New way to monitor faults may help predict earthquakes

Oct 01, 2009

Scientists at the Carnegie Institution have found a way to monitor the strength of geologic faults deep in the Earth. This finding could prove to be a boon for earthquake prediction by pinpointing those faults that are likely to fail and produce earthquakes. Until now, scientists had no method for detecting changes in fault strength, which is not measureable at the Earth's surface.

Paul Silver and Taka'aki Taira of the Carnegie Institution's Department of Terrestrial Magnetism, with Fenglin Niu of Rice University and Robert Nadeau of the University of California, Berkeley, used highly sensitive seismometers to detect subtle changes in earthquake waves that travel through the San Andreas Fault zone near Parkfield, California, over a period of 20 years. The changes in the waves indicate weakening of the fault and correspond to periods of increased rates of small earthquakes along the fault.

"Fault strength is a fundamental property of seismic zones," says Taira, now at the University of California, Berkeley. "Earthquakes are caused when a fault fails, either because of the build-up of stress or because of a weakening of the fault. Changes in fault strength are much harder to measure than changes in stress, especially for faults deep in the crust. Our result opens up exciting possibilities for monitoring seismic risk and understanding the causes of earthquakes."

The section of the near Parkfield, sometimes called the "Earthquake Capital of the World," has been intensively studied by seismologists and is home to a sophisticated array of borehole seismometers called the High-Resolution Seismic Network and other geophysical instruments. Because the area experiences numerous repeated small earthquakes, it is a natural laboratory for studying the physics of earthquakes.

Seismograms from small earthquakes revealed that within the fault zone there were areas of fluid-filled fractures. What caught the researchers' attention was that these areas shifted slightly from time to time. The repeating earthquakes also became smaller and more frequent during these intervals - an indication of a weakened fault.

"Movement of the fluid in these fractures lubricates the fault zone and thereby weakens the fault," says Niu. "The total displacement of the fluids is only about 10 meters at a depth of about three kilometers, so it takes very sensitive seismometers to detect the changes, such as we have at Parkfield."

What caused the fluids to shift? Intriguingly, the researchers noticed that on two occasions the shifts came after the fault zone was disturbed by seismic waves from large, distant earthquakes, such as the 2004 Sumatra-Andaman Earthquake. Pressure from these waves may have been enough to cause the fluids to flow. "So it is possible that the strength of faults and risk is affected by seismic events on the other side of the world," says Niu.

More information: The paper is published in the October 1 edition of Nature.

Source: Carnegie Institution

Explore further: Distant planets provide a glimpse of the future of Earth's oceans

add to favorites email to friend print save as pdf

Related Stories

Why do earthquakes stop?

Feb 06, 2008

The underlying structure of a fault determines whether an earthquake rupture will jump from one fault to another, magnifying its size and potential devastation. Understanding why some earthquakes terminate along a fault, ...

Recommended for you

NASA image: Fires in the southern United States

5 hours ago

In this image taken by the Aqua satellite of the southern United States actively burning areas as detected by MODIS's thermal bands are outlined in red. Each red hot spot is an area where the thermal detectors ...

Software models ocean currents for oil and gas search

6 hours ago

A study involving the use of streamline visualisation has found the technology can help guide electromagnetic transmitter and receiver placements, thereby aiding the search for oil and gas on the seafloor.

User comments : 0