quantum ...

Lightning, with a chance of antimatter

November 22, 2017

A storm system approaches: the sky darkens, and the low rumble of thunder echoes from the horizon. Then without warning... Flash! Crash!—lightning has struck.

0 comments

Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.