A breakthrough of monitoring energy storage at work using optical fibers

July 31, 2018, Changchun Institute of Optics, Fine Mechanics and Physics
Electrochemical surface-plasmon-resonance sensing principle and experimental demonstration with a gold-coated TFBG optical fiber sensor. (a) Experimental setup of a plasmonic fiber-optic sensing system for monitoring the SOC of supercapacitors. (b) Photographs of the configuration for the supercapacitor and (c) gold-coated fiber-optic sensing probe. SEM images of (d) the MnO2 electrode and (e) the corresponding magnified image. (f) Schematic of the measurement of the charge-discharge process of supercapacitors by a plasmonic gold-coated TFBG fiber-optic sensor. Credit: Light: Science & Applicationsvolume 7, Article number: 34 (2018)

A fiber optic sensing system developed by researchers in China and Canada can peer inside supercapacitors and batteries to observe their state of charge.

Renewable energy sources are naturally inconsistent, and thus require new energy technologies. Supercapacitors offer rapid charging and long-term storage, but it is important to be able to monitor their working state. To tackle this issue, a team including Tuan Guo and Wenjie Mai at Jinan University adapted an approach based on an optical fiber-based plasmonic sensor. The sensor is embedded inside the capacitor and is able to measure the state of charge of the electrodes and electrolytes in real time, while operating, and over its lifetime. The sensor demonstrates a clear and repeatable high correlation between measurements of the optical transmission of the fiber device and simultaneous 's state of charge, offering a unique, low-cost method for real-time monitoring of in operation.

This result has been published in Light: Science & Applications (July 11, 2018), with a manuscript title of "In Situ Plasmonic Optical Fiber Detection of the State of Charge of Supercapacitors for Renewable Energy Storage. "

Electrochemical energy storage devices (such as supercapacitors) are considered to be the next generation of energy storage devices with the highest energy storage efficiency and very promising prospects. They are widely used in clean electric power, electric vehicles, mobile medical, portable electronic devices and other fields. In situ and continuous monitoring is a key method for understanding and evaluation of their performance and operation quality. However, the present methods cannot offer the real-time charge state information when the devices are in operation. They are required to take the supercapacitors offline (thus interrupting their function) and carry out electrical measurements, and in some cases, opening up the supercapacitors to examine their components by electron microscopy.

To address this fundamental challenge, Prof. Guo and Prof. Mai and their colleague developed optical fiber devices small enough to be inserted near the surface of the capacitor electrodes. Based on telecommunication-grade fibers, they can be left there and monitored remotely at any time and from any distance. Another important aspect of their approach is that in contrast to current techniques that rely on an indirect estimate of the state of charge from current/voltage tests, the optical fiber devices detect the amount of charge accumulated in a sub-micrometer-sized layer on the electrodes and the adjacent electrolyte directly through its impact on the plasmonic properties of a nanometer-scale gold coating applied to the fiber surface.

Electrochemical surface-plasmon-resonance sensing principle and experimental demonstration with a gold-coated TFBG optical fiber sensor. Sketch of the configuration of a plasmonic optical fiber sensor for in situ monitoring of supercapacitors. Credit: Light: Science & Applicationsvolume 7, Article number: 34 (2018)

It demonstrated a clear and repeatable high correlation between measurements of the optical transmission of the fiber and simultaneous electrical validation measurements. This new technology will have important implications for suppliers who rely on from sun, wind and hydro-electricity for at least part of their power grid requirements. The main implication is that faulty or deteriorating capacitors will be identified before catastrophic failures can occur, and that no interruption of power systems will be required for testing them.

Explore further: As future batteries, hybrid supercapacitors are super-charged

More information: Jiajie Lao et al, In situ plasmonic optical fiber detection of the state of charge of supercapacitors for renewable energy storage, Light: Science & Applications (2018). DOI: 10.1038/s41377-018-0040-y

Related Stories

Paper supercapacitor addresses power/energy density tradeoff

September 27, 2017

By coating ordinary paper with layers of gold nanoparticles and other materials, researchers have fabricated flexible paper supercapacitors that exhibit the best performance of any textile-type supercapacitor to date. In ...

Rapid cellphone charging getting closer to reality

October 25, 2017

The ability to charge cellphones in seconds is one step closer after researchers at the University of Waterloo used nanotechnology to significantly improve energy-storage devices known as supercapacitors.

Chemists invent new supercapacitor materials

June 13, 2016

Dr David Eisenberg and Prof. Gadi Rothenberg of the University of Amsterdam's Van 't Hoff Institute for Molecular Sciences have invented a new type of supercapacitor material with a host of potential applications in electronics, ...

Recommended for you

Trembling aspen leaves could save future Mars rovers

March 18, 2019

Researchers at the University of Warwick have been inspired by the unique movement of trembling aspen leaves, to devise an energy harvesting mechanism that could power weather sensors in hostile environments and could even ...

Quantum sensing method measures minuscule magnetic fields

March 15, 2019

A new way of measuring atomic-scale magnetic fields with great precision, not only up and down but sideways as well, has been developed by researchers at MIT. The new tool could be useful in applications as diverse as mapping ...

Researchers report new light-activated micro pump

March 11, 2019

Even the smallest mechanical pumps have limitations, from the complex microfabrication techniques required to make them to the fact that there are limits on how small they can be. Researchers have announced a potential solution—a ...


Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.