New graphene-coated “e-fabrics” detect noxious gases

October 13, 2015
The fiber sensor. Credit: ETRI

Scientists in Korea have developed wearable, graphene-coated fabrics that can detect dangerous gases present in the air, alerting the wearer by turning on an LED light.

The researchers, from the Electronics and Telecommunications Research Institute and Konkuk University in the Republic of Korea, coated cotton and polyester yarn with a nanoglue called (BSA). The yarns were then wrapped in graphene oxide sheets.

Graphene is an incredibly strong one-atom-thick layer of carbon, and is known for its excellent conductive properties of heat and electricity. The graphene sheets stuck very well to the nanoglue—so much so that further testing showed the fabrics retained their electrical conducting properties after 1,000 consecutive cycles of bending and straightening and ten washing tests with various chemical detergents. Finally, the graphene oxide yarns were exposed to a chemical reduction process, which involves the gaining of electrons.

The reduced-graphene-oxide-coated materials were found to be particularly sensitive to detecting nitrogen dioxide, a pollutant gas commonly found in vehicle exhaust that also results from . Prolonged exposure to nitrogen dioxide can be dangerous to human health, causing many respiratory-related illnesses. Exposure of these specially-treated fabrics to nitrogen dioxide led to a change in the electrical resistance of the reduced graphene oxide.

The fabrics were so sensitive that 30 minutes of exposure to 0.25 parts per million of nitrogen dioxide (just under five times above the acceptable standard set by the U.S. Environmental Protection Agency) elicited a response. The fabrics were three times as sensitive to in air compared to another reduced sensor previously prepared on a flat material.

Dr Hyung-Kun Lee is measuring the fiber sensor. Credit: ETRI

The new technology, according to the researchers, can be immediately adopted in related industries because the coating process is a simple one, making it suitable for mass production. It would allow outdoor wearers to receive relevant information about air quality. The materials could also be incorporated with air-purifying filters to act as "smart filters" that can both detect and filter harmful gas from air.

"This sensor can bring a significant change to our daily life since it was developed with flexible and widely used fibers, unlike the gas sensors invariably developed with the existing solid substrates," says Dr. Hyung-Kun Lee, who led this research initiative. The study was published on June 4 in the online edition of Scientific Reports, a journal from the publishers of Nature.

Dr Hyung-Kun Lee is pointing the graph to monitor the experimental result. Credit: ETRI

Explore further: Successful boron-doping of graphene nanoribbon

More information: Yong Ju Yun et al. "Ultrasensitive and Highly Selective Graphene-Based Single Yarn for Use in Wearable Gas Sensor," Scientific Reports (2015). DOI: 10.1038/srep10904

Related Stories

Successful boron-doping of graphene nanoribbon

August 27, 2015

Physicists at the University of Basel succeed in synthesizing boron-doped graphene nanoribbons and characterizing their structural, electronic and chemical properties. The modified material could potentially be used as a ...

Scientists produce graphene using microorganisms

March 22, 2012

The Graphene Research Group at Toyohashi University of Technology (Japan) reports on the synthesis of graphene by reducing graphene oxide using microorganisms extracted from a local river.

Gas sensors sound the smoldering fire alarm

September 2, 2015

Smoke detectors are everywhere, but still thousands of people die in fires annually. Fire gas detectors, which detect carbon monoxide and nitrogen oxide, identify fires at an early stage. Thanks to a new measurement principle ...

Recommended for you

Graphene photodetector enhanced by fractal golden 'snowflake'

January 16, 2017

(Phys.org)—Researchers have found that a snowflake-like fractal design, in which the same pattern repeats at smaller and smaller scales, can increase graphene's inherently low optical absorption. The results lead to graphene ...

Nanoscale view of energy storage

January 16, 2017

In a lab 18 feet below the Engineering Quad of Stanford University, researchers in the Dionne lab camped out with one of the most advanced microscopes in the world to capture an unimaginably small reaction.

Scientists create first 2-D electride

January 11, 2017

(Phys.org)—Researchers have brought electrides into the nanoregime by synthesizing the first 2D electride material. Electrides are ionic compounds, which are made of negative and positive ions. But in electrides, the negative ...

0 comments

Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.