Peering into the interfaces of nanoscale polymeric materials

January 9, 2012
Schematic configuration of the marker XPCS experiments. The use of resonance enhanced X-ray scattering for XPCS enables one to intensify, by more than one order of magnitude, the probing electrical field in the regions of interest within single nanometer polymer films.

( -- The development of polymer nanostructures and nanoscale devices for a wide variety of applications could emerge from new information about the interplay between nanoscale interfaces in polymeric materials, thanks to research carried out at the U.S. Department of Energy Office of Science’s Advanced Photon Source (APS) at Argonne National Laboratory.

It is well known that the physical and mechanical properties of polymeric materials confined at the nanoscale differ substantially from the bulk, the so-called “nanoconfinement” effect. Polymeric materials comprise a compound or mixture of compounds formed by polymerization and consisting essentially of repeating structural units, prepared on impenetrable solid substrates. There is now growing evidence that the air/ interface and polymer/substrate interface play crucial roles in such nanoconfinement effects: At the air/polymer interface, there exists a surface mobile layer which enhances the chain dynamics, while an immobile adsorbed layer formed onto solid substrates without specific interactions of a polymer (such as π-π stacking or hydrogen bonds) reduces the dynamics. Although most previous work has revealed the deviations of “average” quantities of entire nanometer films from the bulk, it is expected that the local quantities within the film would be different from the average ones, depending on the interplay between these interfaces. It was this unanswered question – both theoretically and experimentally- that motivated the present study.

In order to understand to what extent these interfacial effects propagate into the film interior and to determine the rheological property of polymeric materials as a function of the distance from the interfaces, researchers from Stony Brook University and Argonne utilized the X-ray Science Division beamline 8-ID at the APS to apply x-ray photon correlation spectroscopy (XPCS) to polystyrene (PS) films with an embedded system of gold nanoparticles that act as markers. With this novel technique, the researchers found that the random drifting (the Brownian motion) of the markers adequately tracked the local viscosity, which controls the flow and the mechanical properties of , governed by chain entanglements. In addition, the use of the two illuminating modes with different incident angles for XPCS enabled them to explore in-situ the marker dynamics at the topmost surface and the near-center region of the film independently.

As a result, they discovered that the viscosity of the topmost surface (~ 10 nm depth) in PS films (~100 nm in thickness) is about 30% lower than that at the center of the film. Moreover, XPCS results conclude the long-standing debate as to whether at the topmost surface are entangled or not. The polymer chains at the air/polymer interface are still entangled and the corresponding dynamics are governed by the reptation mechanism, which describes the “snake-like” large-scale motion of entangled polymer chains, as in the bulk.

This work also reports the emergence of the heterogeneous viscosity distributions within single-layer polymer thin films in thermal equilibrium. The researchers found that while the polymer/air interface is more mobile due to its reduced viscosity, the long-range perturbations (~60-nm in thickness in this case), which are associated with the very thin immobile adsorbed layer (~ 7-nm in thickness), result in an exponential-like increase in the local viscosity with decreasing distance from the substrate interface.

Thus, the present findings shed new light on the interplay between these interfaces on the local rheological property, facilitating the development of new polymer and to be used in a wide variety of fields.

Explore further: Lighting the Way to Better Nanoscale Films

More information: Reduced Viscosity of the Free Surface in Entangled Polymer Melt Films (T. Koga, C. Li, M. K. Endoh, J. Koo, M. Rafailovich, S. Narayanan, D. R. Lee, L. B. Lurio, S. K. Sinha), Phys. Rev. Lett., 104 (2010) 066101.

See: T. Koga, N. Jiang, P. Gin, M. K. Endoh, S. Narayanan, L. B. Lurio, and S. K. Sinha, “Impact of an Irreversibly Adsorbed Layer on Local Viscosity of Nanoconfined Polymer Melts,” Phys. Rev. Lett. 107, 225901 (25 November 2011). DOI:10.1103/PhysRevLett.107.225901

Related Stories

Lighting the Way to Better Nanoscale Films

August 30, 2004

Most miniature electronic, optical and micromechanical devices are made from expensive semiconductor or ceramic materials. For some applications like diagnostic lab-on-a-chip devices, thin-film polymers may provide a cheaper ...

Making light work of artificial muscles

January 21, 2011

A new form of self-assembling polymer film that bends and stretches when hit by light is pointing the way to a new family of functional materials. This flexing film is the first material to have been made by coaxing complex ...

Thinnest nanofiltration membrane to date

July 7, 2011

A recent collaboration between researchers at the University of Chicago and the University of Illinois at Chicago with the Center for Nanoscale Material's Electronic & Magnetic Materials & Devices Group at the Argonne National ...

New theory may shed light on dynamics of large-polymer liquids

August 23, 2011

A new physics-based theory could give researchers a deeper understanding of the unusual, slow dynamics of liquids composed of large polymers. This advance provides a better picture of how polymer molecules respond under fast-flow, ...

Recommended for you

The microscopic origin of efficiency droop in LEDs

November 21, 2017

Light-emitting diodes—or LEDs, as they are commonly known—have been slowly replacing incandescent light bulbs in applications ranging from car taillights to indicators on electronics since their invention in the 1960s.

Borophene shines alone as 2-D plasmonic material

November 20, 2017

An atom-thick film of boron could be the first pure two-dimensional material able to emit visible and near-infrared light by activating its plasmons, according to Rice University scientists.


Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.