Charge your mobile phone with formic acid?

May 27, 2013 by Ingrid Söderbergh

(Phys.org) —Surprisingly the answer is yes. With the technology of today it is possible to use environmental friendly formic acid in fuel cell powering your mobile phone or laptop. Physicist Florian Nitze, Umeå University, has in his thesis developed new catalysts to improve the capacity of these fuel cells.

Fuel cells are different from batteries in that they require a constant source of fuel and oxygen to run. The technology is already commercially available but formic acid fuel cells still suffer from low power and lifetime.

The effect of a catalyst is to reduce the and to increase the rate of the chemical reactions, which leads to a higher efficiency in the fuel cell.

In his thesis, Florian Nitze has developed new catalysts based on a combination of and nanotechnology – engineering close to the atom level.

"Especially catalysts of palladium-nanoparticles attached to a unique helical formed carbon nanofibre proved to have a long lifetime and a very high potential to be used in formic acid fuel cells. The helical formed carbon nanofibre has a and a surface that is very easy to decorate with nanoparticles, "says Florian Nitze.

Several of the new catalysts that Florian Nitze have developed are based on palladium. It is a noble metal such as gold or platinum, but it is half as expensive.

Formic acid can be produced from , i.e. wood, and is therefore a highly environmentally friendly alternative.

"One of the major advantages over Li-ion batteries, which are dominating the , is that the charging only takes seconds by simple refueling with formic acid," says Florian Nitze.

Florian Nitze comes originally from Baden-Baden in Germany.

The working principle of a fuel cell:

If for example hydrogen and oxygen (but equally valid for and oxygen) get in contact, they can burn and release a lot of energy. In this process hydrogen gives electrons to oxygen, it is oxidized whereas oxygen takes electrons from hydrogen, it is reduced.

The concept of a fuel cells is now to separate these two reaction spatially into two separate reactions, namely oxidation and reduction. The energy that would be released by burning can now be used as electric power if the two separated reactions are connected electrically. However, not all energy can be used; some energy is needed to keep the reaction running. Catalysts can lower this energy loss and speed up the reactions resulting in a higher efficiency of the .

Explore further: Putting a fuel cell 'in your pocket'

More information: Read the entire or parts of the thesis at: urn.kb.se/resolve?urn=urn:nbn:se:umu:diva-68852

Related Stories

Putting a fuel cell 'in your pocket'

April 15, 2011

(PhysOrg.com) -- Technology using catalysts which make hydrogen from formic acid could eventually replace lithium batteries and power a host of mobile devices.

Researchers develop superior fuel cell material

August 24, 2012

Using a mixture of gold, copper and platinum nanoparticles, IBN researchers have developed a more powerful and longer lasting fuel cell material. This breakthrough was published recently in leading journal, Energy and Environmental ...

As fuel cells evolve, a role emerges for palladium

March 18, 2013

(Phys.org) —Researchers at Yale University have taken another step toward the development of low-temperature, lower-cost alkaline fuel cells, which are battery-like devices that convert oxygen and hydrogen into electricity ...

New method for producing clean hydrogen

May 21, 2013

Duke University engineers have developed a novel method for producing clean hydrogen, which could prove essential to weaning society off of fossil fuels and their environmental implications.

Recommended for you

Findings illuminate animal evolution in protein function

July 27, 2015

Virginia Commonwealth University and University of Richmond researchers recently teamed up to explore the inner workings of cells and shed light on the 400–600 million years of evolution between humans and early animals ...

New polymer able to store energy at higher temperatures

July 30, 2015

(Phys.org)—A team of researchers at the Pennsylvania State University has created a new polymer that is able to store energy at higher temperatures than conventional polymers without breaking down. In their paper published ...

How to look for a few good catalysts

July 30, 2015

Two key physical phenomena take place at the surfaces of materials: catalysis and wetting. A catalyst enhances the rate of chemical reactions; wetting refers to how liquids spread across a surface.

Yarn from slaughterhouse waste

July 29, 2015

ETH researchers have developed a yarn from ordinary gelatine that has good qualities similar to those of merino wool fibers. Now they are working on making the yarn even more water resistant.

1 comment

Adjust slider to filter visible comments by rank

Display comments: newest first

JRi
not rated yet May 27, 2013
Friendly maybe in larger scale, but it is damn corrosive, in case your formic acid bottle happens to leak.

Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.