Physicists describe strange new fluid-like state of matter

Dec 05, 2005
Physicists describe strange new fluid-like state of matter

University of Chicago physicists have created a novel state of matter using nothing more than a container of loosely packed sand and a falling marble. They have found that the impacting marble produces a jet of sand grains that briefly behaves like a special type of dense fluid.

Image: Comparison of granular jets at atmospheric pressure and in a vacuum. A-C show images from a high-speed video of a granular jet produced by the impact of a heavy sphere at atmospheric pressure. D-F show images form a high-speed video of the jet at reduced pressure. Air compressed between the sand grains provides most of the energy that drives the jet, according to scientists at the University of Chicago. Images courtesy of Heinrich Jaeger, University of Chicago

"We're discovering a new type of fluid state that seems to exist in this combination of gas--air in this case--and a dense arrangement of particles," said Heinrich Jaeger, Professor in Physics and Director of the Materials Research Science and Engineering Center at the University of Chicago. "It's just a most amazing phenomenon."

Jaeger's team describes the surprising phenomenon in the December issue of the journal Nature Physics. The team consists of graduate students John Royer and Eric Corwin; 2003 University of Chicago physics graduate Andrew Flior; visiting physics graduate student Maria-Luisa Cordero from the Universidad de Chile; Peter Eng, a Senior Research Associate at the University's James Franck Institute; and Mark Rivers, Associate Director of the University's Consortium for Advanced Radiation Sources.

Scientists typically have produced new states of matter at ultra-cold temperatures, those nearing absolute zero (minus 497.6 degrees Fahrenheit). In this case, granular materials take on unusual characteristics at room temperature. "The jet acts like an ultra-cold, ultra-dense gas, not in terms of ambient temperature, but in terms of how we define temperature via the random motion of particles. Inside the jet there is very, very little random motion," Jaeger said.

The jetting phenomenon was first reported in 2001 by Sigurdur Thoroddsen and Amy Shen, who were then at the University of Illinois at Urbana-Champaign. Studying the way the characteristics of granular materials changes from solid to fluid has long been a research theme at Chicago's Center for Materials Research. Thoroddsen and Shen's work led Jaeger to suggest that Floir reproduce the experiment as the subject of his undergraduate honors thesis.

Meanwhile, a group led by Detlef Lohse at the University of Twente in the Netherlands used high-speed video and computer simulations to infer how the jet was caused by gravity as material rushed in to fill the void left behind by the impacting object.

But to actually demonstrate the underlying cause of the jet's formation, the Chicago team needed very fast, non-invasive tracking of the interior of the sand. To this end, the Chicago scientists used high-speed X-ray radiography. Taken at 5,000 frames per second, the X-ray images were the fastest ever taken at Argonne National Laboratory's Advanced Photon Source, which produces the most brilliant X-ray beams for research in the Western Hemisphere.

The experiments, conducted at both atmospheric pressure and in a vacuum, showed that air compressed between the sand grains provides most of the energy that drives the jet. The University of Twente's Lohse said he regards the work of Jaeger's team as "very important."

"The result is totally unexpected," Lohse. "One would think that the effect of air would weaken the jet, but what is the case is just the opposite."

Systematically reducing the pressure, Jaeger's team observed that the jet, in fact, consisted of two stages. Air pressure exerted little influence on the jet's initial stage, a thin stream of particles that breaks up into droplets. But air pressure played a key role in forming the jet's second stage, characterized by a thick column of particles with ripples on its surface.

"One of the biggest questions that we have still not solved is why this jet is so sharply delineated. Why are there these beautiful boundaries? Why isn't this whole thing just falling apart," Jaeger asked.

Jaeger's team needed advanced scientific equipment and support from the National Science Foundation and the U.S. Department of Energy to conduct this study. To observe the basic effect, however, "You can do this experiment at home," he said. Take a cup of powdered sugar and pour it into another container to ensure that it is loosely packed. Then, drop a marble into the cup. "Once you drop that marble in there, you see that jet emerging, but you have to look fast."

Source: University of Chicago

Explore further: Yellowstone's thermal springs—their colors unveiled

add to favorites email to friend print save as pdf

Related Stories

How can we search for life on icy moons such as Europa?

Nov 24, 2014

Our solar system is host to a wealth of icy worlds that may have water beneath the surface. The Cassini spacecraft recently uncovered evidence of a possible ocean under the surface of Saturn's moon, Mimas.

Testing turbines to save energy

Nov 18, 2014

They say a little knowledge is a dangerous thing. But a little knowledge can also be comforting. For anyone who has sat on a jet airplane at takeoff, tense and sweaty-palmed, wondering how in the world this ...

Recommended for you

Yellowstone's thermal springs—their colors unveiled

Dec 19, 2014

Researchers at Montana State University and Brandenburg University of Applied Sciences in Germany have created a simple mathematical model based on optical measurements that explains the stunning colors of ...

User comments : 0

Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.