Harnessing the potential of quantum tunneling: Transistors without semiconductors

June 21st, 2013 in Nanotechnology / Nanophysics
Electrons flash across a series of gold quantum dots deposited on a boron nitride nanotubes. Scientists at Michigan Technological University made the quantum-tunneling device, which behaves like a transistor at room temperature, without using any semiconducting materials. Credit: Yoke Khin Yap


Electrons flash across a series of gold quantum dots deposited on a boron nitride nanotubes. Scientists at Michigan Technological University made the quantum-tunneling device, which behaves like a transistor at room temperature, without using any semiconducting materials. Credit: Yoke Khin Yap

(Phys.org) —For decades, electronic devices have been getting smaller, and smaller, and smaller. It's now possible—even routine—to place millions of transistors on a single silicon chip.

But transistors based on semiconductors can only get so small. "At the rate the current technology is progressing, in 10 or 20 years, they won't be able to get any smaller," said physicist Yoke Khin Yap of Michigan Technological University. "Also, semiconductors have another disadvantage: they waste a lot of energy in the form of heat."

Scientists have experimented with different materials and designs for transistors to address these issues, always using semiconductors like silicon. Back in 2007, Yap wanted to try something different that might open the door to a new age of electronics.

"The idea was to make a transistor using a nanoscale insulator with nanoscale metals on top," he said. "In principle, you could get a piece of plastic and spread a handful of metal powders on top to make the devices, if you do it right. But we were trying to create it in nanoscale, so we chose a nanoscale insulator, nanotubes, or BNNTs for the substrate."

Yap's team had figured out how to make virtual carpets of BNNTs, which happen to be insulators and thus highly resistant to . Using lasers, the team then placed quantum dots (QDs) of gold as small as three across on the tops of the BNNTs, forming QDs-BNNTs. BNNTs are ideal substrates for these quantum dots due to their small, controllable, and uniform diameters, as well as their insulating nature. BNNTs confine the size of the dots that can be deposited.

In collaboration with scientists at Oak Ridge National Laboratory (ORNL), they fired up electrodes on both ends of the QDs-BNNTs at room temperature, and something interesting happened. Electrons jumped very precisely from gold dot to gold dot, a phenomenon known as quantum tunneling.

"Imagine that the nanotubes are a river, with an on each bank. Now imagine some very tiny stepping stones across the river," said Yap. "The electrons hopped between the gold stepping stones. The stones are so small, you can only get one electron on the stone at a time. Every electron is passing the same way, so the device is always stable."

Yap's team had made a transistor without a semiconductor. When sufficient voltage was applied, it switched to a conducting state. When the voltage was low or turned off, it reverted to its natural state as an .

Furthermore, there was no "leakage": no electrons from the gold dots escaped into the insulating BNNTs, thus keeping the tunneling channel cool. In contrast, silicon is subject to leakage, which wastes energy in and generates a lot of heat.

Other people have made transistors that exploit quantum tunneling, says Michigan Tech physicist John Jaszczak, who has developed the theoretical framework for Yap's experimental research. However, those tunneling devices have only worked in conditions that would discourage the typical cellphone user.

"They only operate at liquid-helium temperatures," said Jaszczak.

The secret to Yap's gold-and-nanotube device is its submicroscopic size: one micron long and about 20 nanometers wide. "The gold islands have to be on the order of nanometers across to control the electrons at room temperature," Jaszczak said. "If they are too big, too many electrons can flow." In this case, smaller is truly better: "Working with and gets you to the scale you want for electronic devices."

"Theoretically, these tunneling channels can be miniaturized into virtually zero dimension when the distance between electrodes is reduced to a small fraction of a micron," said Yap.

Yap has filed for a full international patent on the technology.

More information: Their work is described in the article "Room Temperature Tunneling Behavior of Boron Nitride Nanotubes Functionalized with Gold Quantum Dots," published online on June 17 in Advanced Materials: onlinelibrary.wiley.com/doi/10… a.201301339/abstract

Provided by Michigan Technological University

"Harnessing the potential of quantum tunneling: Transistors without semiconductors." June 21st, 2013. http://phys.org/news/2013-06-harnessing-potential-quantum-tunneling-transistors.html