High-quality mono-silicon crystal grown at low cost for solar cells

January 14, 2016
High-quality mono-silicon crystal grown at low cost for solar cells
Figure: Characteristics of the newly developed single-seed cast method. Credit: National Institute for Materials Science

A joint research team in Japan has developed a "single-seed cast method," a new casting method making it possible to grow high-quality mono silicon at low cost. New casting method may facilitate the return of a market-competitive solar cell industry.

A research team led by Takashi Sekiguchi, a leader of the Nano Device Characterization Group, Nano-Electronic Materials Unit, International Center for Materials Nanoarchitectonics (MANA), National Institute for Materials Science (NIMS), Japan, and Koichi Kakimoto, a professor at the Research Institute for Applied Mechanics, Kyushu University, Japan, has developed a new method to grow high-quality mono silicon at low cost.

The research resulted in the invention of a new casting method called a single-seed cast method. It dramatically improved the quality of crystals created compared to conventional casting methods, which potentially leads to the development of more efficient .

As the current conversion efficiency of mainstream silicon-type has already reached 20%, it is required in future development to increase conversion efficiency even more to add higher value to the cell products. However, this goal is not achievable using conventionally cast polycrystalline silicon. In addition, there is demand for the development of a new silicon material to replace polycrystalline silicon and single-crystal silicon for semiconductors, because dislocation-free single crystal silicon for semiconductors is not adequately competitive pricewise.

To address this issue, the research team developed a single-seed cast method, a new silicon casting method using a seed crystal, and succeeded in growing a high-quality single-crystal silicon (mono silicon) ingot with low impurity. In the new casting method, silicon is melted in a crucible, and a single crystal is grown from a small seed crystal. This method is less expensive than the method to create single crystal silicon for semiconductors due to reduced raw material use and manufacturing costs. Moreover, the conversion efficiency of a solar cell prototype created using the crystal grown by this method was as high as 18.7%. This efficiency was very close to the efficiency of dislocation-free single-crystal silicon (Czochralski (Cz) silicon) wafers for semiconductors (18.9%), which were evaluated concurrently. In future studies, the of mono silicon may exceed that of Cz by further reducing crystal defects and the impact of impurities.

It is also feasible to grow an ingot as large as a 50-cm cube using the current facility. As such, the facility is compatible with and can be integrated into the existing production line. In the future, it may be possible to make the solar cell industry market competitive again by transferring this new technology and other technologies derived from it to solar cell manufacturers in Japan.

This research was conducted as a part of the NEDO project titled "Development of next-generation high-performance technology for photovoltaic power generation system." This study has been published in the 9-20-2015 issue (Vol. 242) of Solid State Phenomena, and presented at the FY2015 NEDO new energy research report meeting on October 28.

Explore further: Scientists fabricate hexagonal silicon, potentially leading to light-emitting semiconductors

More information: Takashi Sekiguchi et al. 50 cm Size Seed Cast Si Ingot Growth and its Characterization, Solid State Phenomena (2015). DOI: 10.4028/www.scientific.net/SSP.242.30

Related Stories

New efficiency record set with dual-junction solar cell

January 6, 2016

Scientists at the Energy Department's National Renewable Energy Laboratory (NREL) and at the Swiss Center for Electronics and Microtechnology (CSEM) have jointly set a new world record for converting non-concentrated (1-sun) ...

Low-cost wafers for solar cells

October 1, 2015

Silicon wafers are the heart of solar cells. However, manufacturing them is not cheap. Over 50 percent of the pure silicon used is machined into dust. A new manufacturing technique developed by Fraunhofer researchers puts ...

New plastic solar cell minimizes loss of photon energy

December 2, 2015

As the world increasingly looks to alternative sources of energy, inexpensive and environmentally friendly polymer-based solar cells have attracted significant attention, but they still do not match the power harvest of their ...

Recommended for you

Electron highway inside crystal

December 8, 2016

Physicists of the University of Würzburg have made an astonishing discovery in a specific type of topological insulators. The effect is due to the structure of the materials used. The researchers have now published their ...

Researchers improve qubit lifetime for quantum computers

December 8, 2016

An international team of scientists has succeeded in making further improvements to the lifetime of superconducting quantum circuits. An important prerequisite for the realization of high-performance quantum computers is ...

A nano-roundabout for light

December 8, 2016

Just like in normal road traffic, crossings are indispensable in optical signal processing. In order to avoid collisions, a clear traffic rule is required. A new method has now been developed at TU Wien to provide such a ...

0 comments

Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.