Self-healing metal oxides could protect against corrosion

April 4, 2018 by David L. Chandler, Massachusetts Institute of Technology
Self-healing metal oxides could protect against corrosion
Credit: Massachusetts Institute of Technology

Researchers have found that a solid oxide protective coating for metals can, when applied in sufficiently thin layers, deform as if it were a liquid, filling any cracks and gaps as they form.

The thin coating should be especially useful to prevent leakage of tiny molecules that can penetrate through most materials, such as hydrogen gas that could be used to power fuel-cell cars, or the radioactive tritium (a heavy form of hydrogen) that forms inside the cores of .

Most metals, with the notable exception of gold, tend to oxidize when exposed to air and water. This reaction, which produces rust on iron, tarnish on silver, and verdigris on copper or brass, can weaken the metal over time and lead to cracks or structural failure. But there are three known elements that produce an that can actually serve as a protective barrier to prevent any further oxidation: , , and silicon dioxide.

Ju Li, a professor of nuclear engineering and science at MIT and senior author of a paper describing the new finding, says "we were trying to understand why oxide and silicon dioxide are special oxides that give excellent corrosion resistance." The paper appears in the journal Nano Letters.

The team, led by MIT graduate student Yang Yang, used highly specialized instruments to observe in detail the surface of metals coated with these "special" oxides to see what happens when they are exposed to an oxygen environment and placed under stress. While most transmission electron microscopes (TEMs) require that samples be studied in a high vacuum, the team used a modified version called an environmental TEM (E-TEM) that allows the sample to be studied in the presence of gases or liquids of interest. The device was used to study the process that can lead to a type of failure known as stress corrosion cracking.

Metals under stress from pressure inside a reactor vessel and exposed to an environment of superheated steam can corrode quickly if not protected. Even with a solid protective layer, cracks can form that allow the oxygen to penetrate to the bare metal surface, where it can then penetrate into interfaces between the metal grains that make up a bulk metal material, causing further corrosion that can penetrate deeper and lead to structural failure. "We want an oxide that is liquid-like and crack-resistant," Yang says.

Researchers have found that a solid oxide protective coating for metals can, when applied in sufficiently thin layers, deform as if it were a liquid, filling any cracks and gaps as they form. Credit: Christine Daniloff/MIT

It turns out that the old standby coating material, aluminum oxide, can have just that liquid-like flowing behavior, even at room temperature, if it is made into a thin enough layer, about 2 to 3 nanometers (billionths of a meter) thick.

"Traditionally, people think that the would be brittle" and subject to cracking, Yang says, explaining that no one had demonstrated otherwise because it is so difficult to observe the material's behavior under realistic conditions. That's where the specialized E-TEM setup at Brookhaven National Laboratory, one of only about 10 such devices in the world, came into play. "No one had ever observed how it deforms at room temperature," Yang says.

"For the first time, we've observed this at nearly atomic resolution," says Li. This approach demonstrated that an aluminum oxide layer, normally so brittle it would shatter under stress, when made exceedingly thin is almost as deformable as a comparably thin layer of aluminum metal—a layer much thinner than aluminum foil. When the aluminum oxide is coated onto a surface of a bulk piece of aluminum, the liquid-like flow "keeps the aluminum covered" with its protective layer, Li reports.

The researchers demonstrated inside the E-TEM that the aluminum with its oxide coating could be stretched to more than double its length without causing any cracks to open up, Li says. The oxide "forms a very uniform conformal layer that protects the surface, with no grain boundaries or cracks," even under the strain of that stretching, he says. Technically, the material is a kind of glass, but it moves like a liquid and fully coats the surface as long as it is thin enough.

"People can't imagine that a metal oxide can be ductile," Yang says, referring to a 's ability to be deformed, such as being stretched out into a thin wire. For example, sapphire is a form of exactly the same material, aluminum oxide, but its bulk crystalline form makes it a very strong but brittle material.

The self-healing coating could have many potential applications, Li says, noting the advantage of its smooth, continuous surface without cracks or grain boundaries that could penetrate into the material.

Explore further: Liquid metal discovery ushers in new wave of chemistry and electronics

More information: Yang Yang et al. Liquid-Like, Self-Healing Aluminum Oxide during Deformation at Room Temperature, Nano Letters (2018). DOI: 10.1021/acs.nanolett.8b00068

Related Stories

Voltage-driven liquid metal fractals

October 30, 2017

Researchers from North Carolina State University have found that gallium indium (EGaIn), a liquid metal with one of the highest surface tensions, can be induced to spread and form patterns called fractals with the application ...

Recommended for you

Covalently modified two-dimensional arsenic

October 15, 2018

The discovery of graphene, a material made of one or very few atomic layers of carbon, started a boom. Today, such two-dimensional materials are no longer limited to carbon and are hot prospects for many applications, especially ...

0 comments

Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.