How to have a blast like a black hole

How to have a blast like a black hole
Fig.1: One of the world's largest petawatt laser facility, LFEX, located in the Institute of Laser Engineering at Osaka University. Credit: Osaka University

Researchers from the Institute of Laser Engineering at Osaka University have successfully used short, but extremely powerful laser blasts to generate magnetic field reconnection inside a plasma. This work may lead to a more complete theory of X-ray emission from astronomical objects like black holes.

In addition to being subjected to extreme gravitational forces, matter being devoured by a black hole can be also be pummeled by intense heat and magnetic fields. Plasmas, a fourth state of matter hotter than solids, liquids, or gasses, are made of electrically charged protons and electrons that have too much energy to form neutral atoms. Instead, they bounce frantically in response to magnetic fields. Within a plasma, is a process in which twisted suddenly "snap" and cancel each other, resulting in the rapid conversion of magnetic energy into particle kinetic energy. In stars, including our sun, reconnection is responsible for much of the coronal activity, such as solar flares. Owing to the strong acceleration, the in the black hole's accretion disk emit their own light, usually in the X-ray region of the spectrum.

To better understand the process that gives rise to the observed X-rays coming from , scientists at Osaka University used intense laser pulses to create similarly extreme conditions on the lab. "We were able to study the high-energy acceleration of electrons and protons as the result of relativistic magnetic reconnection," senior author Shinsuke Fujioka says. "For example, the origin of emission from the famous black hole Cygnus X-1, can be better understood."

How to have a blast like a black hole
Fig.2: Magnetic reconnection is generated by the irradiation of the LFEX laser into the micro-coil. The particle outflow accelerated by the magnetic reconnection is evaluated using several detectors. As an example of the results, proton outflows with symmetric distributions were observed. Credit: Osaka University

This level of light intensity is not easily obtained, however. For a brief instant, the laser required two petawatts of power, equivalent to one thousand times the electric consumption of the entire globe. With the LFEX , the team was able to achieve peak magnetic fields with a mind-boggling 2,000 telsas. For comparison, the magnetic fields generated by an MRI machine to produce diagnostic images are typically around 3 teslas, and Earth's is a paltry 0.00005 teslas. The particles of the plasma become accelerated to such an extreme degree that relativistic effects needed to be considered.

How to have a blast like a black hole
Fig.3: The magnetic field generated inside the micro-coil (left), and the magnetic field lines corresponding to magnetic reconnection (right) are shown. The geometry of the field lines changed significantly during (upper) and after (lower) reconnection. The peak value of the magnetic field was measured to be 2,100 T in our experiment. Credit: Osaka University

"Previously, relativistic magnetic could only be studied via numerical simulation on a supercomputer. Now, it is an experimental reality in a laboratory with powerful lasers," first author King Fai Farley Law says. The researchers believe that this project will help elucidate the astrophysical processes that can happen at places in the Universe that contain extreme magnetic fields.

Explore further

Spinning black hole powers jet by magnetic flux

More information: K. F. F. Law et al. Relativistic magnetic reconnection in laser laboratory for testing an emission mechanism of hard-state black hole system, Physical Review E (2020). DOI: 10.1103/PhysRevE.102.033202
Journal information: Physical Review E

Provided by Osaka University
Citation: How to have a blast like a black hole (2020, September 7) retrieved 22 April 2021 from
This document is subject to copyright. Apart from any fair dealing for the purpose of private study or research, no part may be reproduced without the written permission. The content is provided for information purposes only.

Feedback to editors

User comments