Novel ion exchange membrane improves performance of vanadium redox flow batteries

Novel ion exchange membrane improves performance of vanadium redox flow batteries
The structure and morphology of WO3@GO nanohybrid. Credit: SIAT

The vanadium redox flow battery (VRFB) is a promising sustainable energy storage system. In a VRFB cell, an ion exchange membrane (IEM) is used to prevent formation of a cathode/anode short circuit and avoid electrolyte crossover and side reactions, while allowing proton conduction to keep the cell electrically neutral.

To date, the perfluorinated sulfonic acid (PFSA) membrane is the most widely applied IEM for VRFBs. However, severe vanadium ion permeation of the PFSA membrane will shorten the life of the cell and cause unsatisfactory cell performance.

A research team led by Prof. Li Huiyun, Prof. Yu Shuhui and Dr. Ye Jiaye from the Shenzhen Institute of Advanced Technology (SIAT) of the Chinese Academy of Sciences has developed a hybrid membrane based on two-dimensional nanohybrid materials, which can improve the performance of VRFBs.

The study was published in Advanced Functional Materials on Nov. 9.

In the newly developed membrane, graphene oxide (GO) nanosheets were embedded in the PFSA matrix to act as a "barrier" to reduce vanadium ion permeation. The tungsten trioxide (WO3) nanoparticles were in-situ grown on the surface of the GO nanosheets to overcome the electrostatic effect and enhance the hydrophilicity and dispersibility of the GO nanosheets.

"These hydrophilic nanoparticles on GO nanosheet surfaces serve as proton to facilitate proton transportation," said Dr. Ye Jiaye, the first author of the study.

The porous polytetrafluoroethylene (PTFE) was sandwiched in the middle of the membrane as a reinforced layer enhancing membrane stability.

Under the synergetic effect of WO3@GO and the PTFE layer, the hybrid membrane exhibited high ion selectivity. The VRFB single cell with the optimized hybrid membrane delivered higher Coulombic efficiency and energy efficiency compared with that of the commercial Nafion membrane.

In their previous study published in Chemical Engineering Journal, this research team developed a sandwich structure composite membrane based on one-dimensional functionalized silicon carbide nanowires.

The researchers introduced functionalized silicon carbide nanowires in a perfluorinated sulfonic acid (PFSA) matrix and sandwiched an ultrathin porous polytetrafluoroethylene layer.

This hybrid not only maintains good proton conductivity but also effectively reduces the penetration of vanadium ions, thus improving the performance of the VRFB cell.

These studies provide a preparation strategy for designing high-performance IEMs for VRFBs based on one-dimensional and two-dimensional modified materials, which can be extended to other fields including water treatment and fuel cells.


Explore further

Scientists make breakthrough in ion-conducting composite membranes

More information: Jiaye Ye et al, In Situ Grown Tungsten Trioxide Nanoparticles on Graphene Oxide Nanosheet to Regulate Ion Selectivity of Membrane for High Performance Vanadium Redox Flow Battery, Advanced Functional Materials (2021). DOI: 10.1002/adfm.202109427
Journal information: Advanced Functional Materials

Citation: Novel ion exchange membrane improves performance of vanadium redox flow batteries (2021, November 11) retrieved 5 December 2021 from https://phys.org/news/2021-11-ion-exchange-membrane-vanadium-redox.html
This document is subject to copyright. Apart from any fair dealing for the purpose of private study or research, no part may be reproduced without the written permission. The content is provided for information purposes only.
45 shares

Feedback to editors