New way to store solar energy could lead to more common solar cell usage

September 15, 2015 by Peter Ehrhard
A working cell from Switzer’s research, with gas evolution. Credit: Sam O’Keefe, Missouri S&T.

Researchers at Missouri University of Science and Technology have developed a relatively inexpensive and simple way to split water into hydrogen and oxygen through a new electrodeposition method. The method produces highly efficient solar cells that can gather solar energy for use as fuel.

The research, sponsored by the U.S. Department of Energy, could lead to a sizable increase in the amount of available for .

The Missouri S&T researchers describe their full method in a paper published today on the website of the journal Nature Materials.

"The work helps to solve the problem that solar energy is intermittent," says Dr. Jay A. Switzer, the Donald L. Castleman/Foundation for Chemical Research Professor of Discovery at Missouri S&T. "Obviously, we cannot have the sun produce energy on one spot the entire day, but our process converts the energy into a form that is more easily stored."

Switzer and his team use wafers to absorb solar energy. The silicon is submerged in , with the front surface exposed to a simulator and the back surface covered in electrodes to conduct the energy. The silicon has cobalt nano-islands formed onto it using a process called electrodeposition.

Unlike current research standards that cover the surface of the silicon entirely in a catalyst layer, Switzer has small clusters of cobalt catalysts dotted on the silicon's surface. This process was found to be just as protective and produced much higher voltages.

The generated voltage from the solar rays splits liquid water into hydrogen and . Oxygen evolves at the cobalt-coated silicon electrode, and hydrogen evolves at the platinum counter electrode.

"Initially, we had set out to produce a uniform layer of metal that both catalyzed and protected the silicon, but found that this method actually produces a higher voltage and did not need an additional step that typically has to be applied to the silicon," says Switzer. "These nano-islands of cobalt produce a much more efficient cell."

Besides solar arrays and energy cells, Switzer sees potential usage of the results in large-scale hydrogen collection and even a fully carbon-neutral travel solution.

"If we use this process in hydrogen-fueled vehicles, the hydrogen would be used as fuel and the only thing dripping out of the tailpipe of the car would be water," says Switzer.

Explore further: Discovery of a highly efficient catalyst eases way to hydrogen economy

More information: "An electrodeposited inhomogeneous metal–insulator–semiconductor junction for efficient photoelectrochemical water oxidation." Nature Materials (2015) DOI: 10.1038/nmat4408

Related Stories

Nanowires give 'solar fuel cell' efficiency a tenfold boost

July 17, 2015

A solar cell that produces fuel rather than electricity. Researchers at Eindhoven University of Technology (TU/e) and FOM Foundation today present a very promising prototype of this in the journal Nature Communications. The ...

Cost-effective catalyst converts CO2 into natural gas

September 2, 2015

A discovery made in Leiden helps not only to make natural gas from CO2 but also to store renewable energy. Research by Professor Marc Koper and PhD student Jing Shen shows how this process can be implemented in a cost-effective ...

Recommended for you

Molecular beacon signals low oxygen with ultrasound

December 8, 2017

Areas of hypoxia, or low oxygen in tissue, are hallmarks of fast-growing cancers and of blockages or narrowing in blood vessels, such as stroke or peripheral artery disease. University of Illinois researchers have developed ...

Targeting cancer cells by measuring electric currents

December 8, 2017

EPFL researchers have used electrochemical imaging to take a step forward in mapping the distribution of biomolecules in tissue. This technology, which uses only endogenous markers – rather than contrast agents – could ...

Studying gas mask filters so people can breathe easier

December 8, 2017

In research that could lead to better gas mask filters, scientists at the Department of Energy's Lawrence Berkeley National Laboratory (Berkeley Lab) have been putting the X-ray spotlight on composite materials in respirators ...

4 comments

Adjust slider to filter visible comments by rank

Display comments: newest first

Sonhouse
1 / 5 (2) Sep 15, 2015
It doesn't say anything about the efficiency of the process. It needs to be at least 15% efficient to be economically viable.
gkam
1 / 5 (5) Sep 15, 2015
There are uses for such technology even at higher prices.
Whydening Gyre
3.7 / 5 (3) Sep 15, 2015
It doesn't say anything about the efficiency of the process. It needs to be at least 15% efficient to be economically viable.

See another new article about an efficiency of 14%.
Almost there...
EyeNStein
not rated yet Sep 16, 2015
So they've taken a hermetically sealed solar cell with a 25 year life.
Removed the protection, covered it in water and created an electrically driven corrosion generator. I'd give it maybe six months lifetime, as described in this article?

Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.