A New Path of Conduction for Future Electronics

Jul 22, 2009 by Calla Cofield
Schematic representing trajectories of electrons "dancing" along the edges of a device. Red arrows correspond to electrons with "spin up"; blue, "spin down." An electron injected from one leg of the "H" can end up in the other without bumping into other electrons or defects in the bulk of the material, and hence without any resistance, by traveling unimpeded along the edge. (Image courtesy Shou-Cheng Zhang.)

(PhysOrg.com) -- Last month, researchers from SLAC National Accelerator Laboratory made headlines when they revealed experimental evidence of a topological insulator: a material that could revolutionize computer processors by allowing electricity to flow without resistance. This week in Science, SLAC theorists along with an experimental group in Germany report additional details about the way these topological insulators conduct electricity. Using the topological insulator mercury telluride, the paper shows that an electric current sent through these materials goes against conventional physics knowledge and travels far away from its input points, to the outer edges of the material.

"This is another manifestation of this new state of matter, which is totally different than anything we're familiar with," said co-author Shou-Cheng Zhang of the Stanford Institute for Materials and Energy Science at SLAC. The current generation of microprocessors dissipate a lot of energy as heat, Zhang said, as result of . "It's one of the greatest obstacles facing the information age today. The current experiment proves that there is a possible motion of the electrons that does not dissipate energy in the traditional way."

Imagine moving through a crowded ballroom trying to make your way from one end to the other while dancing couples fill the space. You keep bumping into other dancers, losing your energy and your patience along the way. Similarly, as electric currents pass through conductors, they bump into other electrons and lose their energy. But in topological insulators the electrons exhibit a spin-orbit coupling, as if they were traveling and spinning smoothly in the same direction as all the other dancers, preventing collisions and loss of energy. Last month Zhang and colleagues demonstrated this behavior in bismuth telluride. The new results show that the electrons also take a unique path through the "ballroom." They move around the edge of the topological insulator, even if that means moving far away from the input and output points of the current. In contrast, the current in a regular conductor will take the shortest route possible between those two points.

Zhang and SLAC physicists and Xiao-Liang Qi and Joseph Maciejko predicted this bizarre behavior theoretically, earlier this year. Experimentalists at the Physikalisches Institut and Röntgen Center for Complex Material Systems at the Universität Würzburg in Würzburg, Germany tested the theories in the lab—and their results matched the predictions exactly.

The researchers achieved the new results by shining light on telluride to observe its properties. The German research team sent a current through the material, which provided more precise information and more closely modeled the way these topological insulators will be used in future applications.

Since the first theoretical prediction made by Zhang's group, the field of topological insulators has been roaring forward and research papers on the subject are appearing in the journals Science and Nature every few weeks. To make these the materials ready for applications, Zhang said, engineering researchers must test them for compatibility with current computer technology then confirm that material will operate at room temperature. Maciejko added, "The step toward initial implementation is not that large."

More information: Science paper: www.sciencemag.org/cgi/content/full/325/5938/294

Provided by SLAC National Accelerator Laboratory (news : web)

Explore further: 'Squid skin' metamaterials project yields vivid color display

add to favorites email to friend print save as pdf

Related Stories

New exotic material could revolutionize electronics

Jun 15, 2009

Move over, silicon -- it may be time to give the Valley a new name. Physicists at the Department of Energy's (DOE) SLAC National Accelerator Laboratory and Stanford University have confirmed the existence ...

Super-efficient Transistor Material Predicted

May 15, 2009

(PhysOrg.com) -- New work by condensed-matter theorists at the Stanford Institute for Materials and Energy Science at SLAC National Accelerator Laboratory points to a material that could one day be used to ...

Making magnetic monopoles, and other exotica, in the lab

Feb 05, 2009

Physicist Shou-Cheng Zhang has proposed a way to physically realize the magnetic monopole. In a paper published online in the January 29 issue of Science Express, Zhang and post-doctoral collaborator Xiao-Liang ...

It's all in the spin: Quantum physics cools down computers

Sep 25, 2007

The future of Moore's famous law—that the number of transistors squeezed onto a computer chip can be doubled about every two years—is widely seen as threatened by the damaging heat generated by the chips themselves as ...

Researchers predict a new state of matter in semiconductors

Dec 14, 2006

Conventional matter exists in three familiar forms-solid, liquid and gas. But under special circumstances, quantum theory predicts exotic states of matter, such as superconductors in which electrons flow with no resistance ...

Recommended for you

Mechanical behavior of twinned aluminum revealed

Sep 15, 2014

A research group has discovered plasticity and work-hardening behaviors in twinned aluminum with incoherent twin boundaries by using in situ nanoindentation technique. The group's paper titled "In situ nanoindentation ...

Invisibility cloaks closer thanks to 'digital metamaterials'

Sep 15, 2014

The concept of "digital metamaterials" – a simple way of designing metamaterials with bizarre optical properties that could hasten the development of devices such as invisibility cloaks and superlenses – is reported in a paper published today in Nature ...

User comments : 8

Adjust slider to filter visible comments by rank

Display comments: newest first

earls
not rated yet Jul 22, 2009
How does this effect compare and contrast with superconductors? The "ballroom" analogy I've read before.

A breakthrough of this caliber is just the tip of the iceberg.
winthrom
not rated yet Jul 22, 2009
If this can carry current then transmission lines can be more effective
poi
not rated yet Jul 23, 2009
"The step toward initial implementation is not that large."

if they were asking for funding, they'd be denied if they said this.
so time table pleeaase...
Riverbill
not rated yet Jul 24, 2009
It was my understanding that electrons travel fastest on the outer regons of a conducter, not through the center of the ballroom? How does this efect EMFRadiation? Losses may increase in power transmission.
earls
not rated yet Jul 24, 2009
Birger
not rated yet Jul 27, 2009
If such a component could be given a near-fractal surface, would it be able to carry useful amounts of current on a scale where it could replace copper for electricity power networks?
Slotin
1 / 5 (1) Jul 28, 2009
How does this effect compare and contrast with superconductors?
Bismuth telluride isn't superconductor - instead of it, in its pure state it behaves like perfect insulator. Just the surface of crystals remains conductive and it exhibits a classical, but relativelly high metallic conductivity.
To understand this behavior we should learn a bit about electron structure of bismuth telluride. Due the relative size of Bi and Te ions and low concentration of conductive electrons, movable electrons are confined ("locked") by their repulsive forces to sparse hexagonal mesh (so called Wigner crystal), surrounding Bi2Te3 atoms in crystal lattice. With compare to metals, where movable electrons can occupy a continuous space around atoms ("electron sea"), Bi2Te material remains nonconductive in its monocrystalline pure state.
http://www.aether...ide3.gif
http://www.aether...tor1.gif
Just at the surface of crystals, where repulsive forces of individual electrons aren't compensated from outside the free electrons remains movable, so that surface of material can serve as a 2D conductor. Bi2Te3 exhibits many other interesting properties, for example we can met with it in Peltier cells, serving for cooling of processors.
Slotin
1 / 5 (1) Jul 28, 2009
We can model this behavior partially, if we penetrate hydrophobic porous material by fluid of high surface tension (like water) under pressure. Because fluid remains confined to free spaces between particles, the fluid (i.e. electrons) cannot flow through bulk of porous material. Only at the free surface of porous material the repulsive capillary forces aren't compensated, so that fluid can form a continuous layer and to remain movable and conductive.

The model of porous surface covered by fluid is quite effective model in explanation of electron analogies of solid phase and we can even use it for explanation of semiconductor junction.

http://aetherwave...ors.html