A novel solar CPV/CSP hybrid system proposed

February 11, 2015, Science China Press

In concentrating photovoltaic (CPV) systems only a small part of the incident solar energy can be converted into electricity and the majority of the incident energy is dissipated as waste heat. Although the waste heat could be utilized in conventional CPV/thermal systems, the applications are seriously limited due to the low temperature accompanying the waste heat.

Professor Xu Chao and his group from North China Electric Power University (NCEPU) present a novel CPV/concentrating solar power (CSP) hybrid system. The dissipated heat is used to produce superheated vapor of refrigerant which is effective to generate power through an organic Rankine cycle (ORC), and thus the solar-to-electricity efficiency of the system can be significantly improved. This work was published in Science Bulletin 2015 No.4 issue.

Recently CPV has achieved worldwide attentions due to the features of more cost-effective and more efficient in energy harvesting than PV with no concentrators. However, redundant low grade heat is accompanying the CPV systems, because on one hand the majority of the incident solar energy is converted into heat, and on the other hand the temperatures of solar cell modules have to be restricted to a proper range (usually less than 100 C). To make full utilization of the massive dissipated heat, CPV/thermal (CPV/T) hybrid systems were developed in the past decades. However, the dissipated heat is usually used to heat a coolant to a higher temperature for space heating, absorptive cooling and so on in conventional CPV/T systems. The applications of the CPV/T systems are actually seriously limited due to the possible mismatch between the demand for power and heat and the required complicated energy management system. On the other hand, only the core region of the energy flux density generated by the concentrators with high and relatively uniform local concentration ratios is suitable for CPV modules, and the peripheral radiation with low concentration ratios is usually discarded.

To make better use of both the dissipated heat from and the peripheral low-concentration radiation, Professor Chao Xu and his colleagues proposed a novel CPV/CSP hybrid system, which is mainly composed of CPV modules and its evaporative cooling subsystem on the back side, a solar thermal receiver surrounding the CPV module, and the equipments forming an ORC. The solar cells facing the core region of the concentrated radiation generate electricity directly, and the refrigerant becomes saturated vapor after absorbing the dissipated heat from solar cells. Then the saturated vapor is fed into the receiver tubes, and after being heated by the peripheral solar radiation it becomes superheated vapor which is used to generate power through the ORC. As thus the hybrid system has a combined electricity generation, which could avoid the problem that market of conventional CPV/T is limited because of the combined and power (CHP) generation. Professor Chao Xu et al. also established a steady-state physical model for the hybrid system and carried out the energy analysis. The results show that the useful peripheral low-concentration radiation that can be used to get a high-temperature superheated vapor could be rather considerable, and the overall solar-to-electricity efficiency can be significantly improved by the hybrid system. For example, the overall efficiency can be increased from 28.4% for the conventional CPV system to as high as 44% for the hybrid system with 500 suns. Therefore, the proposed CPV/CSP provides a viable way for high-efficient solar power generation.

Explore further: High efficiency concentrating solar cells move to the rooftop (w/ Video)

More information: Xue Han, Chao Xu, Xing Ju, Xiaoze Du, Yongping Yang. Energy analysis of a hybrid solar concentrating photovoltaic/concentrating solar power (CPV/CSP) system. Science Bulletin, 2015, 60(4): 460-469. link.springer.com/article/10.1 … %2Fs11434-015-0738-7

Related Stories

How to make solar energy systems more widespread

January 14, 2015

Retrofitting existing buildings with adequate cutting-edge technologies is thought to guarantees spectacular energy savings, by about 50%. The objective of the EU funded project BRICKER is precisely to demonstrate such possibility. ...

UQ solar array reaches milestone

April 7, 2011

The University of Queensland's $7.75 million solar power system at St Lucia in Brisbane has reached a milestone, with installation completed on one of the project's most visible components.

World record solar cell with 44.7% efficiency

September 24, 2013

German Fraunhofer Institute for Solar Energy Systems, Soitec, CEA-Leti and the Helmholtz Center Berlin announced today that they have achieved a new world record for the conversion of sunlight into electricity using a new ...

Solar power does not have a long shelf life

August 1, 2011

Storing power is complicated and expensive, but very often, especially far away from the regular power grids, there is no way around large batteries for grid-independent electricity consumers. It would make more sense to ...

Yale engineer to build 'hot' solar cells

September 22, 2014

Associate professor of electrical engineering Minjoo Larry Lee has been awarded $2,540,000 to develop dual-junction solar cells that can operate efficiently at extreme temperatures above 750 degrees Fahrenheit. In addition ...

Recommended for you

Nanoscale Lamb wave-driven motors in nonliquid environments

March 19, 2019

Light driven movement is challenging in nonliquid environments as micro-sized objects can experience strong dry adhesion to contact surfaces and resist movement. In a recent study, Jinsheng Lu and co-workers at the College ...

OSIRIS-REx reveals asteroid Bennu has big surprises

March 19, 2019

A NASA spacecraft that will return a sample of a near-Earth asteroid named Bennu to Earth in 2023 made the first-ever close-up observations of particle plumes erupting from an asteroid's surface. Bennu also revealed itself ...

The powerful meteor that no one saw (except satellites)

March 19, 2019

At precisely 11:48 am on December 18, 2018, a large space rock heading straight for Earth at a speed of 19 miles per second exploded into a vast ball of fire as it entered the atmosphere, 15.9 miles above the Bering Sea.


Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.