NREL demonstrates 45.7% efficiency for concentrator solar cell

NREL demonstrates 45.7% efficiency for concentrator solar cell

The Energy Department's National Renewable Energy Laboratory has announced the demonstration of a 45.7 percent conversion efficiency for a four-junction solar cell at 234 suns concentration. This achievement represents one of the highest photovoltaic research cell efficiencies achieved across all types of solar cells.

NREL's new solar cell, which is designed for operation in a concentrator photovoltaic (CPV) system where it can receive more than 1,000 suns of concentrated sunlight, greatly improves earlier designs by incorporating an additional high quality absorber layer to achieve an ultra-.

Multijunction harvest sunlight by dividing the solar spectrum into portions that are absorbed by a material with a bandgap tuned to a specific wavelength range. Combining materials with optimal bandgaps is critical for high efficiency. The challenge is to maintain the high quality of the materials while integrating them into a complex cell capable of efficient photoconversion.

"The distinction of this multijunction device is the very high quality of the lattice-mismatched subcells," said NREL Scientist Ryan France, designer of the solar cell. "Lattice-mismatched materials require the introduction of defects, called dislocations, into the device, which can drastically hinder device performance. NREL has learned to control and confine these dislocations to inactive regions of the device, allowing even highly mismatched material to be used in a multijunction cell."

NREL invented and developed the advanced four-junction inverted metamorphic (4J IMM) cell with these challenges in mind. The new design consists of a gallium indium phosphide (GaInP) junction, a gallium arsenide junction, and two gallium indium arsenide junctions that are lattice-mismatched to the substrate. The cell's peak efficiency of 45.7 ± 2.3 percent was measured under the AM1.5 direct spectrum at 234 suns concentration, but the device performs nearly as well at even higher concentrations, having 45.2 percent efficiency at 700 suns concentration.

The device has numerous other improvements over previous designs, including a broadband four-layer anti-reflection coating, a novel metamorphic tunnel junction interconnect, and unprecedented performance from the GaInP top cell. Compared to standard GaInP subcells, this subcell has both higher voltage and reduced series resistance, which is essential for high efficiency at high solar concentrations.

The cell measurements lab at NREL validated the efficiency. Notably, the measurements at high concentration were taken with a new flash simulator-a Tunable High Intensity Pulsed Solar Simulator (T-HIPSS)-that more accurately controls the spectrum of the concentrated light. This tool ensures that each junction of the device receives an amount of light representative of the solar spectrum, and greatly reduces the error of measurement. The cell is being sent to an external accredited laboratory for further testing and confirmation.

This body of work is supported by the Energy Department's SunShot Initiative, which is a national effort to make solar energy cost-competitive with traditional energy sources by the end of the decade. Through SunShot, the Energy Department supports private companies, universities, and national laboratories working to drive down the cost of solar electricity to $0.06 per kilowatt-hour. Learn more at

Explore further

NREL reports world record 31.1 percent efficiency for III-V solar cell

Citation: NREL demonstrates 45.7% efficiency for concentrator solar cell (2014, December 17) retrieved 22 July 2019 from
This document is subject to copyright. Apart from any fair dealing for the purpose of private study or research, no part may be reproduced without the written permission. The content is provided for information purposes only.

Feedback to editors

User comments

Dec 17, 2014
cool but i read a lot of rare minerals in the construct....

Dec 17, 2014
cool but i read a lot of rare minerals in the construct....

Sure. This is a lab prototype to get bets possible efficience after all (so no restriction on what metrials they use).
On the other hand it's a concentrator cell (i.e. you only need to cover 0.5% of the area you'd have to cover with coventional solar cells while the rest is just cheap mirrors). That can offset the hefty pricetag by quite a bit.

Dec 17, 2014
cool but i read a lot of rare minerals in the construct....

Yeah, I have the same concerns too. The goal of getting energy costs down to an ultra-competitive rate (e.g.: DoE's $.06/kWh objective) is really what is needed to get solar to supplant a lot of oil/coal energy, but dependence on REMs greats other concerns with mining, manufacturing, and life-cycle costs -not to mention greater dependence on countries with these deposits. Still, I'm really excited about the extremely high efficiency they're demonstrating.

Dec 17, 2014
It isn't that farfetched from commercial application actually. In fact, Soitec which will be undertaking a 150 megawatt CPV solar project in San Diego is about to commercialize a similar 4-junction solar cell next year, with about 46% efficiency (just about the same as the NREL)!

Please sign in to add a comment. Registration is free, and takes less than a minute. Read more