World's First 10Gbps Quantum Dot Laser

Sep 09, 2004

Fujitsu Limited and a research group at the University of Tokyo led by Professor Yasuhiko Arakawa, today announced the joint development of a quantum dot laser that succeeds in minimizing temperature-sensitive output fluctuations, which was not possible with semiconductor lasers in the past. The newly developed quantum dot laser achieves high-speed operation of 10 gigabits per second (Gbps) across a temperature range of 20°C to 70°C without electrical current adjustments, and has minimal output fluctuations caused by changes in temperature. This breakthrough technology will pave the way for compact, low-cost, and low power-consumption optical transmitters targeting optical metro-access systems and high-speed optical LAN for which further development continues.

Research for this technology was conducted as part of a project supported by the IT program "The Focused Research and Development Program for the Realization of the World's Most Advanced IT Nation" of Japan's Ministry of Education, Culture, Sports, Science and Technology (MEXT), and by a project commissioned to the Optoelectronic Industry and Technology Development Associations (OITDA) by the New Energy and Industrial Technology Development Organization (NEDO) of Japan.

Details of the new technology were presented as a post-deadline paper at the European Conference and Exhibition on Optical Communication 2004 (ECOC 2004) that was held in Stockholm from September 5 to September 9.

Background
In order to achieve smaller size, lower power consumption, and lower cost, semiconductor lasers used as optical transmitters in metro access optical networks and high-speed optical LANs, there is a need for the lasers to operate at high speeds even at high temperatures without a cooler. Currently, by using strained quantum-wells in the light-emitting area of lasers, semiconductor lasers known as strained quantum-well lasers, which operate at high-speeds of 10Gbps and temperatures up to 85°C, are being commercialized for optical networks.

Technological Challenges
Due to the fact that the optical output of strained quantum-well lasers is sensitive to changes in ambient temperature, it is necessary for driving current to be adjusted accordingly to ambient temperatures. As such, peripheral circuits are required, thereby hampering reductions of size, cost, and power consumption that are needed for optical metro-access systems and high-speed optical LANs.

Newly Developed Technology
The new semiconductor laser features extremely minimal characteristic changes that are due to temperature fluctuations, and uses 3-dimensional nano-structured quantum dots in the light-emitting area (Figure 1). Professor Yasuhiko Arakawa of the University of Tokyo theorized in 1982 that the operation of quantum dot lasers does not rely on temperature, but such temperature-independent operation had only been realized at low temperatures thus far.

By increasing optical gain through multi-layering quantum dots into 10 layers, raising the density of each layer, p-doping (inserting a p-type impurity in close proximity to the quantum dots), and by using a laser structure that features low parasitic capacitance for optimized high-speed modulation, the new technology successfully achieves high-speed operation of lasers with temperature-independent output at temperatures exceeding room temperature.

Results
The newly developed quantum dot laser realized high-speed operation of 10Gbps at wavelengths of 1.3 micrometers which are used for optical transmission systems, for a temperature range from 20°C to 70°C without drive current adjustments. The achieved 10Gpbs high-speed operation is the world's fastest for a quantum dot laser for use in optical telecommunication systems.

Optical output characteristics of the new quantum dot laser were measured and recorded in increments of 10°C. The optical output characteristics were nearly stable independent of temperature, for a 20°C to 50°C range. Even for temperatures exceeding 50°C, efficiency (slope of the characteristics curve) was constant, with minimal variances up to 70°C (Figure 2, left-side table). In comparison to the performance of conventional strained quantum-well lasers of the past, the new quantum dot laser achieves significantly higher stability of temperature (Figure 2, right-side table).

10Gbps modulation waveforms of the new quantum dot laser at 20°C and 70°C without constant drive current were verified (Figure 3, upper section). Although the current used for the laser was the same at both temperatures, a distinct light output diagram is achieved with the extinction ratio of 7 decibels (7dB). Waveforms for a strained quantum-well laser under the same conditions showed output degradation and pattern disfigurement, with indistinct waveforms (Figure 3, lower section).

Average optical output variances measured for 10Gbps modulation operation across various temperatures depicted that for strained quantum-well lasers, the average optical output dropped significantly at higher temperatures, while the average light output variance for the new quantum dot laser was less than 5% and minimal.

The results achieved with the newly developed quantum dot laser will enable major simplification of circuits to drive lasers, thereby paving the way for optical transmitters that are compact, low-cost, and low power-consuming, for future optical metro-access systems and high-speed optical LANs.

Future Developments
Fujitsu and the University of Tokyo will continue development to extend the temperature range for adjustment-free operation and to achieve single-mode lasing, targeting practical commercial application of this technology by 2007.

Explore further: Nano-forests to reveal secrets of cells

add to favorites email to friend print save as pdf

Related Stories

Breakthrough in light sources for new quantum technology

Aug 29, 2014

One of the most promising technologies for future quantum circuits are photonic circuits, i.e. circuits based on light (photons) instead of electrons (electronic circuits). First, it is necessary to create ...

Laser makes microscopes way cooler

Aug 15, 2014

(Phys.org) —Laser physicists have found a way to make atomic-force microscope probes 20 times more sensitive and capable of detecting forces as small as the weight of an individual virus.

Optalysys will launch prototype optical processor

Aug 09, 2014

UK-based startup Optalysys is moving ahead to deliver exascale levels of processing power on a standard-sized desktop computer within the next few years, reported HPCwire earlier this week. The company itself ...

Recommended for you

Lab unveil new nano-sized synthetic scaffolding technique

4 hours ago

Scientists, including University of Oregon chemist Geraldine Richmond, have tapped oil and water to create scaffolds of self-assembling, synthetic proteins called peptoid nanosheets that mimic complex biological ...

Nano-forests to reveal secrets of cells

10 hours ago

Vertical nanowires could be used for detailed studies of what happens on the surface of cells. The findings are important for pharmaceuticals research, among other applications. A group of researchers from ...

A single molecule device for mobile phones

12 hours ago

Researchers from the Delft University of Technology, Groningen University and the FOM Foundation have designed a single molecule which can act as a useful building block in nanometer-size circuits. They found ...

Intricate algae produce low-cost biosensors

Sep 01, 2014

(Phys.org) —Oregon State University researchers are combining diatoms, a type of single-celled photosynthetic algae, with nanoparticles to create a sensor capable of detecting miniscule amounts of protein or other biomarkers.

User comments : 0