New catalyst could cut cost of making hydrogen fuel

July 2, 2013 by David Tenenbaum

( —A discovery at the University of Wisconsin-Madison may represent a significant advance in the quest to create a "hydrogen economy" that would use this abundant element to store and transfer energy.

Theoretically, hydrogen is the ultimate non-carbon, non-polluting fuel for storing intermittent energy from the wind or sun. When burned for energy, hydrogen produces water but no carbon dioxide. Practically speaking, producing hydrogen from water, and then storing and using the gas, have proven difficult.

The new study, now published online at the Journal of the American Chemical Society, introduces a new structure that can facilitate the use of electricity to produce from water.

Significantly, the catalyst avoids the rare, expensive metal platinum that is normally required for this reaction. (Catalysts speed up without themselves being consumed.)

The material under study, , contains two common elements, notes Mark Lukowski, a Ph.D. student working with associate professor Song Jin in the UW-Madison chemistry department. "Most people have tried to reduce the cost of the catalyst by making small particles that use less platinum, but here we got rid of the platinum altogether and still got reasonably high performance."

The research group has produced milligram quantities of the catalyst, "but in principle you could scale this up," says Lukowski. "Molybdenum disulfide is a commercially available product. To control purity and structure, we go through the trouble of synthesizing it from the bottom up, but you could buy it today."

To make the new material, Lukowski and Jin deposit of molybdenum disulfide on a disk of graphite and then apply a lithium treatment to create a different structure with different properties.

Just as carbon can form diamond for jewelry and graphite for writing, molybdenum disulfide can be a semiconductor or a metallic phase, depending on structure. When the compound is grown on the graphite, it is a semiconductor, but it becomes metallic after the lithium treatment. Lukowski and Jin discovered that the metallic phase has far greater catalytic properties.

"Like graphite, which is made up of a stack of sheets that easily separate, molybdenum disulfide is made up of individual sheets that can come apart, and previous studies have shown that the catalytically active sites are located along the edges of the sheets," says Lukowski.

"The both causes the semiconducting-to-metallic phase change and separates the sheets, creating more edges. We have taken away the limitation from molybdenum disulfide and made the active sites both more pervasive and more reactive."

The experiment, supported by the U.S. Department of Energy's Basic Energy Sciences program, is a proof of concept for a new approach for improving these catalysts, says Jin.

"Even though the efficiency of has been greatly improved, it is still not as good as what platinum can achieve," he says. "The next steps include finding ways to further improve the performance by optimizing all aspects of the process and exploring related compounds. There are many hurdles to achieving a , but the advantages in efficiency and pollution reduction are so significant that we must push ahead."

As technological advances put further strain on the supply of platinum and other rare elements, using common elements is a major advantage, Jin stresses. "The elements we use are cheap and abundant in earth's crust, and the raw material is already commercially available at low cost. Building on this discovery and new understanding, we would like to further improve these materials to achieve the efficient production of hydrogen without using precious metals."

Explore further: Hydrogen from acidic water: Researchers develop potential low cost alternative to platinum for splitting water

Related Stories

Nanoparticle opens the door to clean-energy alternatives

June 13, 2013

( —Cheaper clean-energy technologies could be made possible thanks to a new discovery. Research team members led by Raymond Schaak, a professor of chemistry at Penn State University, have found that an important ...

Recommended for you

New polymer creates safer fuels

October 1, 2015

Before embarking on a transcontinental journey, jet airplanes fill up with tens of thousands of gallons of fuel. In the event of a crash, such large quantities of fuel increase the severity of an explosion upon impact. Researchers ...

Researchers print inside gels to create unique shapes

September 30, 2015

(—A team of researchers at the University of Florida has taken the technique of printing objects inside of a gel a step further by using a highly shear-rate sensitive gel. In their paper published in the journal ...

How a molecular motor untangles protein

October 1, 2015

A marvelous molecular motor that untangles protein in bacteria may sound interesting, yet perhaps not so important. Until you consider the hallmarks of several neurodegenerative diseases—Huntington's disease has tangled ...

Anti-aging treatment for smart windows

October 1, 2015

Electrochromic windows, so-called 'smart windows', share a well-known problem with rechargeable batteries – their limited lifespan. Researchers at Uppsala University have now worked out an entirely new way to rejuvenate ...

1 comment

Adjust slider to filter visible comments by rank

Display comments: newest first

1 / 5 (2) Jul 02, 2013
At present, how much better are platinum catalysts than this material?

Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.