Atomic-scale ping-pong

June 20, 2018, University of Manchester
Helium gas transport through ångström-scale slits. a, Schematic (inset) and TEM micrograph (main panel) of a 2D channel assembled from MoS2 crystals. The channel is seen in black in the main panel; for clarity, its edges are marked with red ticks. The monolayer spacer appears darker with respect to the top and bottom crystals because of different in-plane orientations. The contrast ripples running vertically are a result of the curtaining effect that occurs during ion-beam polishing. b, High-magnification image of the channel in a near its left edge. Each bright horizontal line corresponds to monolayer MoS2. c, Schematic of the experimental devices. The tri-crystal assembly (cyan and yellow) covers an aperture in a silicon nitride membrane (green) prepared on top of a silicon wafer (grey). d, Comparison of helium permeation through 2D channels of the same height (N=5), but with walls made from different crystals (as indicated by the labels). All of the devices here are single-channel, with L=1–6 μm.The (mole) flow rates at room temperature (296 ± 3 K) are normalized per channel length and, for legibility, multiplied by the factors shown. The flow expected for Knudsen diffusion is shown by the solid black line close to the MoS2 data. Inset, our measurement set-up. The arrow indicates the gas flow direction. Credit: (c) Nature (2018). DOI: 10.1038/s41586-018-0203-2

New experiments by researchers at the National Graphene Institute at the University of Manchester have shed more light on the gas flow through tiny, angstrom-sized channels with atomically flat walls.

Published in Nature, this new research shows that the channels allow gas through them at rates that are orders of magnitude faster than expected from theory. This will not only be important for fundamental studies on molecular flows at nanoscale but also for applications such as desalination and filtration.

The reported anomalously-high flow is due to a phenomenon called 'specular surface scattering', which allows a gas to pass through the channel as if it were not there at all.

To understand this effect, imagine a narrow gap between two parallel surfaces. If the surfaces are rough, light shone into the gap is scattered randomly. It would thus take zillions of bounces before the light particles (photons) emerge in random directions.

Now, if these surfaces are mirrors, the light would only need to a few bounces before photons emerge on the other side—as if there were no obstruction at all. The former scenario is what normally happens in a flow of molecules through pipes, and the latter is what was found in this study.

The team were able to obtained their results by studying how helium gas permeates through angstrom-scale slit-like channels with walls made from cleaved crystals of graphite, (hBN) or molybdenum sulphide (MoS2). These materials can all be exfoliated down to a monolayer thickness and provide atomically flat surfaces that are stable at room temperature and pressure.

Such angstrom-scale slits are just a couple of atoms in height and were impossible to fabricate until very recently.

Dr. Radha Boya, who was one of the leaders of the study said: "Our experiments show that surface scattering of helium is highly sensitive to the atomic landscape. For example, helium permeates much more slowly through channels made from MoS2 than through those made from the other two materials. This is because its surface roughness is comparable in height to the size of the helium atoms being transported and their (de Broglie) wavelength."

Professor Sir Andre Geim added: "Although all the used materials are atomically flat, some are flatter than others. Helium atoms are then like tiny ping-pong balls bouncing through a pipe, and depending on whether the pipe surface is bumpy or smooth, the ball comes out of the other end slower or faster."

Graphene is the flattest material of the three. MoS2 on the other hand is so rough for that they bounce back randomly like ping-pong balls from a washboard .

The specular scattering can only be explained by taking into account quantum effects—that is, the wave-like nature of gas molecules. The researchers proved this by comparing gas flows of hydrogen and its heavier isotope deuterium.

They observed that hydrogen flows through the 2-D channels significantly faster than deuterium.

Dr. Ashok Keerthi, the first author of the paper said: "Although the size of both hydrogen and deuterium molecules is the same and they are chemically exactly the same, too, the de Broglie wavelength of hydrogen is larger compared to that of deuterium. And this is all what is needed to change specular reflection off the walls."

The work is expected to have major implications for understanding of nanoscale systems. Much of the current understanding comes from classical Newtonian theory, but the experiments prove that—even under ambient conditions—some nanoscale phenomena intrinsically involve quantum effects and cannot be explained without taking into account that atoms also behave like waves.

The Manchester team are now looking to investigate size-selective separation of gases using even thinner channels, which could provide uses in gas separation technologies.

Explore further: Smallest ever sieve separates atoms

More information: Ballistic molecular transport through two-dimensional channels, Nature (2018). DOI: 10.1038/s41586-018-0203-2 , https://www.nature.com/articles/s41586-018-0203-2

Related Stories

Smallest ever sieve separates atoms

March 20, 2018

Researchers at The University of Manchester have discovered that the naturally occurring gaps between individual layers of two-dimensional materials can be used as a sieve to separate different atoms.

Atomic scale pipes available on demand and by design

September 7, 2016

Materials containing tiny capillaries and cavities are widely used in filtration, separation and many other technologies, without which our modern lifestyle would be impossible. Those materials are usually found by luck or ...

Precise deuteration using heavy water

June 6, 2018

NUS chemists have developed a more effective method using heavy water splitting to swap hydrogen atoms on organic molecules with their heavier cousins (deuterium) for pharmaceutical applications.

Recommended for you

Single-celled architects inspire new nanotechnology

July 16, 2018

Diatoms are tiny, unicellular creatures, inhabiting oceans, lakes, rivers, and soils. Through their respiration, they produce close to a quarter of the oxygen on earth, nearly as much as the world's tropical forests. In addition ...

X-ray triggered nano-bubbles to target cancer

July 16, 2018

Innovative drug filled nano-bubbles, able to be successfully triggered in the body by X-rays, have been developed by researchers, paving the way for a new range of cancer treatments for patients.

Smart window controls light and heat, kills microorganisms

July 13, 2018

A new smart window offers more than just a nice view—it also controls the transmittance of sunlight, heats the interiors of buildings by converting solar radiation into heat, and virtually eliminates E. coli bacteria living ...

1 comment

Adjust slider to filter visible comments by rank

Display comments: newest first

Parsec
not rated yet Jun 21, 2018
A significant differential in transport rate between hydrogen and deuterium could be a real win for creating machines that separate the two isotopes. Current techniques rely on differentials of a few percent or less.

Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.