Goodbye to batteries and power sockets

Jun 03, 2008
Goodbye to batteries and power sockets
The demonstrator – a miniature conveyer system driven by compressed air – contains wireless sensors that provide their own power supply. © Festo

A broken cable or a soiled connector? If a machine in a factory goes on strike, it could be for any of a thousand reasons. Self-sufficient sensors that provide their own power supply will soon make these machines more robust.

When a factory machine breaks down, it’s hard to know what to do. Production often comes to a standstill until the error has finally been pinpointed – and that can take hours. The causes are legion; in many cases it is all due to a single interrupted contact.

Consequently, many manufacturers have long been hoping for a technology that will work without vulnerable power and data cables. The idea is basically feasible, using small devices that harvest energy from their surroundings and provide their own power supply rather like a solar calculator. Experts speak of energy self-sufficient sensor-actuator systems.

These high-tech components normally consist of a sensor, a processor and a radio module. They measure position, force or temperature and transmit the data instantaneously by radio. In this way, vital machine data reach the control center without using cables at all. Is the machine overheating? Is the drive shaft wearing out?

So far, however, there are hardly any off-the-shelf solutions with their own energy supply. Research scientists from the Fraunhofer Technology Development Group TEG in Stuttgart have now joined forces with industrial partners and universities in the EnAS project, sponsored by the Federal Ministry of Economics and Technology, to build a transportable demonstrator.

This is a miniature conveyer system driven by compressed air that transports small components in an endless cycle. The round workpieces are picked up by a vacuum gripper, transported a short way and set down on a small carrier, which conveys the parts back to the starting point. All steps of the process are monitored by sensors as usual.

The special feature of the demonstrator is that the sensing elements have no need of an external power supply. The machine uses photo diodes, for instance, to check whether the carrier has been correctly loaded – if so, the light from the diodes is obscured by the workpieces. Solar cells supply the energy for this workpiece detector. Another example are pressure sensors which monitor the work of the vacuum gripper. In this case, the power is supplied by piezoelectric flexural transducers.

The piezoelectric elements contain ceramics that generate electricity on being deformed. This deformation happens when the vacuum pump is switched on and off. The electricity thus generated is sufficient to send an OK signal to the central control unit. The sensor thus draws its power from pressurized air that is present anyway. Within the next two years, the various system components are expected to make their way into everyday industrial use.

Source: Fraunhofer-Gesellschaft

Explore further: Detecting human life with remote technology

Related Stories

WSJ: Google exploring new day for battery tech

Apr 13, 2015

When The Wall Street Journal turned out a story recently about how Google was exploring improved battery technology, technology watchers thought Google was not a minute too soon; in fact it was about time b ...

Reliable systems for recharging electric vehicles

Apr 01, 2015

The success of electric vehicle networks depends on economical vehicles – and efficient power grids. Existing power lines were not designed for the loads generated by electric vehicles. Fraunhofer researchers ...

Recommended for you

Making LED-illuminated advertisements light and flexible

6 hours ago

VTT is involved in a European project, developing novel LED advertising displays, which combine thin, lightweight and bendable structures with advanced optical quality. The project will implement, for example, a LED display ...

Detecting human life with remote technology

8 hours ago

Flinders engineering students Laith Al-Shimaysawee and Ali Al-Dabbagh have developed ground-breaking new technology for detecting human life using remote cameras.

Team develops faster, higher quality 3-D camera

Apr 24, 2015

When Microsoft released the Kinect for Xbox in November 2010, it transformed the video game industry. The most inexpensive 3-D camera to date, the Kinect bypassed the need for joysticks and controllers by ...

Researchers finding applications for tough spinel ceramic

Apr 24, 2015

Imagine a glass window that's tough like armor, a camera lens that doesn't get scratched in a sand storm, or a smart phone that doesn't break when dropped. Except it's not glass, it's a special ceramic called ...

User comments : 0

Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.