Towards miniaturization of metamaterials: Reluctant electrons enable 'extraordinarily strong' negative refraction

Aug 01, 2012
This is the chamber of the probe station where Donhee Ham's research group tests the new metamaterials. Credit: Photo by Eliza Grinnell, Harvard SEAS Communications

Researchers at the Harvard School of Engineering and Applied Sciences have demonstrated a drastically new way of achieving negative refraction in a metamaterial. The advance, reported in the Aug. 2 issue of Nature, results in an "extraordinarily strong" negative refractive index as large as -700, more than a hundred times larger than most previously reported.

In a vacuum, light travels so fast that it would circle the Earth more than seven times within the blink of an eye. When light propagates through matter, however, it slows by a factor typically less than 5. This factor, called the refractive index, is positive in naturally occurring materials, and it causes light to bend in a particular direction when it shines on, for example, water or glass.

Over the past two decades, scientists have managed to create whose refractive indices are negative; these negative-index defy normal experience by in the "wrong" direction. Due to their unusual ability to manipulate and their potential to be harnessed for technology (that might, for example, cloak objects from view), negative-index metamaterials have been celebrated by scientists and engineers alike.

Researchers at the Harvard School of Engineering and Applied Sciences (SEAS), collaborating with the Weizmann Institute of Science in Israel, have now demonstrated a drastically new way of achieving negative in a metamaterial.

The advance, reported in the August 2 issue of Nature, results in an "extraordinarily strong" as large as -700, more than a hundred times larger than most previously reported.

"This work may bring the science and technology of negative refraction into an astoundingly miniaturized scale, confining the negatively refracting light into an area that is 10,000 times smaller than many previous negative-index metamaterials," says principal investigator Donhee Ham, Gordon McKay Professor of Electrical Engineering and Applied Physics at SEAS.

The underlying physics of previous work in this field has often involved an entity called magnetic inductance. Ham's research group instead explored kinetic inductance, which is the manifestation of the acceleration of electrons subjected to electric fields, according to Newton's second law of motion.

The experimental setup in Donhee Ham's lab shown here is used to test the new metamaterials, which are fabricated on tiny chips. The metamaterials themselves are inside the probing chamber at the bottom right. Imaged through the black microscope, they appear on the screen at the top of this image. Photo by Eliza Grinnell, Harvard SEAS Communications

At its heart, the researchers' change in strategy from using magnetic inductance to kinetic inductance stems from a simple shift in ideas.

"Magnetic inductance represents the tendency of the electromagnetic world to resist change according to Faraday's law," explains Ham. "Kinetic inductance, on the other hand, represents the reluctance to change in the mechanical world, according to Newton's law."

"When electrons are confined perfectly into two dimensions, kinetic inductance becomes much larger than magnetic inductance, and it is this very large two-dimensional kinetic inductance that is responsible for the very strong negative refraction we achieve," explains lead author Hosang Yoon, a graduate student at SEAS. "The dimensionality profoundly affects the condensed-matter electron behaviors, and one of those is the kinetic inductance."

To obtain the large kinetic inductance, Ham and Yoon's work employs a two-dimensional electron gas (2DEG), which forms at the interface of two semiconductors, gallium arsenide and aluminum gallium arsenide. The very "clean" 2DEG sample used in this work was fabricated by coauthor Vladimir Umansky, of the Weizmann Institute.

Ham's team effectively sliced a sheet of 2DEG into an array of strips and used gigahertz-frequency electromagnetic waves (microwaves) to accelerate electrons in the leftmost few strips. The resulting movements of electrons in these strips were "felt" by the neighboring strips to the right, where electrons are consequently accelerated.

In this way, the proof-of-concept device propagates an effective wave to the right, in a direction perpendicular to the strips, each of which acts as a kinetic inductor due to the electrons' acceleration therein. This effective wave proved to exhibit what the researchers call a "staggering" degree of .

The primary advantages of the new technology are its ability to localize electromagnetic waves into ultra-subwavelength scales and its dramatically reduced size. This concept demonstrated with microwaves, if extended to other regions of the electromagnetic spectrum, may prove important for operating terahertz and photonic circuits far below their usual diffraction limit, and at near field. It may also one day lead to extremely powerful microscopes and optical tweezers, which are used to trap and study minuscule particles like viruses and individual molecules.

For now, the device operates at temperatures below 20 degrees Kelvin. The researchers note, however, that a similar result can be achieved at room temperature using terahertz waves, which Ham's team is already investigating, with the carbon structure graphene as an alternative two-dimensional conductor.

"While electrons in graphene behave like massless particles, they still possess kinetic energy and can exhibit very large kinetic inductance in a non-Newtonian way," says Ham.

Explore further: Theorists find a new way to improve efficiency of solar cells by overcoming exciton 'traps'

Related Stories

Bending light the 'wrong' way

Aug 18, 2011

(PhysOrg.com) -- Scientists have tried this with sophisticated meta-materials, but at the Vienna University of Technology (TU Vienna) it has now been done with simple metals; materials with a negative refractive ...

Multilayer ceramic coils with the highest inductance

Aug 26, 2011

TDK-EPC, a group company of TDK Corporation, presents the TDK MLG0603S series of multilayer ceramic coils with the world’s highest inductance values. These 0603 inductors feature an inductance of up to ...

TDK intros ultra high-Q multilayer inductors

Apr 06, 2012

TDK Corporation presented the new MHQ1005P series of multilayer ceramic inductors with a Q factor that, depending on the type, is as good or much better than comparable, but more expensive, wirewound inductors. ...

Practical Cloaking Devices On The Horizon?

Aug 10, 2008

(PhysOrg.com) -- Invisibility cloaks get a step closer to realization, with the demonstration of a new material that can bend (visible) light the 'wrong' way for the first time in three dimensions.

Beyond the looking glass...

Aug 13, 2009

While the researchers can't promise delivery to a parallel universe or a school for wizards, books like Pullman's Dark Materials and JK Rowling's Harry Potter are steps closer to reality now that researchers ...

Recommended for you

New complex oxides could advance memory devices

Sep 17, 2014

The quest for the ultimate memory device for computing may have just taken an encouraging step forward. Researchers at The City College of New York led by chemist Stephen O'Brien have discovered new complex ...

User comments : 4

Adjust slider to filter visible comments by rank

Display comments: newest first

Sonhouse
not rated yet Aug 01, 2012
It sounds like this device would be a powered device, not a passive element like normal metamaterials or say, glass lenses. Requiring an energy input to operate. It maybe would end up being powered by a laser when the engineering details are worked out. Perhaps it could be coupled to an electret material which has a permanent electric field.
Jeddy_Mctedder
3.8 / 5 (4) Aug 01, 2012
this is a big deal. someones winning the nobel for this within a decade.
panorama
not rated yet Aug 01, 2012
P.P. Layouts is born.
antialias_physorg
not rated yet Aug 02, 2012
It sounds like this device would be a powered device,

Sounds like the makings of a photonic transistor to me.