Hybrid nanowires eyed for computers, flexible displays

March 10, 2015 by Emil Venere
This illustration depicts a copper nanowire coated with graphene - an ultrathin layer of carbon - which lowers resistance and heating, suggesting potential applications in computer chips and flexible displays. Credit: Purdue University graphic

A new process for coating copper nanowires with graphene - an ultrathin layer of carbon – lowers resistance and heating, suggesting potential applications in computer chips and flexible displays.

"Highly conductive copper nanowires are essential for efficient data transfer and heat conduction in many applications like high-performance and transparent displays," said Ruchit Mehta, working with Zhihong Chen, an associate professor of electrical and computer engineering at Purdue University.

Now, researchers have developed a technique for encapsulating the wires with graphene and have shown that the hybrid wires are capable of 15 percent faster data transmission while lowering peak temperature by 27 percent compared with uncoated copper nanowires.

"This is compelling evidence for improved speed and thermal management by adapting the copper-graphene hybrid technology in future silicon chips and flexible electronic applications," he said.

Findings are detailed in a research paper published online in February in the journal Nano Letters. The paper was authored by Mehta, doctoral student Sunny Chugh and Chen.

Researchers and industry are trying to create smaller wires to increase the "packing density" of electronic components in chips. However, while smaller wires are needed to increase performance and capacity, scaling down the size of the wires reduces electrical and , which can lead to overheating and damage. The graphene coating prevents the from oxidizing, preserving low resistance and reducing the amount of heating.

"If the surface is covered with oxide then a lot of the electrical and thermal conductive properties of copper are lost," Mehta said. "This is very important because you want as much current as possible going through these wires to increase speed, but they cannot take too much current because they will melt. But if the copper has good electrical and thermal conductivity you can push more current through it."

The hybrid wires are promising for transparent and because they could be used in sparse numbers, maintaining transparency, and they are bendable.

"Copper wires usually aren't good for these displays because they eventually oxidize and stop working," Mehta said. "If you can prevent the oxidation, they potentially become a good fit."

Until now it has been difficult to coat copper nanowires with because the process requires at temperatures of about 1,000 degrees Celsius, which degrades copper thin films and small-dimension wires. The researchers have developed a new process that can be performed at about 650 degrees Celsius, preserving the small wires intact, using a procedure called plasma-enhanced chemical vapor deposition. Wires were tested in two width sizes: 180 nanometers - or more than 500 times thinner than a human hair - and 280 nanometers.

Explore further: Researchers combine graphene and copper in hopes of shrinking electronics

More information: Enhanced Electrical and Thermal Conduction in Graphene-Encapsulated Copper Nanowires, Nano Letters, 2015.

Related Stories

Copper shines as flexible conductor

August 22, 2014

Bend them, stretch them, twist them, fold them: modern materials that are light, flexible and highly conductive have extraordinary technological potential, whether as artificial skin or electronic paper.

New nanomaterial introduced into electrical machines

October 2, 2014

Lappeenranta University of Technology in Finland has constructed the world's first prototype electrical motor using carbon nanotube yarn in the motor windings. The new technology may significantly enhance the performance.

Recommended for you

Atomic blasting creates new devices to measure nanoparticles

December 14, 2017

Like sandblasting at the nanometer scale, focused beams of ions ablate hard materials to form intricate three-dimensional patterns. The beams can create tiny features in the lateral dimensions—length and width, but to create ...

Engineers create plants that glow

December 13, 2017

Imagine that instead of switching on a lamp when it gets dark, you could read by the light of a glowing plant on your desk.

Faster, more accurate cancer detection using nanoparticles

December 12, 2017

Using light-emitting nanoparticles, Rutgers University-New Brunswick scientists have invented a highly effective method to detect tiny tumors and track their spread, potentially leading to earlier cancer detection and more ...

0 comments

Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.