J-2X test series proves part integrityMay 16, 2011 By Jennifer Stanfield in Astronomy & Space / Space Exploration
Engineers at NASA's Marshall Space Flight Center gave a key component of the J-2X engine a brisk workout to ensure it can withstand its extreme operating environment. The engine's fuel turbopump first stage nozzle passed the test, performing even better than expected.
The J-2X is a highly efficient and versatile upper stage rocket engine that can stop and restart in space to support a variety of mission requirements. Full-scale testing begins later this summer but before then, engineers examined the longevity and durability of the engine's fuel turbopump first stage nozzle. The nozzle directs hot gas flow onto the turbine blades.
The entire engine operates at extremes, but the fuel turbopump's first stage nozzle really takes a beating. Drastic thermal changes, being super chilled and then immediately super heated, stresses the metal nozzle causing it to rapidly expand and contract which eventually causes it to crack. During engine operations, this turbine nozzle is exposed to cryogenic hydrogen at -422 degrees Fahrenheit and less than two seconds after the start sequence it is hit with hot gases at 1000 degrees Fahrenheit.
Apollo-era rocket scientists studied this same issue on the original J-2 engine. After a battery of tests, Apollo engineers discovered the fuel turbopump first stage nozzle cracked after dozens of starts and stops. While the part cracked, additional tests proved the engine performance and safety were not compromised.
Modeling and simulation for the J-2X suggested the same issue would emerge, so designers selected a new type of nickel metal alloy for the turbopump nozzle which is less brittle and was predicted to hold up better under extreme temperature fluctuations.
"We did a lot of design and analysis work on this issue to show required part life before we finalized design," said Gary Genge, J-2X turbomachinery manager at NASA's Marshall Space Flight Center in Huntsville, Ala. "We looked at making dramatic design alterations but changing the geometry of the part would have had a downstream effect we wanted to avoid. Also, the historic data hinted that wiith the improved material and minor changes, the new design might be acceptable."
In total, 43 tests were conducted which simulated the actual engine start and shutdown environment. Non-destructive evaluations were performed at the beginning of every test day and no detrimental condition was ever found.
"By taxing the same part over and over and carefully inspecting frequently, we know with confidence the part is very durable," said Genge. "This knowledge will save time and money in the long run because we can't inspect this area on the actual J-2X engines without disassembling the engine. This thorough test series shows we should be safe throughout the planned test series and we now have a better understanding of its longevity and structural integrity."
Assembly of J-2X Engine 10001, the first engine off the production line, is in full swing at NASA's Stennis Space Center. Full-scale engine testing will begin in June.
The J-2X is designed and built by Pratt & Whitney Rocketdyne of Canoga Park, Calif., for NASA's Marshall Space Flight Center in Huntsville, Ala.
Provided by JPL/NASA
"J-2X test series proves part integrity" May 16, 2011 http://phys.org/news/2011-05-j-2x-series.html